Seasonal tune-up and full diagnostic on your Carrier, Trane, or Goodman system - readings shown to you before any repair is proposed
Diagnosis first, numbers second - you approve the repair price before a single part goes in.
Before
After
Before
After
Before
AfterFast, Reliable Heat Pump Installation Across Schertz
Heat pump installation in Schertz, TX typically runs $3,500 – $7,500 for a standard split system, and most jobs are completed in one to two days once equipment arrives. The cost depends on system size, ductwork condition, and whether you’re going with a standard split system or a ductless mini split. Heat Pump Installation is a job that rewards getting the sizing right the first time, and that’s where a proper load calculation matters more than most contractors admit. Call (361) 306-9515 for a free, written estimate. We serve Schertz homeowners who want the job done by the book, with the price in writing before we start.
Schertz sits right where the Edwards Plateau gives way to the Gulf Coastal Plain. That’s not a geology lesson to pad a website page, it’s the reason your heat pump cycles between heating and cooling far more often in a single season than a unit 20 miles south. Wider daily temperature swings mean the thermostat’s changeover setup matters as much as the equipment itself. We know that, and we build it into every install we do here.
Why Dalton Heating & Air Is Schertz’s Preferred Heat Pump Installation Company
Homeowners in Schertz call us because they’re tired of no-shows, door-price surprises, and crews that leave a mess. Dalton Heating & Air is a Garrison Partners company operating under The Garrison Standard since 2003. That standard isn’t a slogan. It’s a set of non-negotiable terms on every job: arrive inside the stated window, put the price in writing before starting, do the work by the book, leave the site clean, and stand behind the install for a full year. If it’s not done right, we make it right. That’s the 365-Day Done Right Promise, and it covers every heat pump install we do in Schertz.
Marco Benitez leads our team, and he holds every technician to The Garrison Code on every single call. The technicians who show up at your door are background-checked, uniformed, and factory-trained to service nine major residential HVAC brands, including Trane, Lennox, Goodman, and Rheem. You know who’s coming before they arrive. When you call us, a live person answers, 24 hours a day, 7 days a week. No voicemail queue, no callback window, no wondering if anyone heard the message. That matters when your system quits on a 38-degree Schertz morning.
Schertz customers get a written guarantee on every repair we perform. If the work fails within the guarantee period, we return at no charge. That’s not an upgrade, not an add-on, not a loyalty perk. It’s just how we operate. For Schertz homeowners comparing quotes, ask any other contractor whether their guarantee and their pricing policy are actually written down before the work starts. That’s usually a short conversation.
Geothermal Heat Pump Installation in Schertz
Geothermal Heat Pump Installation in Schertz is a real option for homeowners planning to stay in their home long term and wanting to stop paying for strip heat on cold mornings. A geothermal system uses the ground’s stable temperature, roughly 60 to 70 degrees year-round just below the frost line, instead of pulling heat from outside air. That means the system doesn’t lose capacity when the outdoor temperature drops. On a Schertz winter morning when it’s 32 degrees outside, a geothermal unit keeps producing steady heat without switching on expensive electric resistance backup. The trade-off is the upfront work: drilling or trenching for the ground loop, which adds time and cost to the job.
In Schertz, geothermal makes the most sense on properties with enough yard space for a horizontal loop field, or in homes where the existing ductwork is already in good shape and sized properly. Price-wise, geothermal installations run well above a standard split system, and the exact figure depends on well depth, soil conditions, and loop configuration. What we tell Schertz homeowners is this: geothermal needs to be evaluated on a 15-to-20-year horizon. If you’re staying, the operating savings can justify the front-end cost. If you might move in five years, a high-efficiency air-source heat pump with a proper load calculation is usually the better financial call. Marco and his team can walk you through that math honestly, without a sales pitch attached.
Ground Loop Sizing and Soil Conditions
The soil across Schertz varies, from limestone outcrops near the plateau edge to heavier clay soils on the coastal plain side. That variation affects how much loop you need and how deep it has to go. We size the loop field based on a real heat loss and heat gain calculation for your specific house, not a rule-of-thumb guess. A loop that’s too small will underperform for the life of the system, and you can’t fix that with a thermostat tweak.
Hybrid Geothermal Split Systems
Some Schertz homes use a hybrid setup: a geothermal loop handles most of the heating and cooling load, with a standard air-source heat pump or furnace as backup during extreme peaks. This can reduce loop field size and upfront drilling cost while still cutting operating expense meaningfully. We evaluate whether the hybrid configuration makes sense based on your home’s age, insulation, and existing ductwork before recommending it.
Ductless Heat Pump Installation in Schertz
Ductless Heat Pump Installation in Schertz is a strong fit for older homes that never had central ductwork, for room additions, and for converted garages or workshops. Ductless systems, also called mini splits, pair an outdoor condensing unit with one or more indoor air handlers mounted on the wall or ceiling. Each indoor unit runs its own zone, so you can heat or cool only the rooms you’re actually using. In Schertz, that’s especially useful in spring and fall, when one side of the house can feel stuffy while the other is comfortable.
Ductless installation in Schertz runs $3,500 – $7,500 depending on the number of indoor heads and the run length to the outdoor unit. The work itself is less invasive than a central system install, no duct cutting, no crawlspace work, which means less mess and often a faster completion timeline. The trade-off is aesthetics: some homeowners don’t love the look of a wall-mounted unit. Others find it completely worth it for the zoning control. We stock equipment from major manufacturers and install both single-zone and multi-zone configurations based on what your house actually needs.
Multi-Zone Ductless Layouts
A multi-zone system uses one outdoor unit to drive two to five indoor heads, each with independent temperature control. In Schertz homes with bonus rooms over garages, sunrooms, or converted attics, this solves the classic problem of a room that never quite reaches the same temperature as the rest of the house. The layout planning matters: indoor head placement, refrigerant line routing, and condensate drainage all affect long-term performance.
Single-Zone Ductless for Additions
For a single room addition or a detached office, a one-to-one ductless system often beats the cost and complexity of extending existing ductwork. We size the unit based on the room’s actual load, not floor area alone. A south-facing room with big windows in Schertz needs more cooling capacity than a shaded north-facing room of the same square footage. We account for that.
Trusted Brands We Service in Schertz
We’re factory-trained on Trane, Lennox, Goodman, and Rheem equipment, among others. That training matters when it comes to warranty coverage, proper startup procedures, and diagnosing issues down the road. For Schertz customers, we keep common replacement parts in local stock so a repair doesn’t have to wait on a distribution warehouse. If your system needs a specific part we don’t have on the truck, we can usually source it same-day or next-day. The brand matters less than the install quality, so we don’t push one manufacturer over another. We size and configure whatever equipment fits your home’s actual load and your budget.
Common Heat Pump Installation Problems We See in Schertz Homes
- Oversized systems installed without a load calculation. We see this a lot in Schertz because older homes often got whatever unit the previous contractor had on the truck. On the Coastal Plain side of town, humidity is a real issue, and an oversized unit short-cycles before it ever pulls enough moisture out of the air. The result is a cool house that still feels clammy, plus higher electric bills from all those stop-start cycles.
- Changeover thermostat misconfiguration. In Schertz’s swing seasons, when afternoons hit 75 and nights drop to 45, a heat pump needs a properly set lockout temperature on the thermostat. When that lockout isn’t set, the system fights itself, switching between heating and cooling modes, and the compressor and reversing valve wear out years ahead of schedule. We check this on every install and every tune-up.
- Duct systems sized for an old AC that can’t handle a heat pump’s airflow requirements. Heat pumps need a specific amount of airflow across the indoor coil to work correctly. When the ducts are too small or leaky, the coil starves, the refrigerant charge runs off, and you get lukewarm heat in January and frozen coils in July. In Schertz homes built before duct sealing was common practice, this is a frequent root cause of poor heat pump performance.
- Strip heat wired in as a crutch rather than a backup. Electric resistance strip heat is meant to supplement the heat pump on the coldest days, not to run every time the thermostat calls for heat. When a system is oversized or the changeover settings are wrong, the strip heat kicks on too often, and that’s where Schertz homeowners see runaway winter electric bills. We verify the control wiring and staging sequence so the heat pump does the work it’s designed to do.
Pricing for Heat Pump Installation in Schertz, TX
Here’s what heat pump work actually costs in Schertz, based on the jobs we price in this market:
| Job Type | Typical Price Range in Schertz |
|---|---|
| Heat pump installation (standard split system) | $3,500 – $7,500 |
| Ductless mini split heat pump installation | $3,500 – $7,500 |
| Heat pump repair (capacitor, refrigerant charge, blower motor) | $150 – $650 |
| Heat pump tune-up and thermostat calibration | $80 – $200 |
What moves the install price within that range? Equipment size and efficiency tier, ductwork modifications, electrical upgrades if your panel needs work, and the number of zones for ductless systems. A written quote means you see exactly what you’re paying for before we start. No door-price surprises, no “while we’re here” add-ons you didn’t ask for. Call (361) 306-9515 for a free estimate on your Schertz heat pump installation. We’ll put the number in writing.
We Also Serve Cities Near Schertz
Dalton Heating & Air serves homeowners throughout the Schertz area and surrounding communities. If you’re in Universal City, Cibolo, Converse, or Marion, the same written pricing, same 365-Day Done Right Promise, and same licensed, background-checked technicians apply. Our crews route through the area daily, and dispatch coordinates from the brand’s metro San Antonio office. Call (361) 306-9515 and a live person will get you scheduled.
Serving Schertz, TX - Our Local Coverage Area
We’re based in the Schertz area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs About Heat Pump Installation in Schertz
Yes, you need a load calculation. Matching your old tonnage assumes the old system was sized correctly in the first place, and in Schertz, that assumption is wrong more often than not. A Manual J load calculation measures your home’s actual heating and cooling loads based on square footage, window area and orientation, insulation levels, air leakage, and local climate data. In Schertz, where daily temperature swings are wider than most of metro San Antonio, a correctly sized heat pump runs longer, gentler cycles, uses less strip heat, and controls humidity better. Skipping this step to save an hour of work costs you for the life of the system. Call (361) 306-9515 and ask us to walk you through a load calc on your home. It’s free with any install estimate.
SEER2 is the cooling efficiency rating, and the number tells you how much cooling you get per watt of electricity used. The higher the SEER2, the lower your summer cooling cost per degree of comfort. For Schertz specifically, where August highs routinely hit the upper 90s, moving from an old 13 SEER unit to a modern 16 or 18 SEER2 heat pump can cut cooling season electricity use by 20 to 30 percent. Heating efficiency is rated separately as HSPF2, and that number matters more for your January and February bills. What gets overlooked is that efficiency numbers on paper only hold up if the install is right: proper airflow, proper charge, proper ductwork. A high-SEER2 unit on bad ducts won’t deliver the rated performance. We verify all of it before we leave.
Heat pump heating mode naturally blows cooler air than a gas furnace, typically 85 to 100 degrees at the supply vent, so “lukewarm” is normal when it’s mild outside. The problem starts when the air feels lukewarm on a 40-degree morning. That usually points to low refrigerant, a failing reversing valve, or strip heat not staging correctly. Repair costs in Schertz run $150 – $650 depending on the part. If the unit is 15-plus years old and needs a compressor or coil, replacement is usually the better financial call, and that’s when a new heat pump install at $3,500 – $7,500 starts looking cheaper than repeated repairs on a dying unit. We’ll give you honest repair-versus-replace guidance, with numbers, not a commission-driven pitch.
Schertz is a strong heat pump market. Our winters are mild enough that a heat pump handles most heating days without backup, and our summers are long enough that the cooling efficiency matters more than a furnace’s heating efficiency ever will. The transition climate, where you might run heat in the morning and cooling by afternoon, plays directly to a heat pump’s strength: one system that does both. A furnace and AC also works, and for some homes with existing gas lines, it’s a reasonable choice. But you’re paying for two systems and maintaining two systems when one properly installed heat pump covers the same ground. The exception is homes that lose power frequently in winter; a gas furnace still needs electricity to run the blower, so that’s not really a differentiator. We’ll price both options and let you see the numbers side by side.
Most standard heat pump installations in Schertz take one day. Ductless multi-zone jobs can take one to two days depending on line routing and the number of heads. Geothermal work takes longer, usually several days including loop installation. Before we leave, we verify refrigerant charge by superheat and subcooling, measure supply and return temperatures, confirm airflow at each register, check the changeover thermostat settings for Schertz’s temperature swings, and review the full system operation with you. You get a written summary of what was installed and what we tested. Call (361) 306-9515 to schedule your free estimate.
Get Your Schertz Heat Pump Installation Priced Today
If you’re ready to replace an old system or install a heat pump in a home that doesn’t have one yet, call Dalton Heating & Air at (361) 306-9515. You’ll talk to a live person, get a written price before any work starts, and have a real install date on the calendar. No pressure, no door-price shifts, no half-finished jobs. That’s The Garrison Standard, and we’ve held to it since 2003.
Written by Marco Benitez, Owner at Dalton Heating & Air, serving Schertz homeowners with written pricing and the 365-Day Done Right Promise.