Seasonal tune-up and full diagnostic on your Carrier, Trane, or Goodman system - readings shown to you before any repair is proposed
Diagnosis first, numbers second - you approve the repair price before a single part goes in.
Before
After
Before
After
Before
AfterHVAC Company in Maltby, WA
Dalton Heating & Air is the HVAC company for Maltby, WA. We repair and install heating and cooling systems in this unincorporated Snohomish County community, where homes sit on larger lots and older equipment runs harder through damp winters and dry summer stretches. Marco Benitez leads our crew, and every job comes with a written price before we start and a full-year written guarantee on repairs. Call (361) 306-9515 when your system stops doing its job.
Why Maltby Homes Are Different
Maltby sits northeast of Woodinville along Highway 522, tucked into rolling terrain with a mix of 1970s ramblers, 1990s two-stories, and a growing number of newer builds on acreage. Many homes here rely on heat pumps and electric furnaces because natural gas lines never reached parts of the area. That matters when equipment fails in February: a heat pump losing charge on a cold snap means strip heat kicking in, and an electric bill that climbs fast if the thermostat wiring is off.
The damp climate works against outdoor condensers. Moisture collects on coils, and moss growth around units is common on shaded Maltby properties. We regularly see corrosion on contactors and capacitor housings before the compressor itself becomes an issue. Lot drainage also plays a role: units sitting low accumulate standing water, which shortens component life. Flat-rate repair pricing covers what we find, whether it’s a contactor swap or a full defrost board replacement.
Permits are handled through Snohomish County when a mechanical installation requires one, and some Maltby neighborhoods with covenants expect equipment placed out of street view or screened on specific sides of the home. We flag those considerations before installation day so there are no surprises.
Our Main Maltby Services
Most Maltby calls come in for two things: a furnace that won’t fire in winter, or an air conditioner that stopped cooling in a July heat wave. Here’s what each job looks like on the ground.
AC Repair in Maltby
When an air conditioner stops cooling in a Maltby summer, the cause is usually electrical before it’s mechanical: a failed capacitor, a burnt contactor, low refrigerant from a slow leak at a flare fitting. Our techs test the compressor, fan motor, and controls, then explain the fix in trade terms and plain English. We carry common parts on the truck, and if a compressor is the culprit, we give you repair and replacement numbers honestly. See AC Repair in Maltby for what a repair visit covers and what it costs.
Heat Pump Installation in Maltby
Maltby’s electrical-heavy housing stock makes heat pump installation a strong move when existing equipment fails. We size units to the home’s actual duct layout and square footage, not a rule of thumb. That means checking return air, static pressure, and existing thermostat wiring before recommending equipment from Rheem, York, or Bryant. The job includes a written fixed price and a set install date. See Heat Pump Installation in Maltby for what to expect, including permit handling.
Furnace Repair in Maltby
A furnace that won’t light in a Maltby winter is usually a failed igniter, flame sensor, or pressure switch. We diagnose those quickly, and most repairs are completed the same visit. Older electric furnaces in the area often need sequencer or limit switch replacement, and we stock those parts because it’s common here. The repair is guaranteed in writing for a full year. See Furnace Repair in Maltby for specific repair prices and what we check.
What happens when you call
- 1
A real person answersNo phone trees - you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Brands We Service in Maltby
Our technicians are factory-trained on Rheem, York, and Daikin, along with most other major residential brands, and we stock common parts for these systems locally. See our brands for the full list. Turnaround is typically same-day when a stocked part fits.
Pricing for HVAC Company in Maltby, WA
| Service | Typical range in Maltby |
|---|---|
| AC repair visit (diagnostic, minor electrical) | $150 – $300 |
| AC repair with refrigerant recharge | $250 – $550 |
| AC repair with compressor replacement | $400 – $650 |
| Furnace repair (igniter, flame sensor, pressure switch) | $150 – $350 |
| Furnace repair with blower motor replacement | $300 – $600 |
| Furnace repair with heat exchanger replacement | $600 – $700 |
| AC installation (full system) | $3,500 – $7,500 |
| Tune-up (spring or fall) | $80 – $200 |
Prices move higher when a system needs both a refrigerant recharge and an electrical part, or when a heat pump outdoor unit has been neglected long enough to stress the compressor. Every job gets a written price before we start, and that number is what you pay.
Neighborhoods We Serve in Maltby
We take calls from every corner of Maltby, including the residential pockets along 51st Ave SE, Paradise Lake Rd, and the newer subdivisions near Little Bear Creek. Response time is typically same-day for repair calls, and we schedule installations within the week.
- Paradise Lake area
- Little Bear Creek neighborhoods
- Maltby Road corridor
- Echo Lake vicinity
- 51st Ave SE residential pockets
Service Area – Cities Near Maltby
Dalton Heating & Air serves Maltby and the surrounding Puget Sound region. Our Maltby crews also cover nearby communities, and depending on scheduling, you may find us in Seattle, WA, Tacoma, WA, Vancouver, WA, or Spokane, WA. Dispatch and scheduling are coordinated from our Seattle office; Maltby calls route to the nearest available tech.
Serving Maltby, WA - Our Local Coverage Area
We’re based in the Maltby area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs About HVAC Company in Maltby
Most Maltby repair calls are answered same-day, especially for no-heat and no-cooling situations during extreme weather. We route based on technician location, so response can be within a few hours. Call (361) 306-9515 and a live person confirms your window, not an answering service.
Some mechanical installations require a permit through Snohomish County, and we handle the paperwork as part of the job. Repairs and replacements of like-for-like components typically don’t. We’ll tell you before work starts whether a permit is needed for your specific project.
Yes. Our phones are answered by a real person 24 hours a day, 7 days a week. No voicemail queue, no callback window. When your furnace quits at 11pm or your AC dies on a Sunday afternoon, you talk to a person who can dispatch help.
What happens when you call
- 1A real person answersNo phone trees - talk to a local hvac pro.
- 2You get an upfront price rangeHonest numbers before anyone is dispatched. No surprises.
- 3We come out and measureLicensed & insured, at a time that suits you - the visit and the quote are both free.
- 4You get the price in writingLine-itemed, yours to keep, and nothing starts until you say go.
What Maltby Customers Say
"Honest, direct people. Told me what the furnace needed and nothing more, and the bill matched."
- Eliza S."Coil cleaning and a refrigerant check before summer. AC has never been this cold."
- Marty D."Good communication, tidy, and disciplined work. Taped off the floor and wiped the unit down."
- Karen J.