Seasonal tune-up and full diagnostic on your Carrier, Trane, or Goodman system - readings shown to you before any repair is proposed
Diagnosis first, numbers second - you approve the repair price before a single part goes in.
Before
After
Before
After
Before
AfterFast, Reliable Heat Pump Installation Across Franklin
Heat pump installation in Franklin typically runs $3,500 to $7,500 for a full system, and most jobs are completed in one day once equipment is on hand. That’s the number to plan around. We’re Dalton Heating & Air, and we’ve been installing and servicing heat pumps across Williamson County long enough to know what Franklin homes actually need. The truth is, a heat pump here has to do two jobs well: keep you cool through humid 95-degree July weeks and keep you warm during those January mornings that dip into the low teens. Get the sizing wrong, and you’ll pay for it every month on your electric bill. Call (361) 306-9515 for a free estimate with written pricing before anything starts.
Why Dalton Heating & Air Is Franklin’s Preferred Heat Pump Installation Company
Franklin homeowners tend to research before they buy. We respect that. Marco Benitez, who leads our team, operates under The Garrison Standard: arrive inside the stated window, put the price in writing before any work begins, do the job by the book, leave the site clean, and stand behind the work for a full year. That’s not a slogan. It’s the operating code every Dalton tech works under, and it applies whether we’re replacing a heat pump in Berry Farms or tuning one up off Peytonsville Road.
Our techs are background-checked and uniformed. You’ll know who’s walking up your driveway before they knock. We service nine major residential brands including Goodman, Rheem, York, and Daikin, and we stock common parts locally so a repair doesn’t stretch into a three-day ordeal while a part ships from somewhere else. Franklin’s housing stock runs the gamut from 1980s ranches to new construction in Westhaven, and we’ve worked on all of it. That matters because a heat pump that fits a 1,400-square-foot ranch on Mack Hatcher isn’t what a 3,200-square-foot home on a cul-de-sac in Fieldstone Farms needs.
Heat Pump Service in Franklin
Heat pump service in Franklin means keeping a single system doing two jobs: heating and cooling. When a furnace acts up, it’s a winter problem. When your heat pump acts up, it’s a year-round problem because the same compressor and coil handle both sides. We see three common failure points in Franklin: refrigerant leaks that slowly erode capacity, failing capacitors that cause short-cycling, and dirty coils that force the system to work harder than it should. A service call usually runs $150 to $650 depending on the part, and every repair comes with a written guarantee for a full year. If the work doesn’t hold, we return at no charge. That’s The Garrison Standard, not an upgrade.
What a Tune-Up Includes
A heat pump tune-up in Franklin runs $80 to $200, and it’s the cheapest insurance you can buy against a mid-summer or mid-winter failure. We check refrigerant levels, test the capacitor, clean the coils, inspect electrical connections, and verify the defrost cycle is working. That last one matters more in Franklin than people realize, because frost buildup during a damp 35-degree night can wreck efficiency if the defrost board isn’t cycling properly.
When to Call Before It Gets Worse
If your heat pump is running constantly but not hitting set temperature, or you hear a buzzing sound from the condenser, or your auxiliary heat light is on more than it used to be, call us. Waiting doesn’t make the fix cheaper. It makes the part that failed take out a second part with it. We answer the phone with a live person 24/7, so you’re not leaving a voicemail and hoping someone calls back by Thursday.
Heat Pump Replacement in Franklin
Heat pump replacement in Franklin is a decision a lot of homeowners put off until the system dies completely. That’s usually the most expensive way to do it. A full replacement runs $3,500 to $7,500, and the spread comes down to size, efficiency level, and whether the existing ductwork needs attention. The most important thing you can do before approving a replacement is have a proper load calculation run. Not a guess based on what tonnage the old unit was. An actual Manual J calculation that accounts for the house’s square footage, insulation, window orientation, and airtightness. Most Franklin homes built before 2010 were installed with oversized equipment, and if you simply swap in the same tonnage, you inherit the same short-cycling, humidity, and uneven temperature problems the old system had.
Repair Versus Replace: The Honest Framework
Here’s how we tell a Franklin homeowner whether to repair or replace. If the compressor is still under warranty and the repair is under $650, repair it. If the unit is over 12 years old and the repair is a refrigerant leak in the evaporator coil, you’re looking at a repair that costs $1,200 or more on a system that’s already past its life expectancy. At that point, replacement is the smarter money. We’ll walk you through the math in writing and let you decide. No pressure, no “act now” games.
What a Load Calculation Changes
Franklin sits in a climate transition zone. Winter design temperatures near the low teens mean a real heating load. Summer humidity means a real latent cooling load. A heat pump sized only for cooling will leave the house relying on expensive strip heat during cold snaps. A unit sized only for heating will short-cycle through the summer and leave the air clammy. A proper load calculation sizes both sides correctly, and that’s the difference between a heat pump that costs $180 a month to run and one that costs $240 for the same comfort. We do the calculation on every replacement quote. No charge for it.
Trusted Brands We Service in Franklin
We install and service Goodman, Rheem, York, and Daikin heat pumps, along with five other major residential brands. We don’t push one brand over another. We pick equipment based on what the load calculation says your house needs and what your budget can absorb. For Franklin’s climate specifically, we’ve had strong results with Daikin’s variable-speed units for humidity control and Goodman’s mid-range models for straightforward single-stage replacements where budget is the priority. Because we stock common parts locally, a repair on a Rheem or York system doesn’t turn into a week-long wait for a part to arrive from a regional warehouse. Franklin’s location works in your favor here: we can get most parts same-day or next-day, and our techs carry the most common capacitors, contactors, and defrost boards on the truck.
Common Heat Pump Installation Problems We See in Franklin Homes
- Same-tonnage swaps without a load calculation. This is the most common mistake we see in Franklin, especially in older subdivisions like Sullivan Farms and Forrest Crossing, where original equipment was oversized. The new system inherits the same cycling problems, which means humidity control suffers and your electric bill doesn’t drop like it should.
- Ignoring the heating-side balance point. A system sized only for Franklin’s summer load will hold temperature on a July afternoon, but on a 14-degree January morning the auxiliary heat strips run constantly. That’s the difference between a $140 electric bill and a $280 one during a cold snap.
- Rust and corrosion on outdoor units. Franklin gets real humidity and occasional ice events, and a unit installed too close to a gutter downspout or under tree drip line will develop rust on the cabinet and corrosion on the coil within a few years. Placement matters more here than in drier climates.
- Skipping static pressure checks after installation. Older Franklin homes often have restrictive ductwork. If a new heat pump gets installed without checking static pressure across the evaporator coil, airflow problems can masquerade as a refrigerant charge problem or a blower motor failure. The real fix is ductwork correction, not adding refrigerant.
Pricing for Heat Pump Installation in Franklin, TN
A full heat pump installation in Franklin runs $3,500 to $7,500. Repairs fall between $150 and $650. A tune-up is $80 to $200. Here’s the breakdown so you know what you’re looking at before you call:
| Service | Franklin Price Range |
|---|---|
| Heat Pump Installation (full system) | $3,500 – $7,500 |
| Heat Pump Repair | $150 – $650 |
| Heat Pump Tune-Up | $80 – $200 |
The installation spread depends on seer rating, whether you need a variable-speed compressor, and whether your existing ductwork is adequate or needs sealing or modification. We give you a written fixed price before any work starts. That number doesn’t change at the door. Call (361) 306-9515 and we’ll put a quote in writing for your specific home in Franklin, based on a real load calculation, not a guess.
We Also Serve Cities Near Franklin
We work throughout the Franklin area and into the surrounding communities. That includes Franklin proper, plus Brentwood, Nolensville, Fairview, and Spring Hill. If you’re a few miles outside city limits and wondering whether we cover your street, call us. If you’re in Williamson County, you’re in our service area.
Serving Franklin, TN - Our Local Coverage Area
We’re based in the Franklin area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs About Heat Pump Installation in Franklin
If the repair is under $650 and your unit is under 12 years old, repair it. If the unit is past 12 years and the repair involves a refrigerant leak in the coil or a failed compressor, replacement usually makes more financial sense. We’ll give you both numbers in writing before you decide. Call (361) 306-9515 and we’ll assess it honestly, even if the answer is that you don’t need to buy anything yet.
A load calculation sizes the equipment to your home’s actual heating and cooling demands. In Franklin, where winter design temperatures drop near the low teens and summer humidity runs high, that means sizing a system that handles both sides correctly, not just matching the old unit’s tonnage. It can mean the difference between a properly sized 3-ton unit and an oversized 4-ton unit that short-cycles and leaves the house humid.
SEER2 is the efficiency standard that went into effect in 2023, and it measures cooling efficiency under more realistic conditions than the old SEER rating. A 15 SEER2 unit is roughly 15% more efficient than a 13 SEER2 unit, which on a Franklin home running the heat pump nine months of the year could save $150 to $250 annually. The payback for stepping up a SEER level usually runs three to five years in our market.
Twice a year: once before cooling season in April or May, and once before heating season in October or November. Franklin’s humidity means coils get dirty faster, and a dirty coil will cost you more in electricity than the tune-up costs. Our tune-up runs $80 to $200 and includes a written report of exactly what was checked and what we found. Call (361) 306-9515 to schedule.
Yes. Mini splits are a common solution for Franklin homes where the original system was a ducted unit but a room addition or finished basement doesn’t have adequate supply runs. We install multi-zone mini split systems that handle both heating and cooling, and they pair well with an existing central heat pump if you’re looking to solve a comfort problem in one specific area. Pricing depends on the number of zones and line set runs, but generally starts in the $3,500 range for a single-zone system. Call (361) 306-9515 and we’ll quote the whole job in writing.
When we replaced a heat pump in Berry Farms earlier this year, the homeowner’s 15-year-old unit was short-cycling and struggling through January. Our tech found a failing capacitor and low refrigerant, but before quoting a replacement we ran a load calculation and found the original system was oversized for the house. We installed a properly sized unit, verified static pressure across the new evaporator coil, and calibrated the thermostat so the auxiliary heat wasn’t kicking on unnecessarily. That’s the difference between a parts swap and a real installation. If you’re in Franklin and your heat pump is struggling, call (361) 306-9515. We’ll send a uniformed tech, put the price in writing, and stand behind the work for a full year. That’s the whole deal.
Written by Marco Benitez, Owner at Dalton Heating & Air, serving Franklin since 2003.