Seasonal tune-up and full diagnostic on your Carrier, Trane, or Goodman system - readings shown to you before any repair is proposed
Diagnosis first, numbers second - you approve the repair price before a single part goes in.
Before
After
Before
After
Before
AfterHVAC Company in Liberty Hill, TX
Dalton Heating & Air handles heating and cooling work across Liberty Hill, TX, from older ranch homes to the newest builds going up along Highway 29. This page explains what HVAC work costs here, what local conditions change about the job, and which neighborhoods we cover. It’s the starting point if you live in Liberty Hill and want straight answers before you pick up the phone. For the three services homeowners call us about most, each has its own dedicated page linked below. Need someone now? Call (361) 306-9515 and a live person answers.
Why Liberty Hill Homes Are Different
Liberty Hill sits on the northeast edge of the Texas Hill Country, which means two things for HVAC equipment: limestone shelf under the soil and long cooling seasons that push systems harder than the annual runtime most manufacturers plan for. Newer developments around Ronald Reagan Boulevard and Highway 29 are mostly slab foundations with the outdoor condenser unit set close to the house. That placement is fine until a system needs a compressor swap or a coil cleaning, and then clearance and drainage matter in ways they do not in flatter parts of Williamson County.
We also see a lot of split systems in Liberty Hill where the air handler is in the attic. Attic heat in a Texas summer can hit 130°F, which means the ductwork and the evaporator coil are working in conditions that shorten their useful life. Older homes off CR 200 and County Road 279 tend to have electric furnaces paired with an aging AC, while newer builds in Santa Rita Ranch and MorningStar often run a heat pump or a high-efficiency AC with a gas furnace. That mix means no two Liberty Hill jobs are exactly the same, and a generic checklist approach fails here.
Our Main Liberty Hill Services
These are the three jobs Liberty Hill homeowners call Dalton Heating & Air about most. Each has its own page with pricing, common failures, and what a repair or install actually involves.
AC Repair in Liberty Hill
When a Liberty Hill AC stops cooling in July, the problem is usually one of three things: a failed capacitor, a refrigerant leak at a braze joint, or a condenser fan motor that has seized. We diagnose the specific fault, put the repair price in writing before any work begins, and stock common parts for Goodman, Rheem, York, and Daikin systems on the truck. If the repair fails within a year, we return at no charge under the 365-Day Done Right Promise. Full detail is on the AC Repair in Liberty Hill page.
Heat Pump Installation in Liberty Hill
Heat pumps are becoming the standard choice in Liberty Hill because they cool and heat from the same unit, which suits our mild winters and long summers. Installation involves a load calculation on the home, not a guess based on square footage alone, then setting the outdoor unit on a pad with enough clearance for service. We install heat pumps from the brands we service and give a written price before any equipment is ordered. Read specifics at Heat Pump Installation in Liberty Hill.
Furnace Repair in Liberty Hill
Although winters are short in Liberty Hill, the cold snaps in January and February are sharp, and an electric furnace failure or a gas furnace with a bad ignitor gets uncomfortable fast. We repair both electric and gas furnaces, check the heat exchanger on gas units as a matter of course, and put every repair in writing before the first part comes off. Most furnace repairs run $150 – $450 depending on the part. Details and pricing are on Furnace Repair in Liberty Hill.
What happens when you call
- 1
A real person answersNo phone trees - you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Brands We Service in Liberty Hill
Dalton Heating & Air is factory-trained to service nine major residential brands, and in Liberty Hill that most often means Goodman, Rheem, York, and Daikin systems. We carry common parts for these brands on the truck, which gets most repairs done in one visit. See our brands for the full list.
Pricing for HVAC Company in Liberty Hill, TX
| Service | Typical Range in Liberty Hill |
|---|---|
| AC repair (electrical or control failure) | $150 – $400 |
| AC repair (refrigerant leak or coil work) | $400 – $650 |
| Furnace repair (ignitor, flame sensor, limit switch) | $150 – $400 |
| Furnace repair (blower motor or control board) | $350 – $700 |
| AC installation (single-stage, mid-efficiency) | $3,500 – $5,500 |
| AC installation (high-efficiency or two-stage) | $5,500 – $7,500 |
| Heat pump installation (mid-efficiency) | $3,500 – $5,500 |
| Heat pump installation (high-efficiency) | $5,500 – $7,500 |
| Seasonal tune-up | $80 – $200 |
Attic air handlers and longer duct runs push Liberty Hill installs toward the upper end of those ranges. Whatever the job, Dalton puts the price in writing before any work starts, so the number you see on the estimate is the number you pay.
Neighborhoods We Serve in Liberty Hill
We cover the whole Liberty Hill area, including the newer master-planned communities and the older county-road pockets where homes are more spread out. Our typical response time in the Liberty Hill area is same-day for emergency calls made before noon.
- Santa Rita Ranch
- MorningStar
- Sundance Ranch
- Legacy Ranch
- Areas along CR 200 and CR 279
Service Area – Cities Near Liberty Hill
Along with Liberty Hill, Dalton Heating & Air schedules work in the surrounding communities. Homeowners in Leander, TX, Cedar Park, TX, and Florence, TX can book by phone and get the same written pricing and guarantee. We also serve Georgetown, CT through our network.
Serving Liberty Hill, TX - Our Local Coverage Area
We’re based in the Liberty Hill area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs About HVAC Company in Liberty Hill
Same-day service is available in Liberty Hill for calls made before noon, and emergency calls are answered live 24/7. Our dispatch is coordinated from the Dallas-Fort Worth office, but the crews and trucks serving Liberty Hill are local to this area. Call (361) 306-9515 and we’ll give you a real arrival window.
Some Liberty Hill communities, especially the larger planned neighborhoods like Santa Rita Ranch, require outdoor condenser units to be screened or placed out of direct street view. We review HOA requirements on any install and make sure the placement meets those rules before we set the pad. Repair work almost never needs HOA approval.
No overtime surcharge on emergency calls. The price is written before any work starts, and it stays the same whether the call comes in at 2 p.m. or 2 a.m. That is part of The Garrison Standard, not an add-on. If the repair fails within a year, we return free.
For a straight answer and a written price, call Dalton Heating & Air at (361) 306-9515. We answer live, show up inside the window, and stand behind the work for a full year.
What happens when you call
- 1A real person answersNo phone trees - talk to a local hvac pro.
- 2You get an upfront price rangeHonest numbers before anyone is dispatched. No surprises.
- 3We come out and measureLicensed & insured, at a time that suits you - the visit and the quote are both free.
- 4You get the price in writingLine-itemed, yours to keep, and nothing starts until you say go.
What Liberty Hill Customers Say
"Blower motor died on the coldest night. They had the part on the truck and had us warm again the same day."
- Sandy G."Changed the filter size and added a better filter rack. Simple and useful advice."
- Rhonda C."Honest, direct people. Told me what the furnace needed and nothing more, and the bill matched."
- Eliza S.