Seasonal tune-up and full diagnostic on your Carrier, Trane, or Goodman system - readings shown to you before any repair is proposed
Diagnosis first, numbers second - you approve the repair price before a single part goes in.
Before
After
Before
After
Before
AfterFast, Reliable Heat Pump Installation Across Edmonds
A heat pump installation in Edmonds, WA typically runs $3,500 – $7,500 for a full system replacement, and the right unit for your home depends more on cold-weather performance and defrost behavior than on peak summer cooling. Most Edmonds homes we serve get a properly sized, cold-climate-capable heat pump installed within one to two days once equipment is ordered and the load calculation is complete. We dispatch crews to Edmonds from our Seattle metro office, so scheduling stays simple and response times are predictable. Call (361) 306-9515 for a free estimate and a written price before any work begins.
Edmonds sits right on the Puget Sound shoreline, and that changes how heat pumps get sized. Marine air keeps summers mild and winters damp, hovering near freezing with high humidity. A unit sized for inland Puget Sound summers will short-cycle here, waste energy, and still struggle on cold mornings. That’s the problem we solve on a regular basis.
Why Dalton Heating & Air Is Edmonds’s Preferred Heat Pump Installation Company
Edmonds homeowners call us because we put every price in writing before work starts and we stand behind the install for a full year under The Garrison Standard. No exceptions, no fine print. That discipline matters when you’ve been burned by a crew that quoted one number over the phone and showed up with another.
Our technicians are background-checked, uniformed, and factory-trained on nine major residential HVAC brands. When we schedule an Edmonds job, you know who’s coming before they arrive, and they arrive inside the stated window. The Garrison Code requires it: arrive on time, price in writing, do the job by the book, leave the site clean, and stand behind the work for a full year.
For Edmonds homeowners specifically, local knowledge matters. We understand how salt air off the Sound affects outdoor coil corrosion, and we know that many mid-century homes here were built with ductwork never designed for modern variable-speed equipment. That’s the difference between an install that performs and one that just runs.
Heat Pump Replacement in Edmonds
Heat Pump Replacement in Edmonds means removing an old, underperforming or failed heat pump and installing a properly sized unit matched to your home’s actual heating load, not a guess based on square footage. A full replacement in Edmonds runs $3,500 – $7,500 depending on equipment efficiency, capacity, and whether ductwork modifications are needed. The mistake we see most often is homeowners paying for a replacement without a load calculation, which leaves them with the same sizing errors the old unit had.
What Replacement Involves
We start with a Manual J load calculation for your specific home, factoring in Edmonds’s marine climate, window orientation, insulation levels, and actual duct condition. Then we specify equipment rated for cold-weather performance, not just a high SEER2 number. The install itself covers the outdoor condenser, indoor air handler or coil, refrigerant lines, thermostat wiring, and start-up verification including defrost cycle operation. Every replacement includes a written price before work begins and a full-year written guarantee.
When Edmonds Homeowners Replace
Most replacements we do in Edmonds fall into three buckets: the existing heat pump is 12 – 15 years old with a compressor or reversing valve failure, the auxiliary heat strips run constantly through winter because the unit never stages properly, or the homeowner is tired of short cycles and humidity problems caused by an oversized system. A repair under $650 is often the right call on a younger unit. A four-digit repair on a 14-year-old heat pump is usually the signal to replace.
Mini Split Installation in Edmonds
Mini Split Installation in Edmonds gives you zoned heating and cooling without touching existing ductwork, and it’s the right answer when one room or an addition never reaches temperature. A ductless mini split install in Edmonds typically runs $3,500 – $7,500 for a single-zone system, with multi-zone systems falling at the higher end depending on the number of indoor heads and the outdoor unit’s capacity. The big advantage in Edmonds is that you stop conditioning rooms you don’t use and get targeted heat only where you need it.
Where Mini Splits Fit Edmonds Homes
Edmonds has a lot of mid-century housing stock with ductwork that was undersized or poorly balanced from day one. A mini split bypasses that problem entirely. We install them commonly in converted garages, sunrooms, and upper-floor bedrooms that never got adequate duct runs. Cold-climate mini splits from Rheem and Daikin perform well down into the teens, which matters more in Edmonds than the cooling spec since our winters run damp and near freezing.
What Installation Looks Like
The job involves mounting the indoor air handler, running a small refrigerant line set to an outdoor condenser, and wiring the system to its own circuit. Most single-zone installs finish in a day. Multi-zone work may take two. You get a written price up front, a set install date, and the same 365-Day Done Right Promise that covers every Dalton install. If it’s not done right, we make it right.
Trusted Brands We Service in Edmonds
Our Heat Pump Installation team works primarily with Rheem, York, Daikin, and Bryant equipment for Edmonds homes, because these manufacturers build units with strong cold-weather performance and good defrost logic, both essential in the Puget Sound marine climate. We stock common replacement parts and refrigerant for these brands locally, which means faster turnaround when a repair is needed after install. If you already have a Carrier, Trane, Lennox, Goodman, or American Standard system, we service those too, all nine major residential brands, factory-trained.
Common Heat Pump Installation Problems We See in Edmonds Homes
- Oversized tonnage from inland sizing habits. Contractors who do most of their work in Bothell or Renton sometimes size Edmonds heat pumps for inland heat, not marine cold. The result is short-cycling, poor humidity control, and heat strips that run more than they should.
- Defrost cycle failures during damp shoulder seasons. Edmonds gets long stretches of 35 – 45° weather with high humidity, which means the outdoor coil ices up and the unit has to defrost frequently. A sticking reversing valve or failed defrost sensor gets misdiagnosed as a dead compressor all the time.
- Ducts that can’t handle variable-speed static pressure. Many Edmonds homes built in the 1960s and 70s have duct runs too small or too leaky for a modern variable-speed heat pump. Real-world SEER2 performance tanks when the blower fights restrictive ducts, and no amount of refrigerant adjustment fixes it.
- Poor envelope sealing on waterfront and near-water homes. Houses near Sunset Ave and the Edmonds waterfront deal with wind-driven moisture and older window seals. Air leaks and missing insulation force the heat pump to work harder than the load calculation assumes, so we check the envelope before finalizing sizing.
Pricing for Heat Pump Installation in Edmonds, WA
| Service | Edmonds Price Range |
|---|---|
| Heat Pump Installation (full system) | $3,500 – $7,500 |
| Heat Pump / AC Repair diagnostic and repair | $150 – $650 |
| Seasonal tune-up and refrigerant charge check | $80 – $200 |
The spread on full installation comes down to equipment efficiency, capacity, whether you need ductwork modifications, and how many zones you’re installing. A straightforward replacement with existing ducts lands at the lower end. A multi-zone mini split system or a high-efficiency cold-climate unit with duct sealing lands higher. Every estimate is free, and the price we quote is the price you pay. Call (361) 306-9515 for exact numbers on your home.
We Also Serve Cities Near Edmonds
Our crews cover the surrounding Puget Sound communities, including Mountlake Terrace, Lynnwood, Kenmore, and Kingston. If you’re just outside Edmonds and need heat pump work, call us and we’ll confirm coverage and response time for your specific area.
Serving Edmonds, WA - Our Local Coverage Area
We’re based in the Edmonds area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs About Heat Pump Installation in Edmonds
Does a heat pump actually work well in Edmonds’s winter, or do I still need the furnace as backup?
A properly sized cold-climate heat pump handles Edmonds winters on its own down to well below freezing, especially when it’s matched to your home’s actual load calculation. Most Edmonds homes do not need a furnace as backup if the heat pump was sized for marine winter conditions, not inland summer heat. Where homes keep their furnaces is usually a retrofit situation where the existing furnace serves as the air handler in a dual-fuel setup, which works fine but isn’t required for comfort. Call (361) 306-9515 and we’ll tell you straight whether your home needs dual fuel or a properly sized heat pump alone.
Why does my heat pump short-cycle in Edmonds’s mild weather?
Short-cycling in Edmonds almost always traces back to oversized tonnage, because the unit reaches set temperature too fast and shuts off before it removes moisture or heats evenly. A system sized for inland Puget Sound heat will do exactly this in Edmonds because our marine air never demands the peak cooling capacity the unit was built for. The fix is a proper load calculation and, in many cases, a variable-speed replacement that runs longer at lower output. A diagnostic call runs $150 – $650 and tells you definitively whether sizing is the problem.
What does a load calculation change about my heat pump installation quote?
A load calculation changes the equipment size we recommend, which changes the price, and it’s the difference between a unit that performs and one that fights your house. In Edmonds, a Manual J calculation accounts for marine humidity, winter design temperatures near freezing, window orientation, insulation, and duct condition. Without one, you’re trusting a rule of thumb that was probably wrong when the old unit went in. Every Dalton estimate includes a load calculation, and it’s free with your quote.
My heat pump is 14 years old and needs a repair – should I fix it or replace it?
If the repair is under $650 on a 14-year-old Edmonds heat pump, fix it and run it, unless the compressor or reversing valve is done. Those are the two failures that make replacement the better financial call, because you’re looking at four figures on a unit near the end of its service life. In Edmonds’s marine climate, 14 years is already a full lifespan for many heat pumps, especially near the waterfront where salt air accelerates outdoor coil corrosion. We’ll give you the repair price and the replacement price side by side, both in writing, and let you decide.
Can I add a mini split to one room instead of replacing my whole heat pump system?
Yes, and in Edmonds it’s often the smartest option when one room, like an upper bedroom or a converted garage, never reaches temperature. A single-zone mini split runs $3,500 – $7,500 installed and gives you independent control without replacing your existing system. It’s a common fix for mid-century Edmonds homes with undersized or unbalanced duct runs. Call (361) 306-9515 for a free estimate and we’ll tell you if a mini split solves the problem without touching the rest of the house.
Get Your Heat Pump Installation Quote in Edmonds
Call Dalton Heating & Air at (361) 306-9515 for a free, no-pressure estimate on heat pump installation in Edmonds. You’ll get a written price before any work begins, a load calculation specific to your home, and the 365-Day Done Right Promise on every install. Our dispatchers answer live, 24/7. No voicemail queue, no callback window.
Written by Marco Benitez, Owner at Dalton Heating & Air, a Garrison Partners company serving Edmonds under The Garrison Standard since 2003.