Seasonal tune-up and full diagnostic on your Carrier, Trane, or Goodman system - readings shown to you before any repair is proposed
Diagnosis first, numbers second - you approve the repair price before a single part goes in.
Before
After
Before
After
Before
AfterHVAC Company in Frisco, TX
Dalton Heating & Air handles HVAC work across Frisco, TX, from AC repairs that need a same-day fix to full heat pump installations. What makes Frisco jobs different is the mix: homes built in the 2000s and 2010s are hitting the age where capacitors, contactors, and blower motors start failing, while the newer builds in the northern neighborhoods come with their own commissioning and sizing issues. You get a written price before any work starts, a live person on the phone 24/7 at (361) 306-9515, and a full-year written guarantee on every repair. This page covers how we work in Frisco, what things cost here, and where we go. Each major service has its own detailed Frisco page, linked right below.
Why Frisco Homes Are Different
Frisco’s housing stock runs on a tight timeline. Most neighborhoods were built out between 2000 and 2020, which means a lot of original equipment is now 10 to 20 years old. That is the window where heat exchangers rust through, evaporator coils leak, and compressors start drawing too many amps. In Stonebriar and The Trails, we routinely find systems that were oversized when installed, which short-cycles and kills compressors early. In newer developments north of Eldorado Parkway, we see the opposite problem: ductwork and returns that were never commissioned properly, leaving rooms 6 to 10 degrees off from the rest of the house. Frisco summers push rooftop condensers hard, and the hail that rolls through Collin County every spring takes a toll on coil fins. HOA rules in many Frisco communities restrict where outdoor units can sit, which can complicate a heat pump installation and dictate line-set routing.
Our Main Frisco Services
The two calls we get most in Frisco are AC outages during the June-to-September stretch and older units that need to be retired before another summer. Here is what each job involves locally.
AC Repair in Frisco
The most common AC repair in Frisco is a failed capacitor on a 10-to-15-year-old condenser. The second most common is a refrigerant leak from an evaporator coil that has slowly eaten itself. If your system is blowing warm air or the outdoor unit is humming but the fan is not spinning, shut it down at the thermostat and call us. Running it can turn a $150 capacitor job into a $650 compressor replacement. We keep the common Frisco parts on the truck, so most repairs happen the same visit. Details, pricing, and how we diagnose are on the AC Repair in Frisco page.
Heat Pump Installation in Frisco
A heat pump install in Frisco means a written, load-calculated quote before anything gets ordered. We do not guess on tonnage. Frisco homes range from 1,400-square-foot courtyard layouts to 4,000-plus-square-foot builds in west Frisco, and the existing ductwork often dictates what can be done. If your HOA has restrictions on condenser placement, we will survey that before the quote so there are no surprises on install day. Most heat pump installations run $3,500 to $7,500 in Frisco depending on size, ductwork, and brand. The full breakdown is on the Heat Pump Installation in Frisco page.
Furnace Repair in Frisco
Frisco winters are not brutal, but a furnace failure in a 20-degree January stretch is a health risk in a house that is built to keep heat in the summer. The repair we see most in Frisco is a failed ignitor or flame sensor on gas furnaces that have sat idle for eight months. Most furnace repairs in Frisco run $150 to $700 depending on the part. If the furnace is over 15 years old and the heat exchanger is cracked, we will tell you straight rather than patch it. See Furnace Repair in Frisco for more.
What happens when you call
- 1
A real person answersNo phone trees - you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Brands We Service in Frisco
Our technicians are factory-trained on the full range of residential equipment, including Carrier, Trane, Lennox, Goodman, Rheem, York, Daikin, Bryant, and American Standard. We stock common Rheem, York, and Bryant parts on the truck for Frisco calls, which cuts turnaround. See our brands for more.
Pricing for HVAC Company in Frisco, TX
| Service | Typical range in Frisco |
|---|---|
| AC repair (capacitor, contactor) | $150 – $650 |
| AC repair (refrigerant leak repair) | $150 – $650 |
| AC install (full system) | $3,500 – $7,500 |
| Heat pump installation | $3,500 – $7,500 |
| Furnace repair (ignitor, flame sensor) | $150 – $700 |
| Furnace repair (blower motor, board) | $150 – $700 |
| Seasonal tune-up (AC or furnace) | $80 – $200 |
What pushes a Frisco repair to the top of those ranges is usually the age of the unit and parts availability on specialty brands. Every quote is in writing before work starts, so the number on the table is the number you pay.
Neighborhoods We Serve in Frisco
We run calls all over Frisco. You will see our trucks in Stonebriar, along Preston Road, through The Trails, and up into the new builds north of Eldorado.
- Stonebriar
- The Trails
- Plantation Resort
- Grayhawk
- Phillips Creek Ranch
Most Frisco calls we can reach within an hour. If a heat advisory is in effect, we prioritize no-cooling calls first.
Service Area – Cities Near Frisco
Beyond Frisco, we serve several nearby communities. If your home is in Prosper, TX, Aubrey, TX, Little Elm, TX, or Celina, TX, dispatch and scheduling run through our Dallas-Fort Worth office, and crews serve each city locally. Call (361) 306-9515 to confirm availability in your neighborhood.
Serving Frisco, TX - Our Local Coverage Area
We’re based in the Frisco area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs About HVAC Company in Frisco
Most Frisco calls we reach within an hour, and during heat advisories we prioritize homes without working AC. Call (361) 306-9515 and a live person answers 24/7, no callback window.
Some Frisco HOAs restrict condenser placement or require approval before installation. We survey placement during the quote and document what your HOA needs, so the work passes on the first try.
We serve the full city, from Stonebriar and The Trails up to Phillips Creek Ranch and the newer developments north of Eldorado. If you are unsure whether you are in our Frisco service area, call (361) 306-9515 and ask.
If your AC, heat pump, or furnace needs attention in Frisco, call (361) 306-9515 for a written, free estimate. Marco Benitez and the Dalton Heating & Air team run every job under The Garrison Standard: arrive on time, price in writing, work done by the book, site left clean, and the repair guaranteed in writing for a full year.
What happens when you call
- 1A real person answersNo phone trees - talk to a local hvac pro.
- 2You get an upfront price rangeHonest numbers before anyone is dispatched. No surprises.
- 3We come out and measureLicensed & insured, at a time that suits you - the visit and the quote are both free.
- 4You get the price in writingLine-itemed, yours to keep, and nothing starts until you say go.
What Frisco Customers Say
"Good communication, tidy, and disciplined work. Taped off the floor and wiped the unit down."
- Karen J."Installed a heat pump to replace an old oil furnace. Three clear quotes and the install crew was tidy."
- Cheryl B."Tech arrived in uniform right on time. AC wasn't cooling, found a failed capacitor, and replaced it in twenty minutes. The owner is a veteran and the company runs like it."
- Frank O.