Seasonal tune-up and full diagnostic on your Carrier, Trane, or Goodman system - readings shown to you before any repair is proposed
Diagnosis first, numbers second - you approve the repair price before a single part goes in.
Before
After
Before
After
Before
AfterFast, Reliable Furnace Repair Across Westchester
Furnace repair in Westchester, FL typically costs $150 to $700 depending on the part, and most calls are resolved in a single visit. We dispatch crews into Westchester from our South FL coordination office, so a uniformed, background-checked technician can reach homes near Coral Way, Bird Road, or the Turnpike quickly. The price is in writing before any work starts, and the repair is guaranteed in writing for a full year. Call (361) 306-9515 for a free estimate.
Why Dalton Heating & Air Is Westchester’s Preferred Furnace Repair Company
Our Furnace Repair team works from a specific standard: arrive inside the stated window, put the price in writing before any work starts, do the job by the book, leave the site clean, and stand behind the repair for a full year. That’s The Garrison Standard, and it has applied to every Dalton Heating & Air job since 2003.
Westchester homeowners deal with specific realities: CBS construction, 1950s and 1960s ranch layouts, furnaces tucked into closets or utility rooms that have not been touched in 20 years. Our technicians are trained on those exact conditions. Marco Benitez, who leads Dalton Heating & Air, holds every tech to The Garrison Code on each call. If a repair fails within the guarantee period, we return at no charge. No negotiation. No callback window.
Boiler Repair in Westchester
Boiler repair in Westchester usually comes down to a circulator pump, an expansion tank, or a zone valve that has gone bad. Because most of Westchester’s housing stock dates to the 1950s through 1970s, boilers here are often older hydronic systems that see short, sharp winter demand and then sit idle for most of the year. That idle time is what kills components faster than constant use. A typical boiler repair in Westchester runs $150 to $700 depending on the part.
Circulator and zone valve failures
An original circulator pump that runs only a month or two per year can seize from sediment and oxidation. Same with zone valves. We diagnose the mechanical failure first and hold off on boiler replacement unless the heat exchanger itself is gone.
Expansion tank and pressure issues
If the boiler fires and the pressure relief valve spits water, the expansion tank has likely lost its air charge. That’s a $150 to $400 repair for most Westchester homes, and it’s one of the few boiler jobs where a yearly inspection actually prevents the failure.
Gas Furnace Repair in Westchester
Gas furnace repair in Westchester usually means an ignitor, a flame sensor, a gas valve, or a high-limit switch that is tripping because the system cannot move enough air. The most common age on these furnaces is 20 to 30 years, because the original unit in a 1960s ranch either lasted that long or was swapped once and never touched again. A typical gas furnace repair in Westchester runs $150 to $700.
Ignitor and flame sensor
A furnace that lights and then shuts off after 30 to 90 seconds is usually a dirty flame sensor or a cracked ignitor. Both are straightforward repairs. The bigger risk is when a unit has been short-cycling for weeks in a cold snap, because that stress can crack a heat exchanger on an already old system.
High-limit trips and airflow
In older Westchester homes, undersized or crushed ductwork raises static pressure. The blower works against the restriction, the heat exchanger overheats, and the high-limit switch shuts it down. The furnace is not the problem. The ductwork is. Figuring that out correctly takes a load calculation, not a part swap.
Trusted Brands We Service in Westchester
Our techs are factory-trained on Trane, Lennox, Goodman, and Rheem, among other major residential brands. That matters in Westchester because original-equipment parts for a 1980s Trane or a 1990s Goodman are not always on the shelf at a supply house. We stock common ignitors, flame sensors, gas valve kits, and blower capacitors in our vans so a one-trip repair is the norm, not the exception. If the local supply house has to order the part, we tell you that before any work begins.
Common Furnace Repair Problems We See in Westchester Homes
- Cracked heat exchangers on original-era furnaces. Westchester’s 1950s to 1970s ranch stock means many units are now 20 to 30 years old, and a short, intense winter demand cycle is often what cracks a heat exchanger that would have survived in a milder run pattern.
- Deferred maintenance turning into emergency no-heat calls. Because heating season is brief here, homeowners skip fall service. A weak capacitor or dirty flame sensor sits until the first cold front, then becomes a no-heat emergency the same night.
- High static pressure in older CBS homes. Undersized or collapsed ductwork causes blower motor overload and high-limit trips. The furnace itself is fine; the airflow is not. That requires a static pressure test and often a load calculation to confirm.
- Home-sale inspection failures. Many Westchester furnaces get discovered during a pre-purchase inspection. A buyer wants to know repair versus replace numbers, and a seller wants a clean HVAC disclosure. We handle both sides with written numbers.
Pricing for Furnace Repair in Westchester, FL
Most furnace repairs in Westchester land between $150 and $700. The final number depends on the failed component, not on how the house looks or what neighborhood it sits in. The price is the same written number whether the home is off Coral Way, near Tropical Park, or back toward the Turnpike.
| Service | Typical Cost in Westchester |
|---|---|
| Furnace repair | $150 – $700 |
| AC repair | $150 – $650 |
| AC installation | $3,500 – $7,500 |
| Tune-up | $80 – $200 |
The contract you sign before any work begins lists that range as an exact number for your specific repair. Estimates are free. Call (361) 306-9515 and we will give you the number over the phone or after a site visit, in writing, before any tools come off the van.
We Also Serve Cities Near Westchester
Dalton Heating & Air handles Furnace Repair in Westchester and surrounding communities across Florida. Our dispatch covers Jacksonville, Miami, Tampa, and Orlando, with the same written price and one-year guarantee on every job.
Serving Westchester, FL - Our Local Coverage Area
We’re based in the Westchester area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs About Furnace Repair in Westchester
Repair is usually the right call when the furnace is under 15 years old and the failed part is a capacitor, ignitor, flame sensor, or gas valve. Replacement is typically the honest answer when the heat exchanger is cracked on a 20 to 30-year-old unit in a 1950s to 1970s Westchester home. The math is specific: a heat exchanger replacement on an old furnace often runs 60 to 80 percent of the cost of a new 96% AFUE unit. We give you both numbers in writing and let you decide. Call (361) 306-9515 for a free repair-versus-replace assessment.
Furnace repair in Westchester runs $150 to $700 for most jobs. A flame sensor or ignitor is at the low end. A gas valve or blower motor runs toward the middle or top of that range. The exact price is written down before any work starts, and the repair is guaranteed in writing for a full year. If it fails in that time, we come back at no charge.
Short-cycling on a Westchester furnace is usually an airflow problem, not a furnace problem. Undersized or crushed ductwork in older CBS construction pushes static pressure up, the blower works harder, the heat exchanger overheats, and the high-limit switch trips. A dirty filter can also cause it, but in this housing stock the ductwork is the usual suspect. We test static pressure before we replace parts, because replacing a blower motor on a system that is still starving for air solves nothing.
Yes. We repair gas furnaces and hydronic boilers throughout Westchester, including homes off Coral Way, Bird Road, SW 87th Avenue, and around Tropical Park. Our techs carry common gas valve kits, ignitors, flame sensors, and circulator parts so most repairs are completed in one visit. Prices are written before any work starts, and the guarantee is written for a full year.
SEER2 is a cooling efficiency metric, and in a cooling-dominated market like Westchester, it directly affects your annual AC bill. If you are repairing an old furnace attached to a 10 SEER AC system, we will show you what a matched 16 or 18 SEER2 replacement would save per year on electricity. That number matters more in South Florida than in any heating-heavy city, because your AC runs far more hours than your furnace. Call (361) 306-9515 and we will run the numbers on your actual system, free.
Written by Marco Benitez, Owner at Dalton Heating & Air, serving Westchester with written pricing and a full-year guarantee on every furnace repair since 2003.