Seasonal tune-up and full diagnostic on your Carrier, Trane, or Goodman system - readings shown to you before any repair is proposed
Diagnosis first, numbers second - you approve the repair price before a single part goes in.
Before
After
Before
After
Before
AfterFast, Reliable Heat Pump Installation Across Roswell
A heat pump installation in Roswell runs $3,500 – $7,500 for a standard split system, with the load calculation included and the price written before any work starts. Most replacements take one full day, and we service every major residential brand including Rheem, York, Daikin, and Bryant. Call (361) 306-9515 for a free estimate, and you’ll get a live person on the line, not a voicemail queue.
Roswell’s winter design temperatures sit in the high teens, which changes how a heat pump should be sized here. A unit picked by square footage alone will lean on its auxiliary strip heat far more than it should. That’s a Georgia Power bill problem, not a comfort problem. We run a Manual J load calculation on every heat pump installation in Roswell because getting the size right is the difference between a system that hums along and one that short-cycles its compressor to an early grave.
We know the homes in Martin’s Landing, East Cobb-adjacent subdivisions off Holcomb Bridge Road, and the older ranch stock near Historic Roswell along Canton Street. Different envelopes, different duct layouts, different right answers. Our techs arrive in uniform, background-checked, and inside the window we gave you. Same standard on every job since 2003, because we operate under The Garrison Standard, part of the Garrison Partners network.
Why Dalton Heating & Air Is Roswell’s Preferred Heat Pump Installation Company
Dalton Heating & Air is a Garrison Partners company. That means every heat pump installation in Roswell carries the same non-negotiable terms: a written price before any work begins, a written guarantee on every repair, and a free return visit if the repair fails within the guarantee period. These aren’t upsells. They’re The Garrison Code, and they’ve been the standard since 2003.
Marco Benitez leads our team, and he holds every tech to the same rulebook. Show up inside the stated window. Put the price in writing. Do the job by the book. Leave the site clean. Stand behind the work for a full year. That’s the 365-Day Done Right Promise, and it applies to every heat pump installation in Roswell we complete.
Our techs are factory-trained to service nine major residential HVAC brands: Carrier, Trane, Lennox, Goodman, Rheem, York, Daikin, Bryant, and American Standard. That matters when your existing system is a Bryant and you’re weighing whether a York replacement makes sense. We’re not married to one manufacturer’s lineup. We match the equipment to the home and the homeowner’s actual heating and cooling load, not to what’s sitting in a warehouse.
Heat Pump Maintenance in Roswell
Heat pump maintenance in Roswell is the single cheapest way to avoid a January no-heat call. A tune-up runs $80 – $200, and it catches the failures that strand you on a cold snap: weak capacitors, dirty coils, drifted refrigerant charge, and static pressure problems that strangle efficiency. Roswell’s pollen season runs long, and our humidity is no joke in summer. Coils clog faster here than in drier parts of the country.
What a tune-up includes
We clean the condenser and evaporator coils, check static pressure across the blower, verify the refrigerant charge to spec, and test the defrost board and auxiliary heat staging. If we find a capacitor that’s reading weak or a thermostat calibration that’s off, we flag it with a specific repair number before we leave. You decide. We don’t sell from the driveway.
How often a Roswell heat pump needs it
Twice a year in Roswell, once before cooling season and once before heating season. Our springs are wet and our summers run hot, and a heat pump that’s been through a Georgia summer needs its coils cleaned and its charge verified before it faces a high-teens winter night. Skipping the fall tune-up is how you end up with a frozen coil on the coldest night of the year.
Why the static pressure check matters
Many Roswell homes built in the 1980s and 1990s have undersized or kinked return ducts. A new high-SEER2 heat pump strangled by bad ductwork will never deliver its rated efficiency. We measure static pressure on every tune-up, because if we find a restriction, we want to tell you before you pay for a new system that can’t breathe.
Geothermal Heat Pump Installation in Roswell
Geothermal heat pump installation in Roswell is a real option on the larger lots in areas like Crabapple and along the Chattahoochee River corridor, where there’s enough land for a horizontal ground loop. A geothermal system runs $3,500 – $7,500 for the equipment side depending on loop configuration, and the honest quote only happens after a site survey. We’ll walk the property, map the loop field, and put the numbers in writing.
Who a geothermal system makes sense for
A Roswell homeowner who plans to stay in the home for ten-plus years and has the land for a loop field is the right candidate. The ground temperature stays steady year-round, which means the heat pump isn’t fighting a 17-degree February night or a 98-degree July afternoon. That translates to lower monthly operating cost and a system that lasts longer than an air-source unit. But we’ll tell you plainly if your lot, your budget, or your timeline says otherwise.
What changes compared to a standard split
The indoor equipment is similar; the difference is the loop field and the loop pump. Ductwork still matters. The load calculation still matters. A geothermal system that’s oversized is still an oversized system. We treat the Manual J as non-negotiable on geothermal work in Roswell, exactly the same as a standard air-source heat pump install. The ground loop just changes where the heat comes from.
Trusted Brands We Service in Roswell
We install and service heat pumps from Rheem, York, Daikin, and Bryant, alongside the rest of the major residential lineup. Because we’re factory-trained on all of them, we don’t push a single brand; we match the equipment to the home’s load, the homeowner’s budget, and the availability of parts. For Roswell customers, that means if your existing York system needs a repair and you’re also weighing a new Bryant variable-speed, we can quote both honestly and get you parts fast without the multi-day wait that comes from a brand-exclusive shop.
Common Heat Pump Installation Problems We See in Roswell Homes
- Oversized replacement by square footage. A contractor who skips the load calculation and installs a 4-ton unit where a 3-ton belongs is handing you short cycling. That wears the compressor and blower motor years before the warranty ends. We see this most often in Roswell homes where the previous owner replaced the AC unit without touching the ductwork.
- Ignored static pressure on older duct systems. Homes off Holcomb Bridge Road and in older neighborhoods near Roswell High often have return ducts that are too small or kinked. A new high-SEER2 heat pump on that ductwork is like running a marathon through a straw. It never delivers its rated efficiency, and the homeowner blames the equipment.
- Skipped refrigerant charge verification. A heat pump that isn’t weighed in to spec will ice the evaporator coil in cooling season and underperform in heating, especially on the cold snaps that hit Roswell in January. We verify the charge as a hard step on every install, not an option.
- Replacing a system that only needed a $150 – $650 repair. A capacitor, thermostat calibration, or refrigerant top-off is a repair, not a replacement. We’ve quoted homes off Upper Hembree Road where the right fix was under $400, but a previous contractor pitched a full $7,500 replacement. We show homeowners both numbers and let the facts decide.
Pricing for Heat Pump Installation in Roswell, GA
| Service | Price Range in Roswell |
|---|---|
| Heat pump repair (capacitor, thermostat calibration, refrigerant charge) | $150 – $650 |
| Heat pump tune-up (coil cleaning, static pressure check, charge verification) | $80 – $200 |
| Heat pump installation (standard split system, load calculation included) | $3,500 – $7,500 |
| Geothermal heat pump installation (ground loop or water-source, quoted after site survey) | $3,500 – $7,500 |
A standard heat pump installation in Roswell runs $3,500 – $7,500, and the spread comes down to efficiency tier, brand, and the ductwork or electrical upgrades a specific home needs. A variable-speed Bryant with a high SEER2 rating lands near the upper end. A straightforward single-stage Rheem replacement on a home with good ductwork lands lower. Every quote includes the load calculation and a written price before any work begins. Call (361) 306-9515 for a free estimate, and we’ll give you the exact number before we touch a tool.
We Also Serve Cities Near Roswell
Our crews cover Roswell and the surrounding north Fulton and Cherokee County communities. That includes Alpharetta, Woodstock, Marietta, and Holly Springs. If you’re just outside Roswell proper but still need a heat pump installed right, we’ll schedule the same way: written price, on-time arrival, full-year guarantee. See our Roswell coverage page for the details, and call (361) 306-9515 if you’re not sure whether you’re in our service area.
Serving Roswell, GA - Our Local Coverage Area
We’re based in the Roswell area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs About Heat Pump Installation in Roswell
Yes, a properly sized heat pump will keep up with Roswell winters, and most Roswell homes we service run heat-pump-only setups without a gas furnace. Roswell’s winter design temperature sits in the high teens, which a correctly sized cold-climate heat pump handles without aux heat on all but the coldest nights. The catch is sizing. If the unit is sized by square footage alone and lands oversized, it will cycle short and you’ll see higher bills. If it’s undersized, your auxiliary strip heat runs constantly and you’ll feel like the heat pump isn’t doing its job. That’s why we treat the Manual J load calculation as non-negotiable on every install. Call (361) 306-9515 and we’ll run the numbers for your home.
A load calculation changes the size of the unit we install, and sometimes the price. In Roswell, many homes built in the 1980s and 1990s have original ductwork and aging windows, which affects how much heating and cooling the home actually needs. A Manual J calculation measures the envelope: square footage, window orientation, ceiling height, insulation levels, and air leakage. Without it, a contractor guesses. With it, we know. That’s the difference between a 3-ton unit and a 4-ton unit, and it’s the difference between a heat pump that runs efficiently for fifteen years and one that short-cycles itself to death. We include the load calculation in every heat pump installation quote, so you see the reasoning behind the size and the price. Call (361) 306-9515 for a free estimate.
At ten years old, a $400 repair on a heat pump is usually worth doing if the rest of the system is solid and the unit wasn’t oversized from day one. Roswell heat pumps face real wear from our long cooling season and January cold snaps, but a well-maintained unit can run fifteen years. The honest repair-versus-replace answer depends on three things: whether the compressor is healthy, whether the refrigerant charge has been drifting low, and whether the unit was ever properly sized. If the compressor is failing, replacement makes more sense. If it’s a capacitor or a thermostat calibration issue, repair is the right call. We quote both numbers side by side, in writing, and let you decide. Call (361) 306-9515 and we’ll do the diagnosis honestly.
SEER2 is the new federal efficiency rating for heat pumps, and a higher number means lower cooling-season energy use per dollar of Georgia Power bill. Roswell’s long, humid summers mean cooling efficiency is where you’ll see the fastest payback. A standard new heat pump runs around 14 – 15 SEER2. A high-efficiency variable-speed unit can run 18 – 20 SEER2 or higher, and the difference shows up as lower summer bills. The catch is that SEER2 only pays off if the ductwork and static pressure are right. A 20-SEER2 heat pump on kinked ducts won’t deliver rated efficiency. That’s why we check static pressure on every install in Roswell before we finalize the equipment recommendation. Call (361) 306-9515 and we’ll show you the real numbers for your home.
Yes, we install geothermal heat pumps in Roswell, and whether it’s worth it depends on your lot size and how long you plan to stay. Geothermal makes sense on larger Roswell properties, like the acreage lots off Crabapple Road or along the Chattahoochee River corridor, where there’s room for a horizontal ground loop. The ground stays around 55 – 60 degrees year-round, so the heat pump isn’t fighting Roswell’s winter lows or summer highs. That means lower operating cost and longer equipment life. The tradeoff is the upfront cost and the site work for the loop field. Geothermal heat pump installation in Roswell runs $3,500 – $7,500 for the equipment side, quoted after a site survey. If you’re on a quarter-acre lot in a dense subdivision, the loop field math may not work. We’ll tell you honestly. Call (361) 306-9515 for a site walk and a real quote.
Heat Pump Installation in Roswell: The Repair-Versus-Replace Decision
Roswell sits in a pocket of north Fulton where winter design temperatures dip to the high teens. A heat pump sized only to the old cooling-first rule of thumb will run its auxiliary strip heat far more than homeowners expect. That’s why we treat the load calculation as non-negotiable here, not a formality. A properly sized heat pump, matched to your home’s actual envelope, is the single biggest factor in whether your system delivers comfort and efficiency, or turns into a Georgia Power bill that climbs every January.
A homeowner off Crabapple Road in Roswell called us after a 12-year-old Carrier heat pump started tripping the breaker in January. Our tech found a weak capacitor on the condenser fan and a refrigerant charge that had drifted low after years of top-offs, so we ran a full load calculation before recommending anything. Because the load calculation showed the existing 3-ton unit was oversized for the home’s actual envelope, we quoted the honest repair-versus-replace numbers side by side. The homeowner chose a properly sized Trane variable-speed heat pump, and the new SEER2 rating plus correct refrigerant charge means the auxiliary heat isn’t running on every cold morning like it used to.
That’s how we approach Heat Pump Installation for every home in Roswell. The right size, the right charge, the right ductwork, and a written price before we start. Because the decision between a $400 repair and a $7,500 replacement should be based on facts, not a sales pitch. Call (361) 306-9515 for a free estimate, and Marco Benitez or one of our techs will walk you through the numbers honestly.
Written by Marco Benitez, Owner at Dalton Heating & Air, serving Roswell since 2003 as part of the Garrison Partners network.