Seasonal tune-up and full diagnostic on your Carrier, Trane, or Goodman system - readings shown to you before any repair is proposed
Diagnosis first, numbers second - you approve the repair price before a single part goes in.
Before
After
Before
After
Before
AfterFast, Reliable Heat Pump Installation Across Westwood
Heat pump installation in Westwood typically runs $3,500 – $7,500 for a standard split system, and the job takes one to two days once the equipment arrives. We know Westwood’s homes, we know the blocks, and we know that two houses sitting side by side on the same street can need entirely different heat pump tonnage because one was built in 1925 and the other in 1995. That’s why we run a room-by-room load calculation before any Westwood heat pump goes in. If you need a straight answer on price, sizing, or timing, call us at (361) 306-9515 and we’ll put it in writing.
Why Dalton Heating & Air Is Westwood’s Preferred Heat Pump Installation Company
Westwood homeowners call us because we show up inside the stated window, put the price in writing before any work starts, and stand behind the job for a full year with our 365-Day Done Right Promise. That’s not a special offer; it’s The Garrison Standard we’ve operated under since 2003. Every technician who arrives at your Westwood door is background-checked, uniformed, and factory-trained on nine major brands, including Trane, Lennox, Goodman, and Rheem. We’re part of the Garrison Partners network, which means every location answers to The Garrison Code: arrive on time, price in writing, do the job by the book, leave the site clean, and stand behind the work for a full year.
Marco Benitez leads our team, and his rule is simple: if a heat pump is not sized and installed correctly for the specific house it serves, it will never run right, no matter how much the equipment costs. That’s the discipline Westwood homeowners get from us, and it’s why our customers keep telling their neighbors.
Geothermal Heat Pump Installation in Westwood
Geothermal Heat Pump Installation in Westwood means drilling a ground loop or horizontal loop system on your property and hooking it to a heat pump that pulls stable ground temperature instead of fighting outdoor air. Done right, it cuts heating and cooling costs more than any other system we install, because the ground around Westwood stays around 50°F year-round no matter what the air temperature does. The tradeoff is the upfront cost: a geothermal install in Westwood generally starts at the top of our standard heat pump range and goes up from there, depending on loop depth, soil conditions, and the size of the house. For the right Westwood lot, though, the long-term numbers make sense, especially with federal tax credits still available for geothermal systems.
When a Ground Loop Makes Sense
Westwood lots with enough open yard for horizontal trenches or enough access for vertical drilling are the ones to consider. A 1920s brick home with a small rear yard may not have the space, while a 1990s infill with a wider lot often does. We’ll tell you straight if geothermal is a good fit or if a high-efficiency air-source heat pump is the better use of your money.
What the Install Actually Involves
We coordinate the drilling or trenching, the loop installation, and the indoor heat pump tie-in as one job with a fixed written price. The ground loop itself is the part you’ll never see again; the indoor unit looks much like a standard air-source heat pump. We verify loop pressure, purge air from the lines, and dial in the flow rate before we call the job done.
Ductless Heat Pump Installation in Westwood
Ductless Heat Pump Installation in Westwood is the clean answer for homes where ductwork was never intended to carry heat pump airflow. A lot of Westwood’s pre-war housing was built for radiators, and the ductwork that exists in some 1990s infill runs too small for a modern heat pump’s higher airflow needs. Ductless systems, also called mini-splits, skip ducts entirely: an outdoor condenser pairs with slim indoor heads mounted high on the wall or in the ceiling, each serving a zone. You heat and cool only the rooms you’re using, and you never lose capacity to leaky or undersized ductwork.
Zoning for Older Brick Homes
Westwood’s older houses often have cold rear bedrooms and warm front parlors, and a single thermostat can’t handle both. A ductless system lets you set different temperatures in different zones, which is a real fix for homes with radiators that made the second floor unusable in August. We size each head to its zone, not to the square footage of the whole house.
When Ducts Are the Problem
We see Westwood homes where the ducts are physically intact but too narrow for the airflow a heat pump needs. The result is high static pressure, reduced capacity, and a blower motor that works harder than it should. Ductless systems route around that problem entirely, and the installed cost lands in the same $3,500 – $7,500 range as a standard split system, depending on how many zones you need.
Trusted Brands We Service in Westwood
We install and service heat pumps from Trane, Lennox, and Goodman, and we keep common parts for these brands stocked locally so Westwood customers are not waiting a week for a control board or a reversing valve. Our techs are factory-trained on all three lines plus Rheem, which means we know the specific quirks of each brand’s defrost logic, refrigerant charge specs, and control wiring. When you buy a heat pump from us, you’re not getting whatever’s on the truck; you’re getting a system we back in writing. For Westwood homeowners already running one of these brands, we service it the same way, with a written guarantee on every repair.
Common Heat Pump Installation Problems We See in Westwood Homes
- Oversized units on older brick homes. A Westwood house built in the 1920s with uninsulated walls loses heat fast and gains it fast, which pushes some installers to oversize the heat pump. The oversized unit short-cycles, the compressor wears out years early, and the efficiency numbers on your electric bill never match the brochure. The fix is a Manual J load calculation, not a bigger outdoor unit.
- Reusing old furnace tonnage. We routinely find Westwood heat pumps that were sized off the old furnace’s tonnage, not off the actual heating and cooling load of the house. That leaves the refrigerant charge and blower motor mismatched to the new heat pump, and the system trips on high head pressure. The right tonnage often differs from what was there before.
- Undersized ductwork on 1990s infill. Many Westwood homes built in the 1990s have ducts that were fine for a gas furnace but too small for the higher airflow a heat pump needs. Static pressure goes up, capacity drops, and the system works harder for less output. We measure static pressure and duct sizing before we ever order equipment.
- Shoulder-season short-cycling near Westwood’s older brick blocks. On a recent call, we found a 3-ton heat pump short-cycling because the installer sized it off square footage alone and ignored the home’s leaky envelope. We ran a Manual J load calculation, corrected the tonnage to 2.5, verified static pressure across the evaporator coil and blower motor, and dialed in the refrigerant charge. The homeowner’s winter electric bill dropped and the system stopped tripping on high head pressure.
Pricing for Heat Pump Installation in Westwood, PA
A standard split-system heat pump installation in Westwood lands between $3,500 and $7,500, while a repair or diagnostic visit runs $150 – $650 depending on the part and the fault. A seasonal tune-up with thermostat calibration is $80 – $200. What moves the number on an install is the equipment efficiency tier, the condition of your existing ductwork, whether we’re adding or modifying zones, and whether the home needs electrical upgrades to support the new equipment. We don’t give a verbal guess; we give you a written price before any work starts, and that price is what you pay. Call (361) 306-9515 for a free estimate. Marco Benitez will make sure the quote reflects what your house actually needs, not a generic number from a spreadsheet.
| Service | Typical Westwood Price Range |
|---|---|
| Heat pump installation (standard split system) | $3,500 – $7,500 |
| Heat pump repair / diagnostics | $150 – $650 |
| Seasonal tune-up and thermostat calibration | $80 – $200 |
We Also Serve Cities Near Westwood
Our Westwood crew regularly handles heat pump work in nearby communities. If you’re just outside Westwood but need the same written pricing and full-year guarantee, we serve Westwood plus Philadelphia, Levittown, Norristown, and Chester. Scheduling is coordinated from the brand’s Philadelphia office, and the crew serving Westwood comes from the local area. For full service-area details, see our Heat Pump Installation page.
Serving Westwood, PA - Our Local Coverage Area
We’re based in the Westwood area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs About Heat Pump Installation in Westwood
Yes, and in Westwood specifically, skipping the load calculation is the single most common cause of early heat pump failure we see. Westwood’s housing stock is split between 1920s brick homes with uninsulated walls and 1990s infill with tighter envelopes, so two houses on the same block can need heat pump tonnage that differs by a full ton. A room-by-room Manual J calculation is the only way to get the tonnage, airflow, and refrigerant charge right. Any company that quotes you a heat pump without one is guessing. Call (361) 306-9515 and we’ll run the calculation before any equipment is ordered.
SEER2 is the current federal efficiency measurement for heat pumps in cooling mode; it replaces the old SEER rating and reflects real-world conditions more accurately. For a Westwood homeowner, a higher SEER2 number means lower summer electric bills, but it does not mean the system will run efficiently if it’s oversized or the ducts are wrong. Buy the SEER2 rating that matches your comfort goals and budget, but make sure the installer sizes the system correctly first. We can walk you through the efficiency math on any quote. Call (361) 306-9515.
The honest answer depends on the age of the unit, the compressor’s condition, and whether the system was sized correctly in the first place. A heat pump repair in Westwood typically runs $150 – $650, and if the unit is under 10 years old and the fault is a capacitor, contactor, or control board, repair is usually the right call. If the compressor is failing, the refrigerant is leaking, or the unit was oversized for a leaky brick home and short-cycling for years, replacement may cost less in the long run. A new install in Westwood runs $3,500 – $7,500, and we’ll give you a straight comparison in writing. Call (361) 306-9515 for that comparison; the estimate is free.
Modern cold-climate heat pumps can carry a Westwood home down to well below freezing, but the answer depends on the home’s envelope and the system’s sizing. A 1920s brick house in Westwood with uninsulated walls will lose heat faster than a 1990s infill, and the heat pump has to be sized for the home’s actual heat loss, not the square footage. Many Westwood homes do fine without electric resistance backup; some need a small backup strip for the coldest nights. We’ll tell you which yours is based on the load calculation. Call (361) 306-9515.
A standard split-system heat pump installation in Westwood runs $3,500 – $7,500, with geothermal and multi-zone ductless systems landing at the upper end or beyond depending on scope. The equipment tier, ductwork condition, zoning, and any electrical work all move the number. What you get from us is a written price before any work starts, not an estimate that shifts when the crew arrives. Call (361) 306-9515 and Marco Benitez will give you a fixed quote based on your actual house.
Get a Straight Answer on Your Westwood Heat Pump
If you’re weighing repair against replacement, wondering whether geothermal or ductless makes sense for your home, or just want a real price with no games, we’re here. Dalton Heating & Air serves Westwood with written pricing, background-checked techs, and a full-year guarantee on every job. Calls are answered by a live person 24/7, and we show up inside the window we gave you. Call (361) 306-9515 for a free estimate on heat pump installation in Westwood.
Written by Marco Benitez, Owner at Dalton Heating & Air, serving Westwood, PA.