Seasonal tune-up and full diagnostic on your Carrier, Trane, or Goodman system - readings shown to you before any repair is proposed
Diagnosis first, numbers second - you approve the repair price before a single part goes in.
Before
After
Before
After
Before
AfterFast, Reliable Heat Pump Installation Across Somerset
Heat pump installation in Somerset typically runs $3,500 – $7,500 for a full system replacement, and most jobs are scheduled within a week once the load calculation is done. We serve the entire Somerset area, from the neighborhoods off Somerset Road to the newer developments around the school district. Dalton Heating & Air sends background-checked, uniformed technicians who put the full price in writing before any work starts. Call (361) 306-9515 for a free estimate on a properly sized heat pump for your home.
Why Dalton Heating & Air Is Somerset’s Preferred Heat Pump Installation Company
Somerset homeowners keep calling us for a reason: we do the load calculation first, not after the check clears. That matters more here than almost anywhere else in the region, because mild winters and long cooling seasons punish oversized equipment in ways other climates never reveal. A system that’s too big short-cycles, never gets the humidity out, and runs up your bill while wearing itself out early. We measure the house, the ducts, and the windows, then match the tonnage to the actual load, not to whatever the builder put in 15 years ago.
Marco Benitez leads our team, and he holds every tech to The Garrison Standard: arrive inside the stated window, price in writing before starting, do the job by the book, leave the site clean, and stand behind the work for a full year. That’s the 365-Day Done Right Promise. If it’s not done right, we make it right. Somerset customers also get a written guarantee on every repair, with a free second visit if the work doesn’t hold.
We answer the phone 24/7 with a live person, not a voicemail queue. Dispatch and scheduling are coordinated from our San Antonio office, and crews serve Somerset locally. When you call at 2 p.m. on a Friday in July and your heat pump’s dead, you’ll talk to a real person who can tell you when a tech rolls.
Ductless Heat Pump Installation in Somerset
Ductless Heat Pump Installation in Somerset solves a problem a lot of older homes here share: rooms that never get comfortable no matter what the thermostat says. The ranch houses and brick homes built around Somerset in the 1980s and 1990s often had one central system stretched across the whole footprint, with undersized or leaky duct runs to the far bedrooms. A ductless mini split heat pump puts a quiet indoor unit on the wall or ceiling of that problem room, with a small outdoor condenser connected by a slim line set. No new ductwork, no tearing out drywall. For Somerset rooms that run 8 – 10 degrees warmer than the rest of the house in August, a ductless unit is usually the straightest fix.
A single-zone ductless heat pump installation in Somerset falls inside our $3,500 – $7,500 range depending on capacity and the run length between indoor and outdoor units. We give a written fixed price before any equipment is ordered.
Single-Zone Mini Split for Additions and Garages
Finished-out garages and room additions rarely have ductwork tied to the main system. A single-zone mini split handles those spaces without overloading the existing unit. We size it from the room’s square footage and sun exposure, then set the condensate and refrigerant lines up to code.
Multi-Zone Ductless for Whole-Home Comfort
If three or four rooms in your Somerset house never cool right, a multi-zone ductless system can serve them all from one outdoor condenser. You get independent temperature control per room. That tends to cut the fighting over the thermostat down to zero.
Heat Pump Service in Somerset
Heat Pump Service in Somerset covers the routine work that keeps a heat pump alive through a 100-degree August and a rare freeze that actually matters. Because these systems run in cooling mode most of the year around here, the outdoor coil picks up cottonwood fuzz, dust from the caliche roads, and the usual South Texas grime faster than a heat pump in Dallas ever would. A clogged coil drags efficiency down and makes the compressor run hot. Our tune-ups run $80 – $200 and include cleaning the coils, checking refrigerant charge, testing the reversing valve, and verifying the defrost controls actually work.
Repairs on heat pumps in Somerset run $150 – $650 depending on the part. A failed capacitor is on the low end. A reversing valve or defrost board is on the higher end. Every repair includes a written guarantee, and if it fails within the year, we come back at no charge.
Annual Heat Pump Tune-Up
One visit a year catches most failures before they become no-cooling emergencies. We do the full checklist and hand you a written report of what we found, what it means, and what it costs to fix. Our techs are paid on doing the job right, not on what they sell.
Emergency Heat Pump Repair
When a heat pump dies during a heat wave, it’s a health risk, not just an inconvenience. We treat those calls as emergencies and send a tech to Somerset as fast as the schedule allows. Call (361) 306-9515 and a live person answers, day or night.
Trusted Brands We Service in Somerset
Our techs are factory-trained to service nine major residential HVAC brands, including Trane, Lennox, Goodman, and Rheem. That matters in Somerset because a lot of the existing equipment out here is builder-grade Goodman or older Trane from the 2000s, and you want a tech who knows the common failure points on both without trial and error. We keep common parts stocked for these brands so a capacitor or contactor swap doesn’t turn into a two-day wait. Whether you need a full system replacement or just honest heat pump service, we’ll get your exact brand and model right the first time.
Common Heat Pump Installation Problems We See in Somerset Homes
- Oversized systems that short-cycle. Somerset sits in South Texas where mild winters and long cooling seasons mean heat pumps run in cooling mode the vast majority of the year. Sales-driven installs that skip the load calculation routinely put in more tons than the house needs, and the result is a unit that kicks on and off every few minutes, never dehumidifies, and fails years early. A room-by-room load calculation is the only way to get the tonnage right.
- Builder-grade duct systems starving the coil. A lot of Somerset homes built in the last 25 years have flex-duct runs that are undersized or pinched. High static pressure reduces airflow across the evaporator coil, which tanks the effective efficiency and drags down SEER2 performance below what the condenser is rated for. The fix is duct inspection and sometimes sealing or replacing runs, not a bigger unit.
- Heat-pump-specific controls ignored on install. The reversing valve, defrost controls, and aux heat lockout settings are heat-pump-specific parts that generic installers often skip. When they’re not set right, the system flips into electric strip heat when it shouldn’t, or fails to defrost during the couple of cold mornings Somerset gets each winter. Within two years, the homeowner thinks they bought a lemon when the real problem was a rushed install.
- Old condenser pads sinking into South Texas soil. The clay-heavy soil around Somerset shifts with wet and dry cycles. We regularly see outdoor heat pump units tilted or half-sunk because the original pad wasn’t leveled properly. A tilted unit strains the compressor and can pull refrigerant lines out of alignment. We re-pad and level every condenser we touch.
A homeowner near Somerset ISD called us after a Trane unit in a 2,600 sq ft ranch kept short-cycling in July. After a room-by-room load calculation showed the builder had installed a 3.5-ton unit when 2.5 tons of capacity was correct, we replaced the system with a 2.5-ton Carrier variable-speed heat pump, and their supply-air temperature drop went from 8°F to a normal 18 – 20°F. That’s the difference a real load calculation makes in this climate.
Pricing for Heat Pump Installation in Somerset, TX
Here’s what our customers in Somerset actually pay, in writing, before any work begins:
| Service | Price Range |
|---|---|
| AC Installation (heat pump system replacement) | $3,500 – $7,500 |
| AC Repair (heat pump) | $150 – $650 |
| Tune-Up (heat pump) | $80 – $200 |
A full heat pump replacement in Somerset ranges from $3,500 for a basic single-stage unit in a smaller home to $7,500 for a variable-speed system with better humidity control and lower running costs. The main variables are tonnage, efficiency level, and whether your ductwork needs work before the new system goes in. We don’t charge for the estimate, and the price we quote is the price you pay. Call (361) 306-9515 to schedule a load calculation and get a fixed written quote.
We Also Serve Cities Near Somerset
Dalton Heating & Air provides Heat Pump Installation for homes throughout the Somerset area and nearby communities. Our crews work regularly in Lytle, San Antonio, Helotes, and Converse. If you’re in one of those cities and need Heat Pump Installation in Somerset level service at your address, call us and we’ll get you scheduled.
Serving Somerset, TX - Our Local Coverage Area
We’re based in the Somerset area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs About Heat Pump Installation in Somerset
Yes, you need one, and matching the old tonnage is the single most common install mistake we see in Somerset. Builder-grade systems are routinely oversized because the original installer guessed or copied a floor plan from another house. In Somerset’s climate, where the heat pump runs in cooling mode most of the year, an oversized unit short-cycles, leaves the house humid, and burns out the compressor early. A room-by-room load calculation takes window size, insulation, ceiling height, and orientation into account. We won’t install a system without one. Call (361) 306-9515 to get your load calculation scheduled as part of a free estimate.
In most Somerset cases, replacing makes more sense than repairing at that age. A compressor replacement on a 12-year-old heat pump typically runs toward the top of our $150 – $650 repair range for labor and parts, but you’re putting a new heart into a system whose coils, reversing valve, and electronics are all the same age. A new heat pump installation runs $3,500 – $7,500, and at 12 years you’re usually inside the window where the efficiency gain on your electric bill helps offset the cost. We’ll give you written numbers for both options and let you decide. Call (361) 306-9515 and we’ll send a tech to assess the system honestly.
SEER2 is the updated efficiency rating that reflects real-world installed conditions, including the higher static pressure from typical ductwork. The higher the number, the less electricity the system uses per unit of cooling. In Somerset, where cooling season runs from March through October, the difference between a 14 SEER2 and a 17 SEER2 system can be a meaningful cut to your summer electric bill. But a high SEER2 rating is worthless if the ducts are starved or the system is oversized. That’s why we check the ducts and do the load calculation before we talk efficiency numbers.
Yes, and it’s often the best fix for the problem room in an older Somerset house. A ductless mini split heat pump installation typically falls within our $3,500 – $7,500 range, depending on capacity and line-set run. These units don’t need ductwork, so they work well for rooms the central system never reached, like a converted garage, a western-facing bedroom, or an addition. We size the unit to the room and install it with a written fixed price. Call (361) 306-9515 for a free estimate on a ductless system for your home.
A proper heat pump tune-up in Somerset should clean the outdoor coil thoroughly, check the refrigerant charge, test the reversing valve and defrost controls, inspect the aux heat lockout, and measure airflow across the coil. Ours runs $80 – $200 and ends with a written report of what we found. Given how much cottonwood fuzz and caliche dust builds up on outdoor coils around here, an annual cleaning makes a measurable difference in efficiency and lifespan. Call (361) 306-9515 to book your tune-up.
Contact Dalton Heating & Air for Heat Pump Installation in Somerset
If your heat pump is short-cycling, struggling to cool a back bedroom, or ready for replacement, call (361) 306-9515 for a free estimate. A live person answers 24/7, and we’ll schedule a time that works for you. Every Somerset job includes a written price before work begins, a written guarantee on the work, and the 365-Day Done Right Promise: if it’s not done right, we make it right. Marco Benitez and the entire Dalton Heating & Air team are ready to get your home comfortable.
Written by Marco Benitez, Owner at Dalton Heating & Air, serving Somerset, TX.