Seasonal tune-up and full diagnostic on your Carrier, Trane, or Goodman system - readings shown to you before any repair is proposed
Diagnosis first, numbers second - you approve the repair price before a single part goes in.
Before
After
Before
After
Before
AfterHVAC Company in Garland, TX
Dalton Heating & Air provides HVAC repair and installation across Garland, TX, with written pricing before any work begins and a full-year written guarantee on every repair. Most Garland homes run their air conditioning hard from May through September, and when a system fails in that stretch, the indoor temperature climbs fast. Our crews arrive inside a stated window, service all nine major residential HVAC brands, and leave the site clean. Call (361) 306-9515 when your system needs a technician who shows up.
Why Garland Homes Are Different
Garland’s housing stock spans a wide range of ages, from 1960s ranch-style homes in older neighborhoods near downtown to newer construction on the city’s north and east edges. That matters because ductwork, electrical capacity, and even the refrigerant type in a system vary by era. Older homes often have undersized return air and original duct runs that have never been sealed, while newer homes tend to have tighter envelopes and higher-efficiency equipment that still needs regular service to hold its rated performance.
The climate is the bigger factor. Garland sits in a humid subtropical zone where summer highs routinely reach the upper 90s and humidity makes it feel hotter. A system that is slightly low on refrigerant or has a dirty condenser coil may limp through spring but will struggle badly by July. We also see a lot of heat pump adoption in Garland because winters are mild enough for a heat pump to handle most heating days efficiently, which changes the maintenance conversation compared to gas-only furnace country further north.
Drainage and foundation movement show up in our work too. The clay-heavy soils under much of Garland shift with wet and dry cycles, and that movement can put stress on outdoor condenser pads, causing units to sit out of level. That affects compressor oil distribution over time. It is a small detail, but it is the kind of thing we check on every visit because it shortens equipment life when ignored.
Our Main Garland Services
Most calls from Garland homeowners fall into one of two buckets: an air conditioner that has stopped cooling in the middle of a Texas summer, or a heat pump or furnace decision that needs a straight answer on price and scope. Here is what each job involves locally.
AC Repair in Garland
When a Garland air conditioner stops cooling, the problem is usually one of a handful of things: a failed capacitor, a refrigerant leak, a clogged condensate drain, or a contactor that has burned out. Our AC Repair in Garland page covers exact pricing, what a diagnostic visit includes, and how fast we can get a technician to your door. In Garland’s summer heat, we prioritize no-cooling calls same-day because the house becomes unsafe for pets and older family members within hours.
Heat Pump Installation in Garland
Heat pumps are a strong fit for Garland’s climate, handling both cooling in summer and heating on the mild winter days that make up most of the season here. A proper installation starts with a load calculation, not a rule-of-thumb guess, and we put the full price in writing before any equipment is ordered. See Heat Pump Installation in Garland for cost ranges, available efficiency tiers, and how long a typical replacement takes in a Garland home.
Furnace Repair in Garland
Furnaces in Garland get a shorter workout than they do up north, but they still fail, usually on the first genuinely cold night of the year when they fire up after months of sitting idle. Ignitors crack, flame sensors get coated, and blower motors wear out. The Furnace Repair in Garland page breaks down common furnace failures, what they cost to fix in this market, and how our written guarantee works if the repair does not hold.
What happens when you call
- 1
A real person answersNo phone trees - you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Brands We Service in Garland
Our technicians carry parts for Rheem, York, Daikin, Bryant, and five other major residential lines, which means most repairs in Garland finish on the first visit. We keep capacitors, contactors, ignitors, flame sensors, and blower motors stocked in our Dallas-Fort Worth area service vehicles. When your system needs something we do not have on the truck, our supply chain puts it in hand same-day in nearly every Garland case. See our brands for the full list.
Pricing for HVAC Company in Garland, TX
These are the ranges Garland homeowners see on our written estimates, based on what we actually charge for work in this market. A diagnostic visit is applied toward the repair if you decide to move forward.
| Service | Typical range in Garland |
|---|---|
| AC repair (minor, e.g., capacitor or contactor) | $150 – $350 |
| AC repair (major, e.g., compressor or coil) | $400 – $650 |
| Furnace repair (minor, e.g., ignitor or flame sensor) | $150 – $350 |
| Furnace repair (major, e.g., blower motor or gas valve) | $400 – $700 |
| Tune-up (cooling or heating, per system) | $80 – $200 |
| AC installation (full system replacement) | $3,500 – $7,500 |
What moves a Garland job to the higher end of those ranges is usually equipment age and access. A condenser squeezed into a tight side yard or a furnace in a low-clearance attic takes longer and costs more in labor. The price we quote is the price you pay, and it is in writing before any work starts.
Neighborhoods We Serve in Garland
We run calls all over Garland, from homes near downtown to subdivisions along the city’s northern and eastern edges. Response time is typically same-day for no-cooling calls and next-day for scheduled maintenance, depending on call volume.
- Firewheel and the area around Firewheel Town Center
- Club Hill
- SpringPark
- The neighborhoods along Broadway Boulevard near downtown
- North Garland, including the Belt Line Road corridor
Service Area – Cities Near Garland
In addition to Garland, our crews cover the surrounding northeast Dallas suburbs. We regularly schedule work in Sachse, TX, Rowlett, TX, Wylie, TX, and Richardson, TX. If you are on the border between cities, call and we will tell you which crew is closest.
Serving Garland, TX - Our Local Coverage Area
We’re based in the Garland area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs About HVAC Company in Garland
In summer, we treat no-cooling calls as emergencies and dispatch same-day in nearly all Garland cases. A live person answers the phone 24/7, so you will speak to someone immediately rather than leaving a message.
Most furnace and AC replacements in Garland require a city permit, and we handle that paperwork as part of the installation job. Repairs and maintenance typically do not need a permit. Your written estimate will note any permit fees before you sign.
Yes, there is a diagnostic fee for the visit, and it is applied toward the repair if you have us complete the work. You will see the diagnostic fee in writing before the technician starts, and the full repair price is written before any work begins.
Call (361) 306-9515 for a free estimate on any HVAC work in Garland. A live person answers, and we will get a technician scheduled inside a window that works for you.
What happens when you call
- 1A real person answersNo phone trees - talk to a local hvac pro.
- 2You get an upfront price rangeHonest numbers before anyone is dispatched. No surprises.
- 3We come out and measureLicensed & insured, at a time that suits you - the visit and the quote are both free.
- 4You get the price in writingLine-itemed, yours to keep, and nothing starts until you say go.
What Garland Customers Say
"Tech arrived in uniform right on time. AC wasn't cooling, found a failed capacitor, and replaced it in twenty minutes. The owner is a veteran and the company runs like it."
- Frank O."Blower motor died on the coldest night. They had the part on the truck and had us warm again the same day."
- Sandy G."Changed the filter size and added a better filter rack. Simple and useful advice."
- Rhonda C.