Seasonal tune-up and full diagnostic on your Carrier, Trane, or Goodman system - readings shown to you before any repair is proposed
Diagnosis first, numbers second - you approve the repair price before a single part goes in.
Before
After
Before
After
Before
AfterHVAC Company in Texas City, TX
Dalton Heating & Air handles HVAC work across Texas City with written pricing before any job starts, a one-year written guarantee on repairs, and technicians who show up inside the window we set. Texas City’s mix of mid-century brick homes, newer construction near the bay, and older pier-and-beam houses means no two calls are the same – but the standard is. If your AC quits in August or your furnace won’t fire on the first cold morning, call (361) 306-9515 and a live person answers, day or night.
Why Texas City Homes Are Different
Texas City sits on Galveston Bay, and that location shapes HVAC work in ways that don’t show up in a spec sheet. Salt air moves through condenser coils faster than it does ten miles inland. We regularly find coil corrosion on systems in the Bay Street and Skyline Terrace areas that would still look clean in a drier part of the county. Homeowners here should expect to replace outdoor units sooner than the national average, and should plan for it.
Housing stock varies block by block. The older neighborhoods off Texas Avenue and 6th Street hold brick ranches from the 1950s and 60s, many still running original ductwork sized for a different heat load. New construction near Moses Lake and off Palmer Highway uses tighter envelopes and higher-efficiency equipment, which changes how we approach both repair and replacement. Crawlspace access under pier-and-beam homes means ductwork inspections matter more here than in slab-on-grade suburbs.
Humidity is the real driver. A system that cools but doesn’t dehumidify leaves a Texas City house feeling sticky and breeding mold inside walls. Sizing matters, and so does the condition of the evaporator coil and drain line. We see more clogged drains and wet insulation in this city than almost anywhere else we work.
Our Main Texas City Services
Two calls dominate our Texas City schedule: cooling failures during the long hot season, and heat pump replacements where homeowners want one system for both sides of the year. Here is what each job involves here.
AC Repair in Texas City
Most AC failures in Texas City come down to one of three things: a capacitor that gave out, a condenser coil choked with salt and grass, or a refrigerant charge low enough that the system can’t pull heat out of the house. We diagnose in that order because that’s what the local failure pattern says. Coastal corrosion and long runtimes in July and August push systems hard. If your unit is blowing warm or short-cycling, we get a technician out, put the written diagnosis in your hand, and let you decide. See the full breakdown on our AC Repair in Texas City page.
Heat Pump Installation in Texas City
Heat pumps earn their keep in Texas City because our winters are mild enough for them to run efficiently and our summers demand serious cooling. A properly sized heat pump with the right dehumidification settings handles both. Coastal air means we recommend coating options and coil protection on outdoor units, and we explain exactly what that costs before any equipment is ordered. If you’re weighing a replacement, see Heat Pump Installation in Texas City for equipment options and the installation process.
Furnace Repair in Texas City
Furnaces here don’t get the workout they do upstate, but they fail in specific ways: igniters crack, flame sensors soot over, and gas valves stick after months of disuse. We also see rust on controls from the same bay humidity that eats AC coils. When the first real cold front hits and your furnace won’t light, the priority is getting heat on fast and safely. Our Furnace Repair in Texas City page covers common failure points and typical pricing.
What happens when you call
- 1
A real person answersNo phone trees - you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Brands We Service in Texas City
We’re factory-trained on nine residential brands, and the ones we see most in Texas City are Trane, Lennox, Goodman, and Rheem. Our vans carry common capacitors, contactors, igniters, and flame sensors for these units, which means many repairs finish the same visit. For the full brand list, see our brands.
Pricing for HVAC Company in Texas City, TX
| Service | Typical range in Texas City |
|---|---|
| AC repair (general) | $150 – $650 |
| Furnace repair (general) | $150 – $700 |
| AC installation | $3,500 – $7,500 |
| Seasonal tune-up | $80 – $200 |
Coastal corrosion and the age of Texas City’s older housing stock push repair prices toward the upper end of those ranges, especially when a condenser coil or heat exchanger is involved. Whatever the number, you get it in writing before we start. No door-price changes, no surprise fees after the fact.
Neighborhoods We Serve in Texas City
We cover the full Texas City footprint, from the older blocks near the refineries to the lake-adjacent subdivisions. Response time across the city is typically same-day for repair calls, and we schedule installations in a fixed window.
- Skyline Terrace
- Bay Street area
- Moses Lake
- Palmer Highway corridor
- West Texas City
Service Area – Cities Near Texas City
Dalton Heating & Air also runs calls in the surrounding communities. If you’re in La Marque, TX, Hitchcock, TX, Dickinson, TX, or Bacliff, TX, we cover those areas with the same written pricing and one-year repair guarantee.
Serving Texas City, TX - Our Local Coverage Area
We’re based in the Texas City area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs About HVAC Company in Texas City
Same-day in almost all cases for repairs. We dispatch from the Houston office, and our Texas City routes are staffed every weekday and through the weekend. Emergency cooling and heating calls get priority, and a live person answers the phone at (361) 306-9515 any hour.
Yes, most full system replacements in Texas City need a city permit. We pull it as part of the job and the cost is itemized on your written quote – no added surprises at inspection time. Repairs and tune-ups typically don’t require permits.
No. Our rate sheet doesn’t change based on the clock. Emergency calls after hours cost the same as a Tuesday morning visit. You get the written price before work starts, every time, no exceptions.
If you’re in Texas City and your system isn’t doing its job, call Dalton Heating & Air at (361) 306-9515. We’ll put the price in writing, show up when we say, and stand behind the repair for a full year. Marco Benitez and the Texas City crew are ready.
What happens when you call
- 1A real person answersNo phone trees - talk to a local hvac pro.
- 2You get an upfront price rangeHonest numbers before anyone is dispatched. No surprises.
- 3We come out and measureLicensed & insured, at a time that suits you - the visit and the quote are both free.
- 4You get the price in writingLine-itemed, yours to keep, and nothing starts until you say go.
What Texas City Customers Say
"Coil cleaning and a refrigerant check before summer. AC has never been this cold."
- Marty D."Good communication, tidy, and disciplined work. Taped off the floor and wiped the unit down."
- Karen J."Installed a heat pump to replace an old oil furnace. Three clear quotes and the install crew was tidy."
- Cheryl B.