Seasonal tune-up and full diagnostic on your Carrier, Trane, or Goodman system - readings shown to you before any repair is proposed
Diagnosis first, numbers second - you approve the repair price before a single part goes in.
Before
After
Before
After
Before
AfterFast, Reliable Heat Pump Installation Across Roanoke
Heat pump installation in Roanoke typically runs $3,500 to $7,500 for a full system, and the right unit for your house depends on a real load calculation, not a guess. We install and service heat pumps in every Roanoke neighborhood, from Fairway Ranch to Trophy Club’s western edge, and we carry parts for Goodman, Rheem, York, and Daikin locally so you’re not waiting a week for a compressor. If your heat pump is short-cycling, running on aux heat too often, or just worn out after 12 to 15 Texas summers, call (361) 306-9515 and we’ll give you a straight answer, not a sales pitch.
Key Takeaways for Roanoke Homeowners
- Full heat pump installation in Roanoke runs $3,500 to $7,500 depending on size, efficiency tier, and duct condition.
- Roanoke’s dual-load climate, 100°F-plus summers and teens in winter, means sizing matters more here than in milder parts of Texas.
- Builder-grade ductwork in newer Roanoke subdivisions is a real problem that can cut a new heat pump’s efficiency by 30% before it ever cycles on.
- Every job from Dalton Heating & Air gets a written price before work starts and a written guarantee that lasts a full year.
Why Dalton Heating & Air Is Roanoke’s Preferred Heat Pump Installation Company
Marco Benitez runs our Roanoke heat pump installation work, and he holds every job to The Garrison Standard that’s been in place since 2003. That means the price you see in writing is the price you pay. Not less if you haggle, not more if the job runs long. It also means our techs arrive inside the window they give you, in a marked Dalton uniform, and they leave your Roanoke home the way they found it except for the new system doing its job.
We’re a Dallas-Fort Worth company with local crews serving Roanoke directly. When you call (361) 306-9515, a live person answers, 24/7. You don’t leave a voicemail and hope someone gets back to you by Thursday. Our dispatchers know Roanoke’s streets and can have a factory-trained tech rolling to your neighborhood the same day your heat pump goes down in a cold snap.
Roanoke homeowners deal with a specific set of heat pump failures that techs in other parts of the metro don’t see as often. We know the builder-grade ductwork in neighborhoods like Meadow Lake Estates and the wind-driven coil damage from storms that roll through southern Denton County. That local knowledge means we diagnose the root problem faster, and we don’t sell you a new system when a $200 repair is the honest fix.
Mini Split Installation in Roanoke
Mini split installation in Roanoke is the right call when you need heating and cooling in a room or garage that your central system never reaches, and it’s one of the heat pump services our Roanoke crews do most often. A ductless mini split gives you zone control without running new ductwork, which matters a lot in Roanoke’s newer homes where the existing ducts are already leaking enough as it is. Expect to pay from the same range as standard heat pump work, $3,500 to $7,500, with the final number set by the number of zones and the equipment’s efficiency rating. Marco Benitez will walk you through the load math for the specific room before you spend a dollar.
Heat Pump Installation for a ductless system follows the same Garrison Standard as a central unit: written price first, factory-trained install, full-year written guarantee.
Garage and Bonus Room Conversions
Roanoke has a lot of bonus rooms above garages that bake in August and freeze in February. A single-zone mini split is usually the cheapest way to make those rooms usable year-round, and our installers have done enough of them in the Fairway Ranch area to know exactly where to mount the condenser so HOA rules stay happy.
Multi-Zone Split Systems for Additions
If you’re adding a primary suite or a home office in Roanoke, a multi-zone mini split can heat and cool the new space without disturbing the existing HVAC. We run the room-by-room load calculation first, so you don’t end up with an oversized unit that short-cycles and kills its own compressor early.
Heat Pump Maintenance in Roanoke
Heat pump maintenance in Roanoke is the cheapest insurance against the two things that kill these systems here: pollen and cottonwood clogging the outdoor coil in spring, and hard-use winters that push the compressor harder than a straight AC ever gets pushed. A tune-up runs $80 to $200, and our techs check refrigerant charge, coil condition, defrost cycle operation, blower motor amp draw, and the condition of your air handler’s filter slot. Roanoke homeowners who keep a regular spring and fall maintenance schedule typically get 3 to 5 more years out of a heat pump than those who run it until it quits.
Our Roanoke maintenance visits include a written report of what was actually found, and our techs are not paid on what they sell. If the tune-up turns up a failing capacitor or a dirty blower wheel, you’ll get a repair quote in writing with no pressure.
Spring Coil Cleaning and Charge Check
After the live oaks and cottonwoods drop their load on Roanoke every spring, a clogged outdoor coil will drive up your electric bill even though the house still cools. We wash the coil, check subcooling on cooling mode, and catch refrigerant leaks before you lose a compressor over a $200 repair.
Fall Defrost and Heat Mode Verification
Before Roanoke nights dip below freezing, we test the defrost cycle, heat output at the duct, and auxiliary heat staging. A heat pump that’s running its strip heat too early is one that needs attention, and catching it in October beats a $500 electric bill in January.
Trusted Brands We Service in Roanoke
Our Roanoke installers are factory-trained on nine major residential HVAC brands, and on the heat pump side we do the most work on Goodman, Rheem, York, and Daikin. That means we know the failure points of each brand, and we keep common Roanoke parts like reversing valves, contactors, and defrost control boards stocked locally so repairs don’t drag into a second week. If you already have a Daikin heat pump that’s 10 years old and still running, we’ll tell you what’s repairable and what’s not, without pushing a specific brand because our supplier has a deal this month.
Common Heat Pump Installation Problems We See in Roanoke Homes
- Oversized systems on rule-of-thumb tonnage. A lot of Roanoke homes got a 3-ton heat pump because the builder guessed. On 30°F mornings, the system blasts aux heat strips, never reaches its rated SEER2 efficiency, and cycles off before it dehumidifies properly in summer. We run a real Manual J load calculation on every install.
- Builder-grade duct leak issues. In newer subdivisions like Seabrook and PointVista, we regularly find supply ducts that were never sealed and returns that are undersized. A leaking duct system can cut a new heat pump’s real-world efficiency by 30%, and it’s a common reason Roanoke homeowners think their heat pump is too small when it isn’t.
- Bad refrigerant jobs from prior repairs. We see heat pump condenser coils that were swapped without a proper vacuum pulled or without weighing in the refrigerant charge. That kills capacity and shortens compressor life. The fix is precise work, not a guess with gauges.
- Filter grilles too small for higher-efficiency systems. A lot of Roanoke homes built in the last 15 years have a 1-inch filter slot that chokes airflow. When you upgrade to a higher-efficiency heat pump, we check static pressure and often recommend up-sizing the return or switching to a media cabinet so the new equipment actually performs.
Pricing for Heat Pump Installation in Roanoke, TX
Here’s the honest math for heat pump work in Roanoke, in writing:
| Service | Roanoke Price Range |
|---|---|
| Heat pump installation (full system) | $3,500 – $7,500 |
| Heat pump repair / diagnostic | $150 – $650 |
| Heat pump tune-up | $80 – $200 |
What moves a Roanoke heat pump install toward the high end? Higher SEER2 ratings, two-stage or variable-speed compressors, upgraded duct sealing or a new return, and zoning if your two-story has a hot upstairs. What moves it toward the low end? A straightforward swap of a 2-ton or 2.5-ton single-stage unit with decent existing ductwork. Estimates are free. Call (361) 306-9515 and Marco Benitez will give you a written quote before any wrenches come out.
We Also Serve Cities Near Roanoke
Dalton Heating & Air handles heat pump installation across the northwest metro. If you’re in Flower Mound, Southlake, Argyle, or Justin, the same crews and the same written guarantee apply. Our dispatchers route Roanoke calls and nearby service areas through the same 24/7 live line, so you reach a real person whether your compressor dies at noon or midnight.
Serving Roanoke, TX - Our Local Coverage Area
We’re based in the Roanoke area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs About Heat Pump Installation in Roanoke
Yes, for most Roanoke homes. Roanoke sits in the Denton County wind-and-hail belt where summer design temps push past 100°F while winter still drops into the teens. A heat pump handles both ends of that swing in one unit, and a properly sized one will heat your home efficiently down into the 20s before aux heat strips become the primary heat source. The catch is that dual-load sizing, not rule-of-thumb tonnage. If you want an exact recommendation for your house, call (361) 306-9515 and we’ll run the numbers.
A standard single-family heat pump swap in Roanoke takes one full day, sometimes a day and a half if we’re sealing ducts, upsizing a return, or relocating the condenser. Mini split jobs run one to two days depending on zones. We schedule a specific install date and show up when we say we will, and the price is in writing before the crew arrives.
Aim for 15 to 17 SEER2 if you plan to stay in the house more than five years, and don’t pay for 20+ SEER2 unless the load calculation shows you’ll actually run the unit enough to earn it back. Roanoke’s electric rates and hot summers make a mid-tier two-stage system the best dollar-per-comfort choice for most homes. Our installers will show you the efficiency math on your specific house, not a brochure chart.
Usually, and you should ask for that option. Most Roanoke heat pump failures we see, bad capacitors, reversing valves, defrost boards, dirty coils, are repairable for $150 to $650. We recommend replacement when the compressor is dead, the evaporator coil is leaking and the unit is 10-plus years old, or the repair cost exceeds half the value of the remaining life of the system. Marco Benitez gives you the repair-versus-replace math in writing, and we don’t push replacement unless the numbers justify it.
Yes. Mini split installation, repair, and maintenance are all part of our standard heat pump service in Roanoke. That includes ductless wall units, ceiling cassettes, and multi-zone systems, whether they’re a primary heat source or a supplemental zone for a bonus room. We service Goodman, Daikin, Rheem, and York mini splits with the same one-year written guarantee as central heat pump work. Call (361) 306-9515 for a free estimate.
Written by Marco Benitez, Owner at Dalton Heating & Air, serving Roanoke since 2003.