Seasonal tune-up and full diagnostic on your Carrier, Trane, or Goodman system - readings shown to you before any repair is proposed
Diagnosis first, numbers second - you approve the repair price before a single part goes in.
Before
After
Before
After
Before
AfterFast, Reliable Heat Pump Installation Across Tomball
Heat pump installation in Tomball typically runs $3,500 – $7,500 depending on tonnage, SEER2 rating, and ductwork condition. Most Tomball homeowners get a fixed written price within 24 hours of the estimate, and installs are scheduled on a set date, not a vague window. Dalton Heating & Air serves Tomball from our Houston dispatch office with crews who know the neighborhoods off 2920, Telge Road, and Boudreaux Road. Call (361) 306-9515 and we’ll send someone out to measure the house, run the load calculation, and put the price in writing before you commit to anything.
Why Dalton Heating & Air Is Tomball’s Preferred Heat Pump Installation Company
We don’t guess. A heat pump that gets sized wrong in Tomball short-cycles through February and November when temperatures hover in the 60s and 70s, and the compressor pays for it over time. Our installers run a Manual J load calculation on every job, check the existing ductwork for leaks and sizing, and tell you exactly what the old system was doing right or wrong before we recommend anything.
Dalton Heating & Air is a Garrison Partners company, operating under The Garrison Standard since 2003. That means every Tomball job gets a written price before any work starts, a written guarantee on the repair, and a crew that arrives inside the stated window, background-checked and in uniform. Marco Benitez leads our team, and he holds his people to the Garrison Code: arrive on time, price it in writing, do it by the book, leave the site clean, and stand behind the work for a full year. If something fails in that year, we come back at no charge through the 365-Day Done Right Promise. Tomball homeowners have heard plenty of promises. Ours are written down.
Heat Pump Service in Tomball
Heat Pump Service in Tomball usually means the system runs but doesn’t hold temperature, short-cycles, or makes a noise it didn’t make last season. The job starts with a full diagnostic, not a parts swap. We test the reversing valve, the defrost board, refrigerant pressures, capacitor readings, and airflow before we quote anything. Most heat pump service calls in Tomball run $150 – $650 depending on what we find. The written quote comes before the repair, every time.
Diagnostics First, Not Part Piles
A heat pump is two systems in one. When it cools fine but won’t heat, the problem is rarely the compressor. It’s usually the reversing valve sticking, a defrost board that quit, or a refrigerant charge that drifted after a long Tomball summer. We identify the actual failure and quote the repair, not a list of “might-as-well” upcharges.
Common Tomball-Specific Service Repairs
A failed capacitor on a unit only a few years old is something we see regularly in Tomball’s heat. It’s a cheap fix that gets missed when a homeowner insists the system “kind of” runs. A charge that’s off a few ounces makes the heat pump work harder in both heating and cooling mode, and it shows up as a higher electric bill before it shows up as a breakdown. These are the calls we solve in one visit.
Heat Pump Replacement in Tomball
Heat Pump Replacement in Tomball is the right call when the compressor fails out of warranty, the coil leaks, or the unit is old enough that another repair doesn’t pencil out. A full replacement in Tomball runs $3,500 – $7,500 installed, and the spread depends on tonnage, SEER2 rating, brand, and whether ductwork needs work. We don’t replace a system without running the numbers first.
Repair vs. Replace: The $600 Rule
Take the repair quote and multiply it by the age of the unit in years. If the result is over $3,000, replacement starts making sense. If the compressor is dead on a 12-year-old R-410A system, you’re looking at a repair that costs half of what a new system costs, and the rest of the unit is still 12 years old. We’ll show you the math in writing and let you decide without pressure.
Why Load Calculation Matters Here
Tomball’s climate runs heat pumps in both modes most of the year. The load calculation isn’t just about matching square footage to tonnage. It’s about keeping the system from short-cycling during February and November when the outdoor temperature matches your indoor setpoint. An oversized system cools the air fast, shuts off, turns back on 10 minutes later, and burns through compressors. We size it right the first time.
Trusted Brands We Service in Tomball
We install and service Rheem, York, Daikin, and Bryant heat pumps, along with the other major residential brands. That matters when you need parts. A Tomball homeowner with a 10-year-old York shouldn’t have to wait a week for a defrost board while the family sits in a cold house. We keep common parts stocked for the brands we install so same-week service is actually same-week. Our technicians are factory-trained on nine major brands, including every heat pump brand we recommend in Tomball. When we quote a Rheem or Daikin replacement, we quote it with the features that make sense for a climate where the heat pump runs year-round.
Common Heat Pump Installation Problems We See in Tomball Homes
- Oversized tonnage from the original install. Builders in some Tomball subdivisions matched the AC tonnage to the square footage and never ran a proper load calculation. The result is short-cycling through the long mild springs, compressor strain, and humidity that never quite leaves the air. We correct this on replacements.
- Undersized or leaky ductwork. A new heat pump can’t fix airflow that leaks into the attic. We inspect and measure ductwork on every install. In older Tomball homes near the downtown area off Main Street, duct leakage is often the reason the old system never felt right.
- Wrong refrigerant charge from previous service work. A heat pump that works fine in cooling can fail in heating if the charge is off. Tomball’s hot summers hide a small undercharge until the reversing valve switches in November and the system can’t pull heat. We verify charge as part of every install and every service call.
- Short-cycling during shoulder months. February and November in Tomball produce weeks where the outdoor temperature matches the thermostat setting. An oversized system turns on and off constantly during those months, and homeowners hear it. Proper sizing is the only real fix, and it’s why we won’t skip the load calculation.
Pricing for Heat Pump Installation in Tomball, TX
The installed price of a heat pump in Tomball breaks down like this. Installation labor and materials follow the equipment cost, and the spread between the low and high end of each range depends on the condition of your existing ductwork, the brand you choose, and how much electrical work the air handler needs.
| Service | Tomball Price Range |
|---|---|
| Heat Pump Installation (full system) | $3,500 – $7,500 |
| Heat Pump Service / Repair | $150 – $650 |
| Preventative Tune-Up | $80 – $200 |
Every estimate is free. The price we quote is the price you pay, in writing, before any work starts. Call (361) 306-9515 to schedule an estimate, and we’ll tell you exactly what your home needs and what it costs.
We Also Serve Cities Near Tomball
Dalton Heating & Air installs and services heat pumps across Tomball and the surrounding areas, including Pinehurst, Magnolia, Spring, and Katy. Our Houston dispatch coordinates crews locally, so response times don’t stretch just because you’re a few miles outside the city center.
Serving Tomball, TX - Our Local Coverage Area
We’re based in the Tomball area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs About Heat Pump Installation in Tomball
Yes, you need one, and matching the old tonnage is exactly how oversized systems get installed in the first place. A Manual J load calculation measures your home’s insulation, window orientation, duct leakage, and the specific load Tomball’s climate puts on the system. At a house off Holderrieth Road, our tech found a 3-ton Carrier heat pump short-cycling every 10 minutes on a 72-degree day because the load calculation called for 2.5 tons, and the original install was oversized. We dropped the tonnage, dialed in the refrigerant charge and thermostat calibration, and the system held a steady temperature without the constant on-off that had the homeowner worried the compressor was dying. Call (361) 306-9515 to schedule a load calculation and get the real number for your house.
A higher SEER2 rating means the heat pump produces more heating or cooling output per unit of electricity, which translates directly to a lower electric bill in Tomball’s year-round heat pump climate. The payback depends on how much you run the system. In Tomball, where heat pumps run in both modes most of the year, a jump from a 14 SEER2 to a 17 SEER2 system typically cuts the cooling and heating portion of the bill by 15 – 20%, and the savings are larger in August and January when the system runs hardest. We’ll show you the efficiency math on your actual usage before you choose a system.
Multiply the repair quote by the age of the unit in years. If the number is under $3,000, repair usually makes sense. If it’s over, replacement starts looking better because you’re buying time on a system that has already aged past its design life. A dead compressor on a 12-year-old heat pump in Tomball usually points to replacement. A failed capacitor on a four-year-old unit is a $150 – $400 repair and the system likely has years left. We’ll quote both options honestly and let the numbers do the talking.
Short-cycling during Tomball’s mild February and November weeks almost always means the system is oversized for the home, which is why matching the old tonnage without a load calculation is a mistake. When the outdoor temperature is close to your indoor setpoint, an oversized heat pump hits the target fast, shuts off, and then cycles back on minutes later. The compressor wears out from constant starts, and the humidity never gets removed because the system doesn’t run long enough. The fix is proper sizing, which is exactly why we run the load calculation on every new install. Call (361) 306-9515 and we’ll diagnose the cause.
Yes. Our technicians are factory-trained on nine major residential HVAC brands, including Rheem, York, Daikin, and Bryant, along with Carrier, Trane, Lennox, Goodman, and American Standard. That training means we diagnose the specific failure instead of guessing, and we keep common parts stocked for the brands we install. Call (361) 306-9515 and we’ll tell you what you’re working with.
Written by Marco Benitez, Owner at Dalton Heating & Air, serving Tomball and the surrounding areas.