Seasonal tune-up and full diagnostic on your Carrier, Trane, or Goodman system - readings shown to you before any repair is proposed
Diagnosis first, numbers second - you approve the repair price before a single part goes in.
Before
After
Before
After
Before
AfterFast, Reliable Heat Pump Installation Across Aubrey
A new heat pump installation in Aubrey, TX typically runs $3,500 to $7,500 depending on the size of your home, the system’s efficiency rating, and whether your existing ductwork can handle the job. We install heat pumps all over Aubrey, from Paloma Creek to Silverado to ArrowBrooke, and we know what this town’s specific housing mix demands. Most installations take one full day, and you get a written price before we touch anything. Call us at (361) 306-9515 for a free estimate, and we’ll send a tech who knows Aubrey homes.
Aubrey isn’t one kind of housing market. It’s a fast-growing North Texas town where a brand-new Lennar or Highland home sits across the road from a 1980s ranch on a two-acre lot. That matters for Heat Pump Installation because the right system for a tight, spray-foamed new build is often wrong for an older home with leaky duct runs and a retrofitted return. We see this every week. The people who call us after another company blew the job usually got a one-size-fits-all quote that ignored how their house actually breathes. We do the load calculation first. Then we talk price.
Why Dalton Heating & Air Is Aubrey’s Preferred Heat Pump Installation Company
Marco Benitez runs our Aubrey-facing operation, and he’s built the crew around a simple rule: show up inside the window, put the price in writing, and don’t leave until the system is running and the site is clean. That’s The Garrison Code, and it’s been the standard at every Garrison Partners location since 2003. We’re not the cheapest bid in Aubrey. We don’t want to be. We’re the company you call when a low bid turns into a no-show or a door price that’s $1,800 higher than the phone quote.
Our techs are factory-trained on nine residential brands: Carrier, Trane, Lennox, Goodman, Rheem, York, Daikin, Bryant, and American Standard. That matters in Aubrey because homes here run everything from builder-grade Goodman units in new subdivisions to aging Rheem and York systems in older acreage properties. We stock common parts locally so a repair or install doesn’t stall for three days waiting on a warehouse shipment.
Every job includes a written guarantee for a full year. If the installation isn’t done right, we return at no charge. That’s the 365-Day Done Right Promise, and it’s not an upgrade you pay extra for. It’s the default.
Heat Pump Maintenance in Aubrey
Heat Pump Maintenance in Aubrey is a twice-a-year job, and it matters more here than in drier parts of Texas because our summers push humidity through the coil and our clay-heavy soils settle and shift outdoor units. A tune-up runs $80 to $200, and it covers coil cleaning, refrigerant check, electrical inspection, condensate drain clearing, and a written report of what we found. The report is yours to keep whether or not you approve any extra work.
What a spring tune-up catches before June
By May, Aubrey temperatures climb fast, and a heat pump with a dirty outdoor coil will pull more amperage and run hotter. A spring tune-up catches that before the first 95-degree day. We check the refrigerant charge against the manufacturer’s spec for Aubrey’s altitude, roughly 600 feet above sea level. A system charged for sea level runs slightly differently here, and that affects compressor life over time.
Fall maintenance before the first cold snap
Heat pumps work year-round, so fall maintenance is about the reversing valve, defrost cycle, and auxiliary heat strips. North Texas cold snaps hit Aubrey hard in January and February, and a heat pump with a dead defrost sensor will turn itself into a block of ice. That’s not a repair you want at 6 a.m. on a 19-degree morning.
Geothermal Heat Pump Installation in Aubrey
Geothermal Heat Pump Installation in Aubrey is a different animal from a standard air-source install, and it’s worth understanding before you commit. Geothermal systems run $15,000 to $35,000 installed for most Aubrey properties, depending on whether you need vertical boreholes drilled or have room for horizontal loop trenches. The payoff is utility cost: a geothermal unit typically cuts heating and cooling bills by 30 to 50 percent compared to a standard heat pump, because it pulls heat from the ground rather than from the outside air.
Acreage properties and horizontal loops
If you’re on one of Aubrey’s larger lots outside the main subdivisions, you may have room for a horizontal loop field. That’s the lower-cost geothermal option, typically $15,000 to $22,000 all-in. The tradeoff is trenching across whatever part of your yard you’re willing to disturb. On smaller lots in Paloma Creek or Silverado, vertical drilling is the only option, and that’s where the price climbs toward the upper end of the range.
What geothermal means for a heat pump’s lifespan
A geothermal heat pump (the indoor unit) is not fundamentally different from an air-source unit. The difference is that the outdoor coil sits in a stable 55-to-65-degree loop instead of a 100-degree Texas summer air mass. That reduces compressor strain and means the indoor unit can last 20 years or more, roughly double a standard heat pump in Aubrey’s climate. The loop field itself typically carries a 50-year warranty from the manufacturer.
Trusted Brands We Service in Aubrey
We install and service Goodman, Rheem, York, and Daikin heat pumps across Aubrey, plus five other major brands, and we keep the most common replacement parts stocked locally. That means a blown capacitor or failed defrost board on a Rheem unit in ArrowBrooke doesn’t mean a three-day wait for a part to ship from Dallas. We also know the quirks of each brand. Goodman units are common in Aubrey’s new-build subdivisions, and they’re fine systems when installed and charged correctly, but they’re sensitive to refrigerant overcharge. York systems from the 2005-to-2015 era tend to leak at brazed joints. Daikin’s inverter units are excellent for humidity control, which matters in a July where the dew point sits at 74 for a week straight. We’ll give you a straight answer about which brand fits your house and your budget, not just whichever unit we have sitting in the shop.
Common Heat Pump Installation Problems We See in Aubrey Homes
- Oversized systems from day one. Builders and cut-rate installers often size a heat pump by square footage alone, without a load calculation. In Aubrey’s humid summers, an oversized unit short cycles and never runs long enough to pull moisture out of the air. The house hits 72 but feels sticky, and the compressor gets beat to death by constant starts.
- Ductwork that can’t handle the new unit’s airflow. Aubrey’s mix of new tight-envelope homes and older acreage properties creates a specific problem: a modern variable-speed heat pump moving 1,600 CFM of air through 40-year-old flex duct that was sized for 1,000 CFM. The blower motor works twice as hard, burns out early, and the system never delivers rated efficiency.
- Incorrect refrigerant charge for local conditions. At roughly 600 feet of elevation, Aubrey is not at sea level, and a system charged to the sea-level spec runs inefficiently and shortens compressor life. We charge every new install to the manufacturer’s chart for our specific conditions, not a generic number from the manual’s cover page.
- Condensate drains that can’t keep up. Aubrey’s summer humidity means a heat pump can pull gallons of water out of the air every day. In older homes where the drain line is undersized or sloped wrong, that water backs up, trips the safety switch, and leaves you with no cooling on the hottest day of the year. We replace undersized drains on nearly every install in older Aubrey homes.
Pricing for Heat Pump Installation in Aubrey, TX
Here’s what you’re actually looking at for a heat pump install in Aubrey. These are line-item ranges, not teaser numbers:
| Service | Aubrey Price Range |
|---|---|
| Heat Pump Installation | $3,500 – $7,500 |
| Heat Pump Repair | $150 – $650 |
| Heat Pump Tune-Up | $80 – $200 |
What pushes an install toward the top of that range? A larger home in a newer Aubrey subdivision needs a bigger unit and more labor. An older home with ductwork that has to be replaced or sealed adds real cost. A variable-speed system runs more than a single-stage unit, but in Aubrey’s humid climate, it’s often the right call because it dehumidifies better. The price you get from us is the price you pay. Written, fixed, before any work starts. Call (361) 306-9515 and Marco Benitez will walk you through what your specific house needs and exactly what it costs.
Real Talk: Repair or Replace Your Aubrey Heat Pump?
Aubrey’s rapid growth means a lot of homes are hitting the 10-to-15-year mark on their original builder-grade systems at the same time. The question every homeowner asks is whether to fix the old unit or put that money toward a new one. Here’s our honest answer: if the repair is under $500 and the system is under 12 years old, fix it. If the compressor is gone, the coil is leaking, or the unit is over 15 years old, you’re paying to keep a dying system on life support. A new heat pump in Aubrey typically cuts your cooling bill by 20 to 40 percent compared to a 15-year-old unit, and that savings starts immediately.
Here’s a real example from recent work. Our tech installed a Carrier heat pump in the Paloma Creek neighborhood after a homeowner’s 15-year-old system kept tripping the breaker. We ran a load calculation and found the old unit was oversized by a full ton, which caused short cycling and high indoor humidity. The new variable-speed unit, sized correctly, dropped their summer electric bill by about $60 a month. That’s not a rare outcome here. We see oversizing in Aubrey constantly.
We Also Serve Cities Near Aubrey
We run crews to Aubrey every day, and we also cover the surrounding North Texas communities: Heat Pump Installation in Aubrey and nearby Pilot Point, Frisco, Little Elm, and Denton. If you’re just outside the city limits on a county road, call us. We’ll tell you straight if we can get to you same week.
Serving Aubrey, TX - Our Local Coverage Area
We’re based in the Aubrey area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs About Heat Pump Installation in Aubrey
Aubrey’s humid subtropical climate means a heat pump has to do two jobs well: cool and dehumidify. An oversized system cools the air too quickly and never runs long enough to remove humidity, leaving your house feeling clammy even at 72 degrees. We run a Manual J load calculation on every install in Aubrey, using the home’s actual square footage, window orientation, insulation levels, and ductwork condition, not a rule-of-thumb guess. Call (361) 306-9515 for a proper sizing assessment.
A SEER2 rating between 15 and 17 is the sweet spot for most Aubrey homes. Below 15, and you’re paying noticeably higher summer electric bills. Above 17, the upfront price climbs faster than the utility savings justify, unless you’re planning to stay in the house for 10-plus years. A variable-speed unit in the 16-to-18 SEER2 range is often the best fit for Aubrey’s humidity because it runs at lower speeds for longer cycles, pulling more moisture out of the air. We’ll show you the payback math on a few options before you decide.
You can, but we generally don’t recommend it in Aubrey unless the indoor unit is less than five years old. Mismatched indoor and outdoor units create refrigerant and airflow problems that kill efficiency and shorten compressor life. The old indoor coil often can’t handle the newer outdoor unit’s refrigerant requirements. There are limited cases where it makes sense, and we’ll tell you straight whether yours is one of them. We won’t sell you a half-system just to take the job.
Twice a year. Once in spring before cooling season, once in fall before heating season. Aubrey’s summer humidity puts a heavy load on the coil and drain system, and our winter cold snaps stress the defrost cycle. A $80 to $200 tune-up catches small problems before they become $600 repairs. The maintenance report you get is written, dated, and yours to keep whether or not we find anything wrong.
Most Aubrey heat pump installations fall between $3,500 and $7,500, with the average around $5,000 for a standard single-stage system in a mid-size home. Variable-speed systems and jobs requiring ductwork replacement push higher. You’ll get a written fixed price before any work begins, and if the install isn’t done right, the 365-Day Done Right Promise means we fix it at no charge. Call (361) 306-9515 for a free estimate on your specific home.
Written by Marco Benitez, Owner at Dalton Heating & Air, serving Aubrey and surrounding North Texas communities.