Seasonal tune-up and full diagnostic on your Carrier, Trane, or Goodman system - readings shown to you before any repair is proposed
Diagnosis first, numbers second - you approve the repair price before a single part goes in.
Before
After
Before
After
Before
AfterHVAC Company in San Bruno, CA
Dalton Heating & Air handles heating and cooling work across San Bruno, CA, where the marine layer pushes cool, damp air over the hills most mornings and the housing stock runs from 1940s cottages to newer hillside builds. The job here is rarely a simple swap: tight crawlspaces, old duct runs, and furnaces jammed into hallway closets change how we diagnose and what we quote. If you need AC repair, heat pump installation, or furnace repair in San Bruno, call (361) 306-9515 and you’ll get a live person, a written price, and a crew that shows up inside the stated window.
Why San Bruno Homes Are Different
San Bruno sits on the east slope of the Santa Cruz Mountains, so a lot of the city climbs. Houses on the hill side, up near Crestmoor and Rollingwood, get hit by wind off the ocean and run colder than homes down by San Bruno Avenue or the flatlands near Tanforan. That elevation split shows up in the equipment: hill homes tend to run bigger furnaces and older ductwork that was installed to fight damp, fog-heavy winters. Flatland homes, especially the 1950s and 60s tracts, often have the original registers and returns that were sized for a different era of equipment.
We also see a lot of tight mechanical spaces. Many San Bruno homes have furnaces in hall closets or attic kneewalls where access is limited, which means a repair that takes 45 minutes in a roomy garage can take twice that here. Condensation is a real factor too. The marine layer keeps outdoor AC condensers wet through the summer, and we regularly find corroded contactors and rusted cabinet fasteners on systems that sit exposed to fog. None of that is unusual to us, but it does change how our technicians in San Bruno approach each visit.
Our Main San Bruno Services
Most San Bruno homeowners call Dalton Heating & Air for two things: a system that stopped working when they needed it, or a replacement they want done right the first time. Each service below has its own San Bruno page with pricing, timelines, and what to expect.
AC Repair in San Bruno
When an air conditioner quits in San Bruno, it’s often on the first genuinely hot afternoon of the year, after months of sitting idle in damp air. We check refrigerant pressures, electrical connections, and the condenser coil, then put the fix and the price in writing before any work starts. Fog is hard on outdoor units here: we replace a lot of rusted capacitors and pitted contactors on condensers that face the wind. AC Repair in San Bruno is our dedicated page with the full symptom breakdown and what a typical repair runs.
Heat Pump Installation in San Bruno
San Bruno’s mild summers and cool, damp winters make heat pumps a practical fit, especially for homes without existing AC. The catch is the terrain: hillside installs need proper pad leveling and sometimes a wall bracket, and we size the unit for the actual heat loss of the house, not a rule of thumb. Every install includes a written fixed price, a set install date, and a full year of coverage under the 365-Day Done Right Promise. See Heat Pump Installation in San Bruno for what the job involves and what it costs.
Furnace Repair in San Bruno
Furnace calls in San Bruno skew toward two problems: cracked heat exchangers on aging equipment near the end of its life, and ignition failures from moisture getting into the burner compartment. Access matters a lot here. We work around the closet and attic installs common in this city, and we never recommend a repair we wouldn’t make if the system were our own. Furnace Repair in San Bruno covers the most common failures, pricing, and how we diagnose a no-heat call.
What happens when you call
- 1
A real person answersNo phone trees - you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Brands We Service in San Bruno
Our technicians are factory-trained on the furnaces, air conditioners, and heat pumps most common in San Bruno homes, including Goodman, Rheem, and Daikin. We stock everyday parts locally for those brands, so a lot of repairs finish the same visit without a second trip for parts. See our brands for the full list of what we work on.
Pricing for HVAC Company in San Bruno, CA
| Service | Typical range in San Bruno |
|---|---|
| AC Repair | $150 – $650 |
| Furnace Repair | $150 – $700 |
| AC Installation | $3,500 – $7,500 |
| Tune-Up | $80 – $200 |
What pushes a San Bruno repair toward the top of the range is access: a furnace in an attic kneewall or a condenser pad cut into a hillside takes longer to work on than an open crawlspace. The price we quote is the price on the invoice, written down before any work begins, with no surprise line items at the end.
Neighborhoods We Serve in San Bruno
We run calls across the whole city, from the hillside blocks up near Crestmoor Canyon to the flat streets around San Bruno Avenue and the homes just off El Camino Real. Most San Bruno neighborhoods are 10 to 15 minutes from our dispatch point, and that holds true through normal afternoon traffic.
- Rollingwood
- Crestmoor
- Portola Highlands
- Mills Park
- Huntington
Service Area – Cities Near San Bruno
In addition to our San Bruno work, Dalton Heating & Air covers neighboring Peninsula cities for heating and cooling service. We regularly schedule jobs in Millbrae, CA, South San Francisco, CA, Pacifica, CA, and Brisbane, CA. If you’re a few minutes outside the city line, call us and we’ll confirm coverage and the next open window.
Serving San Bruno, CA - Our Local Coverage Area
We’re based in the San Bruno area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs About HVAC Company in San Bruno
Most repair calls in San Bruno are scheduled the same day, and emergency no-heat or no-cooling calls are prioritized. Scheduling is coordinated from our Bay Area office, but the technicians who arrive are local to the San Bruno area and know the housing stock. Call (361) 306-9515 and a live person will give you the next window.
Yes. San Bruno requires permits for equipment replacement, and the city’s inspection office checks that the install meets current mechanical code. We handle the permit paperwork on our installs and schedule the inspection for you, so the only thing you do is be home for the inspector if the city requires it.
Yes, we work the entire city, including Crestmoor, Rollingwood, and the streets up near the canyon. Hillside homes sometimes add a little time if we need to stage equipment, but there’s no neighborhood in San Bruno we won’t schedule.
If your heating or cooling system needs attention in San Bruno, call Dalton Heating & Air at (361) 306-9515 for a free estimate. The price is in writing before any work begins, the repair is guaranteed for a full year, and the crew shows up when we say they will.
What happens when you call
- 1A real person answersNo phone trees - talk to a local hvac pro.
- 2You get an upfront price rangeHonest numbers before anyone is dispatched. No surprises.
- 3We come out and measureLicensed & insured, at a time that suits you - the visit and the quote are both free.
- 4You get the price in writingLine-itemed, yours to keep, and nothing starts until you say go.
What San Bruno Customers Say
"Good communication, tidy, and disciplined work. Taped off the floor and wiped the unit down."
- Karen J."Installed a heat pump to replace an old oil furnace. Three clear quotes and the install crew was tidy."
- Cheryl B."Tech arrived in uniform right on time. AC wasn't cooling, found a failed capacitor, and replaced it in twenty minutes. The owner is a veteran and the company runs like it."
- Frank O.