Seasonal tune-up and full diagnostic on your Carrier, Trane, or Goodman system - readings shown to you before any repair is proposed
Diagnosis first, numbers second - you approve the repair price before a single part goes in.
Before
After
Before
After
Before
AfterFast, Reliable Heat Pump Installation Across Cleburne
A full heat pump installation in Cleburne typically runs $3,500 to $7,500 depending on system size, SEER2 rating, and what your ductwork needs. That’s the written price you get before any work starts. We install heat pumps across Cleburne, from the historic district near downtown to the newer subdivisions around Lake Pat Cleburne. Call (361) 306-9515 for a free estimate, and a real person answers, day or night.
Cleburne sits in a climate band where a heat pump earns its keep roughly eight months a year. We get real summer heat and actual winter cold, which means the system has to handle both loads without overshooting either one. A heat pump that’s sized right for a Cleburne summer won’t struggle to keep up when January dips below freezing. The trick is knowing what “sized right” actually means for your specific house, and that’s where most installs go wrong.
Why Dalton Heating & Air Is Cleburne’s Preferred Heat Pump Installation Company
We’ve worked in enough Cleburne homes to know the two big housing profiles here. The older pier-and-beam houses near the Johnson County Courthouse and along Henderson Street have crawl spaces, original hardwoods, and often ductwork that’s been patched and re-patched for sixty years. The newer slab builds out toward Nolan River Road and Chisholm Trail Parkway are tighter, better insulated, and need a different calculation entirely. A crew that treats both like the same job gets one of them wrong.
Dalton Heating & Air operates under The Garrison Standard, which has been in place since 2003. That means every heat pump install in Cleburne starts with a written price, not a verbal ballpark. Our techs are background-checked and uniformed, and they show up inside the window we give you. Marco Benitez runs our team, and he holds every job to the same standard: arrive on time, price in writing before starting, do the work by the book, leave the site clean, and stand behind it for a full year.
We service nine major residential HVAC brands, which matters because Cleburne homes run everything from Trane units in the higher-end builds to Goodman and Rheem in more budget-conscious replacements. Factory training on all of them means we don’t learn on your time.
Heat Pump Maintenance in Cleburne
Heat Pump Maintenance in Cleburne is not a seasonal favor you do the system. It’s the difference between a heat pump that runs fourteen years and one that fails at nine. In our climate, the outdoor coil picks up cottonwood fuzz in spring and grass clippings in summer, and a coil that can’t reject heat in August forces the compressor to work hotter than it should. A tune-up in Cleburne runs $80 to $200, and that includes a capacitor test and a refrigerant charge check.
What We Check on Every Maintenance Call
We test the capacitor under load, because a weak capacitor is the single most common reason a Cleburne heat pump won’t start on the first hot afternoon of May. We clean the outdoor coil, check refrigerant pressure against the manufacturer’s chart, inspect the reversing valve, and verify the defrost cycle works. We also check amp draw on the compressor and fan motor, because rising amp draw shows up months before a motor fails.
When Cleburne Homeowners Should Schedule
Twice a year is right for most Cleburne homes. Spring takes care of the summer load, and fall catches anything that loosened up through the summer before the first cold snap. If you wait until the system breaks, you’re paying repair labor on top of what the maintenance call would have caught. Every maintenance visit comes with the same written pricing and the same 365-Day Done Right Promise as any other call.
Geothermal Heat Pump Installation in Cleburne
Geothermal Heat Pump Installation in Cleburne is a different animal from an air-source swap, and it’s worth considering on the right property. A geothermal system uses a ground loop instead of an outdoor condensing unit, so it doesn’t lose capacity when our summer air hits 100 degrees or when winter drops below freezing. The loop field goes in horizontally on a bigger lot or vertically on a smaller one, and Cleburne’s clay-heavy soils hold heat transfer well once the loop is grouted correctly.
Who Geothermal Makes Sense For
Geothermal makes the most sense when you’re planning to stay in the house ten years or more, because the upfront cost is higher but the operating cost runs 40 to 60 percent below a standard heat pump. The ground loop itself carries a multi-decade warranty, and the indoor unit is essentially a standard heat pump that doesn’t have to fight extreme outdoor air. On acreage around County Road 313 or out toward Grandview, a horizontal loop field is often the simplest option.
What Geothermal Costs and Why
Geothermal is a bigger project than an air-source swap. You’re drilling or trenching, running loop piping, and fusing it underground, and then the indoor unit installs like any other heat pump. We’ll give you a written price that covers the full loop field, the unit, and the indoor connections, and we won’t start drilling until that price is in your hand. The same 365-Day Done Right Promise applies.
Trusted Brands We Service in Cleburne
We install and service Trane, Lennox, Goodman, and Rheem heat pumps in Cleburne, and our techs are factory-trained on all of them. That matters when you already own a Goodman and a sales rep from another company wants to talk you into a Trane because that’s all they stock. We’d rather fix what you have if it’s worth fixing, and if it’s not, we’ll give you a written replacement price on a unit that fits your ductwork and your budget. Parts ordering for these brands moves faster through our Dallas-Fort Worth dispatch office, so Cleburne customers aren’t waiting a week for a compressor.
Common Heat Pump Installation Problems We See in Cleburne Homes
- Oversized units short-cycling in humid summers. A too-big heat pump cools the air fast but never runs long enough to pull humidity out. You get a cold, clammy house and a compressor that dies early from starting and stopping constantly.
- Duct leakage in older pier-and-beam homes. Crawl-space ductwork in houses built before about 1980 loses a surprising amount of conditioned air into the crawl. A new heat pump can’t fix that; the ducts have to be sealed or the efficiency numbers mean nothing.
- Thermostat calibration throwing off defrost cycles. A thermostat reading even three degrees off can send the heat pump into defrost at the wrong time, which shows up as the outdoor unit frosting over on a 50-degree night in Cleburne.
- Ignoring static pressure on new slab-built homes. Tighter houses with high-efficiency filters sometimes choke airflow across the coil. The blower motor works against static pressure it wasn’t spec’d for, and the system underperforms from day one.
We replaced a failing 12-year-old heat pump in the Santa Fe Trails area with a 3-ton Carrier unit after a load calculation showed the old system was oversized and short-cycling thanks to leaky original ductwork. Our tech sealed the ducts, verified refrigerant charge, and set thermostat calibration so the new heat pump actually runs long enough to dehumidify. The customer’s summer kWh use dropped noticeably the next bill.
Pricing for Heat Pump Installation in Cleburne, TX
Here’s what heat pump work actually costs in Cleburne, in writing.
| Service | Price Range |
|---|---|
| Heat Pump Installation | $3,500 – $7,500 |
| Tune-Up (capacitor test and refrigerant charge check included) | $80 – $200 |
| Heat Pump Repair (diagnostic and fix) | $150 – $650 |
Installation price moves with system tonnage, SEER2 rating, and what your ductwork needs. A 2-ton heat pump on a small well-insulated home sits at the lower end. A 4-ton unit with duct sealing on an older Cleburne house lands higher. The price you get is the price you pay. Call (361) 306-9515 for a free estimate, and we’ll put the number in writing before any work begins.
We Also Serve Cities Near Cleburne
Our Heat Pump Installation crews work throughout Johnson County, and we regularly handle jobs in Cleburne, Keene, Joshua, Alvarado, and Grandview. If you’re just outside city limits on a county road, call us and we’ll confirm we can get to you. Same written pricing, same full-year guarantee.
Serving Cleburne, TX - Our Local Coverage Area
We’re based in the Cleburne area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs About Heat Pump Installation in Cleburne
If the compressor is still pulling proper amp draw and the coils are in decent shape, a repair in the $150 to $650 range usually makes sense, especially on a unit under ten years old. If the compressor has failed or the unit is over twelve years old and leaking refrigerant, replacement at $3,500 to $7,500 starts to pencil out better than sinking repair money into a system near the end of its life. We’ll give you an honest read, not a sales pitch, and the diagnostic is part of the estimate. Call (361) 306-9515 and we’ll look at it.
A room-by-room load calculation changes the tonnage, the duct sizing, and the blower settings, because it measures each room’s actual gain and loss instead of guessing from square footage. In Cleburne, where an older pier-and-beam home and a newer slab build can have completely different envelopes, that’s the only way to avoid an oversized unit that short-cycles all summer or an undersized one that can’t hold temperature in January. This is not a “nice to have” extra; it’s the difference between a system that works and one that disappoints.
Aim for SEER2 15 to 17 on most Cleburne homes. Below 15 and you’re not much better than a builder-grade unit from a decade ago. Above 17 and the upcharge takes too many years to pay back at our electric rates unless you’re running the system constantly. The exception is geothermal, where the loop field does the heavy lifting and the efficiency numbers land well above any air-source unit.
Heat pump installation in Cleburne runs $3,500 to $7,500 for a full air-source system, and geothermal runs higher because of the ground loop. The range covers equipment tonnage, SEER2 rating, and any ductwork modifications your house needs. You’ll get an exact written quote before any work starts, and that price holds. Call (361) 306-9515 for a free estimate.
Yes, we service Carrier, Trane, Goodman, and every other major residential brand, including Lennox, Rheem, York, Daikin, Bryant, and American Standard. Our techs are factory-trained across all nine brands, so a Trane diagnostic is a Trane diagnostic, not a generic guess. Parts availability through our Dallas-Fort Worth dispatch office keeps most Cleburne repairs to a one-trip visit.
If your heat pump is struggling or you’re weighing repair against replacement, call (361) 306-9515. A live person answers, we’ll schedule a time that works for you, and the estimate is free, in writing, and good for the full job. Marco Benitez and the Dalton Heating & Air team serve Cleburne under The Garrison Standard: arrive on time, price in writing, do the job right, clean up, and stand behind it for a full year.
Written by Marco Benitez, Owner at Dalton Heating & Air, serving Cleburne and Johnson County.