Seasonal tune-up and full diagnostic on your Carrier, Trane, or Goodman system - readings shown to you before any repair is proposed
Diagnosis first, numbers second - you approve the repair price before a single part goes in.
Before
After
Before
After
Before
AfterHow Much Does HVAC Cost in Arlington?
HVAC costs in Arlington run $80 – $200 for a tune-up, $150 – $650 for most AC repairs, $150 – $700 for furnace repairs, and $3,500 – $7,500 for a full AC installation. A standard repair call is usually finished the same day, and you’ll have the price in writing before any work starts.
What you pay depends on the part, the age of the system, and how hard it is to reach the equipment. Texas summers push HVAC gear harder than almost anywhere in the country, and that wear shows up on the invoice. Below are the ranges we actually see across Arlington, from north side neighborhoods like Viridian and Interlochen to older housing near UTA and downtown.
Dalton Heating & Air is a Garrison Partners company that’s been operating under The Garrison Standard since 2003. That means written pricing, background-checked technicians in uniform, and a full-year written guarantee on every repair. No shifting numbers at the door.
HVAC Cost Breakdown (2026)
Here’s what the work costs in Arlington this year. These ranges hold whether you’re in a 1980s ranch house off Collins Street or a newer build near the Arlington Highlands.
| Service | Typical Price Range | Notes |
|---|---|---|
| AC Repair | $150 – $650 | Most common: capacitor, contactor, blower motor |
| Furnace Repair | $150 – $700 | Ignitor, flame sensor, inducer motor, board |
| AC Installation (full system) | $3,500 – $7,500 | Depends on tonnage, SEER2 rating, and ductwork |
| Tune-Up / Maintenance | $80 – $200 | Coil cleaning, refrigerant check, electrical inspection |
| Refrigerant Recharge | $200 – $500 | Priced per pound of R-410A or R-32 |
| Blower Motor Replacement | $350 – $650 | Part plus labor, most residential units |
| Compressor Replacement | $900 – $1,800 | Often worth pricing against a new system |
| Ductwork Repair | $300 – $1,200 | Sealing, patching, or replacing runs |
| Thermostat Replacement | $150 – $400 | Basic to smart thermostat, includes install |
A few things move these numbers. System tonnage is one. A 2-ton unit costs less to service and replace than a 5-ton. Refrigerant type is another. Older R-22 systems sit at the high end for a recharge because the refrigerant is phased out and costly. Access matters too, and it’s a real factor in Arlington. Attic-mounted air handlers in single-story homes on slabs are common here, and when the attic is a 140-degree box by noon, the labor time goes up. Ductwork condition rounds it out. Old, leaky ducts in a house built before 1990 will often add to the ticket.
The number one thing that keeps the bill predictable is getting the price in writing before anyone touches the system. That’s standard on every Dalton job, and it’s part of what you should read about in the home page on how we operate.
What Affects HVAC Pricing in Arlington
Arlington sits in a climate zone that punishes HVAC equipment. Long cooling seasons, mild but real winters, and clay soil that shifts foundations (and ductwork with it) all play into what you’ll pay. Six factors drive the spread:
- System age and efficiency. A 15-year-old unit on its way out costs more to repair each time. Once repairs pass roughly half the cost of replacement, we’ll usually tell you straight: put the money toward a new system instead. The trade word for that tipping point is the “repair-versus-replace threshold,” and it’s the deciding line on most big calls.
- Part availability and brand. Dalton is factory-trained to service nine major residential brands: Carrier, Trane, Lennox, Goodman, Rheem, York, Daikin, Bryant, and American Standard. Parts for any of these are usually on the truck or sourced same-day. Off-brand equipment can take longer, and time is labor.
- Refrigerant type. R-410A systems are everywhere in Arlington, but newer units use R-32 and older ones still hold R-22. Each has a different price per pound, which is why two identical-sounding recharges can come in $100 apart.
- Season and demand. A dead AC in July gets attention faster than a sluggish furnace in October. Emergency calls in the peak of the cooling season carry a higher labor rate because the schedule is tight and the techs are working longer days.
- Ductwork and attic access. Much of Arlington’s housing stock is slab-on-grade with attic ductwork. If the run is pinched, poorly insulated, or sitting under a low roof deck, setup and access push labor up.
- Permits and code. A full system replacement in Arlington typically requires a permit and inspection, and changeouts must meet current efficiency and electrical code. That paperwork is baked into installation pricing, not tacked on after.
How to Save on HVAC
You don’t save by chasing the lowest bid. The cheapest quote usually comes with the shortest guarantee and the longest wait for a callback. You save by staying ahead of the failure, and by getting the price locked in writing.
- Tune up twice a year. An $80 – $200 tune-up in spring and fall catches a weak capacitor or a dirty coil before it becomes a $650 repair. It’s the single best dollar-for-dollar move on this list.
- Change the filter. A clogged filter starves the blower motor and freezes the coil. Swap it every 1 – 3 months. Free, and it prevents real damage.
- Ask for a written price before work starts. On every job, no exceptions. A quote that isn’t in writing isn’t a quote.
- Fix small things early. A $150 capacitor today beats a $900 compressor next summer. Nuisance failures rarely fix themselves.
- Weigh repair against replacement honestly. If the compressor is shot and the system is 15 years old, a $1,800 repair on a unit that’s near the end isn’t a saving.
Estimates are free, and we’ll give you the range before anyone books a visit. Call (361) 306-9515 and the person who answers is a live human, day or night. Know the job, the price, and who’s coming, upfront.
FAQs – HVAC Cost
How much does AC repair cost in Arlington?
Most AC repairs in Arlington run $150 – $650. A capacitor swap sits near the bottom, a blower motor or major component near the top. You’ll get the exact figure in writing before we start, and the repair is guaranteed in writing for a full year. Call (361) 306-9515 for a free estimate.
Is it cheaper to repair or replace my AC?
Repair is cheaper when the fix is under about half the cost of a new system and the unit has years left. Replacement wins when the system is 15+ years old, needs a compressor, or keeps failing. A new AC in Arlington runs $3,500 – $7,500 installed. We’ll price both and let you decide.
How much does a furnace repair cost in Arlington?
Furnace repairs typically cost $150 – $700, depending on the part. An ignitor or flame sensor is on the low end; an inducer motor or control board is higher. North Texas winters are mild but not gentle, and a furnace that quits in January gets same-day attention. Call for a free estimate.
Can you come out the same day?
Often, yes. Live phone support is staffed 24/7, and same-day service is common in the cooling season. If it can’t be today, you’ll get a firm window, and we arrive inside it. Call (361) 306-9515 for a free estimate.
How much should an HVAC tune-up cost in Arlington?
A proper tune-up runs $80 – $200. It covers coil cleaning, a refrigerant level check, electrical inspection, and airflow. Certified technicians do the work here. The price is in writing, and it’s the cheapest way to avoid a bigger repair later.
What brands can Dalton service?
Dalton’s technicians are factory-trained on all nine major residential brands: Carrier, Trane, Lennox, Goodman, Rheem, York, Daikin, Bryant, and American Standard. Parts for these are usually on hand, which keeps labor down. Call (361) 306-9515 for a free estimate.
Dalton Heating & Air is a Garrison Partners company that’s been operating under The Garrison Standard since 2003, led by owner Marco Benitez. Every job carries a written price before work begins, a full-year written guarantee on the repair, and a 365-Day Done Right Promise. If something we fix fails in that window, we come back at no charge. Calls are answered by a live person around the clock. Call (361) 306-9515 for a free estimate and get a written price before anyone starts.
Pricing reflects the Arlington market as of 2026. Dalton Heating & Air offers free estimates – call (361) 306-9515.
Written by Marco Benitez, Owner at Dalton Heating & Air, serving Arlington since 2003.
What Our Customers Say
"Honest, direct people. Told me what the furnace needed and nothing more, and the bill matched."
- Eliza S."Coil cleaning and a refrigerant check before summer. AC has never been this cold."
- Marty D."Good communication, tidy, and disciplined work. Taped off the floor and wiped the unit down."
- Karen J.