Seasonal tune-up and full diagnostic on your Carrier, Trane, or Goodman system - readings shown to you before any repair is proposed
Diagnosis first, numbers second - you approve the repair price before a single part goes in.
Before
After
Before
After
Before
AfterHVAC Company in Kennedale, TX
Dalton Heating & Air is the HVAC company Kennedale homeowners call when the AC quits in July or the furnace won’t fire on a February morning. We handle AC repair, heat pump installation, and furnace repair across Kennedale, TX, with written pricing before any work starts and a full-year guarantee on every repair. If your system is down, call (361) 306-9515 and a live person answers, day or night. This page covers what makes Kennedale HVAC work different: the clay soil, the tight lots, the older and newer housing mix, and what jobs actually cost here.
Why Kennedale Homes Are Different
Kennedale sits on the southwestern edge of the Dallas-Fort Worth metro, and the housing stock tells two stories. You’ve got original 1960s and 1970s ranch homes along Kennedale Parkway and Mansfield Cardinal Road, many still running ductwork sized for furnaces that were installed before anyone thought much about AC. Then you’ve got subdivisions built in the last twenty years near New Hope Road and Dick Price Road, where systems are tighter but under more load because the homes are bigger with higher ceilings and east-west glass exposure. The clay soil under Kennedale shifts with every wet-dry cycle, which means slabs move, duct runs flex, and condensate lines that drained fine ten years ago now back up. We see that pattern constantly: a homeowner near Sonora Drive calls about a water stain on the ceiling, and the root cause is a condensate line that has shifted out of slope. The local fix is usually a re-pitched drain line and a float switch, which is a Kennedale repair more than a generic one.
Kennedale’s climate does the rest. Summers run 95 to 105 degrees for weeks, and the cooling season stretches from May into October. Winters are shorter but hard enough that a dead furnace in a 1970s pier-and-beam house is a genuine comfort emergency. There is no local permit requirement for a typical component swap like a capacitor, contactor, or blower motor, but any full system replacement or heat pump install goes through the City of Kennedale permitting desk. We handle that paperwork as part of the job, not as an extra.
Our Main Kennedale Services
Kennedale homeowners call Dalton Heating & Air most often for two things: an AC that stopped cooling and a furnace that will not fire. Here is what each job involves in this part of Tarrant County.
AC Repair in Kennedale
Most AC repair calls in Kennedale start the same way: the outdoor unit runs, the indoor blower runs, but the air coming out of the vents is warm. That points to a refrigerant leak, a failed capacitor, or a clogged condensate line, and the fix usually runs $150 to $650 depending on what we find. Because Kennedale sits on shifting clay soil, we check the refrigerant line set and drain slope before we change any parts, so we are not fixing the symptom and leaving the cause. Every AC repair in Kennedale gets the price in writing before we open a panel, and the repair is guaranteed in writing for a full year.
Heat Pump Installation in Kennedale
A heat pump replaces both your AC and your furnace logic in one unit, which fits a lot of Kennedale homes because our winters are cold enough to need heat but not so bitter that a heat pump struggles. The work starts with a load calculation on the actual house, not a guess from square footage, because a 1975 ranch and a 2015 two-story on the same street need very different equipment sizes. We then install the outdoor unit, the air handler, the thermostat, and a new line set, and we pull the permit. A heat pump installation in Kennedale is a scheduled job with a set install date and a written, fixed price before any equipment is ordered.
Furnace Repair in Kennedale
Furnace repair in Kennedale most often comes down to an igniter, a flame sensor, a pressure switch, or a blower motor, and most jobs run $150 to $700 depending on the part. In older Kennedale homes, we also check the heat exchanger, because a 30-year-old furnace in a pier-and-beam house has been working hard every winter. If the exchanger is cracked, we stop the job and show you the failure on camera, because that is a carbon monoxide risk, not a repair. Every furnace repair in Kennedale carries the 365-Day Done Right Promise: if the fix does not hold, we return at no charge.
What happens when you call
- 1
A real person answersNo phone trees - you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Brands We Service in Kennedale
Our technicians are factory-trained to service Trane, Lennox, Goodman, and Rheem, among other major residential brands. We keep common parts on the truck, which means we can complete most repairs in one visit instead of coming back a week later. See our brands for the full list.
Pricing for HVAC Company in Kennedale, TX
| Service | Typical range in Kennedale |
|---|---|
| AC repair (minor: capacitor, contactor, drain line) | $150 – $350 |
| AC repair (major: blower motor, fan motor, control board) | $350 – $650 |
| Furnace repair (minor: igniter, flame sensor, pressure switch) | $150 – $350 |
| Furnace repair (major: blower motor, gas valve, inducer motor) | $350 – $700 |
| AC installation (full system, standard efficiency) | $3,500 – $5,500 |
| AC installation (full system, high efficiency) | $5,500 – $7,500 |
| Tune-up (AC or furnace, one system) | $80 – $200 |
What pushes a Kennedale job toward the top of any range is usually access: a furnace in a tight attic off a ladder, a condenser squeezed into a side yard with a fence six inches away, or a home that needs duct repairs before the new equipment can breathe. Whatever the job, the price is on paper before we start, and we do not change it at the door.
Neighborhoods We Serve in Kennedale
We run calls across the whole city, from the original neighborhoods near Kennedale Parkway to the newer subdivisions off New Hope Road and the homes along Mansfield Cardinal Road. Our typical response time in Kennedale is same-day for emergency repair calls, and we schedule installations at a set time that works for you.
- Kennedale Parkway corridor
- New Hope Road area
- Mansfield Cardinal Road area
- Sonora Drive and surrounding streets
- Dick Price Road subdivisions
Service Area – Cities Near Kennedale
Dalton Heating & Air serves Kennedale, TX and the surrounding Tarrant County communities. If you’re just over the city line, we run calls in Arlington, WA, Mansfield, TX, Burleson, TX, and Fort Worth, TX. Dispatch and scheduling are coordinated from our Dallas-Fort Worth office, and crews serve Kennedale locally every day.
Serving Kennedale, TX - Our Local Coverage Area
We’re based in the Kennedale area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs About HVAC Company in Kennedale
For emergency AC or furnace repair in Kennedale, we aim for same-day response, often within a few hours. We answer the phone 24/7 with a live person, so you know a real technician is on the way. Call (361) 306-9515 when the system fails and we’ll give you a window right then.
Component-level repairs like a capacitor, contactor, or igniter do not require a permit in Kennedale. Full system replacements and heat pump installations do, and we pull the permit as part of the job. You’ll see the permit posted before the work starts, not after it’s done.
Yes. Some Kennedale subdivisions have architectural guidelines about where a condenser can sit or what a heat pump looks like from the street. We check the relevant HOA rules before we propose an installation location, so the job passes the board review the first time.
What happens when you call
- 1A real person answersNo phone trees - talk to a local hvac pro.
- 2You get an upfront price rangeHonest numbers before anyone is dispatched. No surprises.
- 3We come out and measureLicensed & insured, at a time that suits you - the visit and the quote are both free.
- 4You get the price in writingLine-itemed, yours to keep, and nothing starts until you say go.
What Kennedale Customers Say
"Changed the filter size and added a better filter rack. Simple and useful advice."
- Rhonda C."Honest, direct people. Told me what the furnace needed and nothing more, and the bill matched."
- Eliza S."Coil cleaning and a refrigerant check before summer. AC has never been this cold."
- Marty D.