Seasonal tune-up and full diagnostic on your Carrier, Trane, or Goodman system - readings shown to you before any repair is proposed
Diagnosis first, numbers second - you approve the repair price before a single part goes in.
Before
After
Before
After
Before
AfterFast, Reliable Furnace Repair Across Tiburon
Furnace repair in Tiburon typically runs $150 – $700, and most no-heat calls we take from Tiburon homes trace to ignition, thermocouple, or blower motor wear rather than a failed system. Because Tiburon’s heating season is short and mild, your furnace sits idle most of the year, which creates a specific set of failure patterns. Dalton Heating & Air has crews serving Tiburon with written pricing before any work starts and a full-year guarantee on every repair. When your heat goes out on a damp winter night, call (361) 306-9515 and a live person answers, 24/7.
Why Dalton Heating & Air Is Tiburon’s Preferred Furnace Repair Company
Tiburon homeowners are done with no-shows and prices that change at the door. That’s the exact problem Dalton Heating & Air was set up to solve. We’re a Garrison Partners company operating under The Garrison Standard since 2003, which means every job in Tiburon follows the same discipline: arrive inside the stated window, put the price in writing before starting, do the work by the book, leave the site clean, and stand behind the repair for a full year.
Our technicians are background-checked and uniformed, so you know who is walking up your driveway before they knock. We service all nine major residential HVAC brands, including Goodman, Rheem, York, and Daikin, which matters in Tiburon because hillside homes off Paradise Drive and around Reed Ranch Road often have mixed-brand setups or older equipment that generic shops won’t touch. Marco Benitez leads our team with a simple rule: the repair is guaranteed in writing for a full year, and if it fails in that time, we return at no charge.
Response time to Tiburon is a real number, not a vague promise. We coordinate dispatch from our San Francisco Bay Area office and route crews into Tiburon the same day for no-heat calls whenever we have a technician available. You’ll also get a free second visit if the repair does not hold, which is part of the 365-Day Done Right Promise on every job.
Furnace Maintenance in Tiburon
Furnace Maintenance in Tiburon is less about heavy winter wear and more about protecting equipment that sits off for nine months of the year. Coastal fog and damp air corrode igniters and flame sensors while the furnace is idle, so the first cold snap often brings a lockout instead of heat. A maintenance visit in Tiburon includes cleaning the flame sensor, checking the igniter, testing the blower motor amp draw, inspecting the heat exchanger for cracks, and verifying the thermostat calibration. The cost for a tune-up in Tiburon runs $80 – $200, and that’s a flat price, not a doorway to upsells.
Flame Sensor and Igniter Service
Coastal moisture from the Bay is the biggest enemy of furnace ignition parts. A corroded flame sensor can’t confirm the burner lit, so the system shuts down as a safety measure. We clean or replace the sensor, test the igniter, and the furnace fires on the first attempt.
Heat Exchanger Inspection
Heat exchangers in Tiburon fail differently than in cold-climate cities because of low-use, high-condensation cycles. Rust and micro-cracks can form in the off-season without you seeing a symptom. We inspect every heat exchanger during maintenance because that’s the part that separates a repair call from a safety concern. Our Furnace Repair team takes this seriously on every Tiburon home.
Heat Pump Repair in Tiburon
Heat Pump Repair in Tiburon is a growing need because many hillside homes run heat pumps year-round for both heating and cooling. A heat pump that loses refrigerant or has a failing reversing valve will struggle to heat even in Tiburon’s mild winter, and that’s often misdiagnosed as a furnace problem. We check the outdoor unit, test the reversing valve, verify refrigerant levels, and confirm the system is actually switching modes correctly. Heat pump repair in Tiburon typically falls in the $150 – $700 range, depending on the component.
Refrigerant Recharge and Leak Check
A refrigerant recharge is topping off the fluid your heat pump needs to move heat. If the charge is low, there’s a leak, and we find it before adding refrigerant. Tiburon’s salt air accelerates coil corrosion, which is a common leak source on older Rheem and Goodman outdoor units.
Reversing Valve Diagnosis
The reversing valve is the part that tells the heat pump whether to heat or cool. When it sticks, the system might blow cold air in heat mode. We test the valve directly rather than guessing, because replacing a compressor over a $300 valve swap is the kind of mistake that gives this trade a bad name.
Trusted Brands We Service in Tiburon
We’re factory-trained to service all nine major residential HVAC brands, and in Tiburon we routinely work on Goodman, Rheem, York, and Daikin systems. We keep common replacement parts stocked for these brands, which means less waiting for parts to ship when your heat is out. Whether your home off Tiburon Boulevard has a newer Daikin heat pump or an older York furnace, our techs know the service history, the common failure points, and the right fix. Parts availability is a real thing in Tiburon because the hills add travel time, and we plan for it.
Written by Marco Benitez, Owner at Dalton Heating & Air, serving Tiburon and the surrounding Bay Area.
Common Furnace Repair Problems We See in Tiburon Homes
- Corroded igniters and flame sensors from coastal air. The fog off Richardson Bay carries salt and moisture that settle on ignition components. If your furnace tries to start but locks out within a few seconds, this is the most likely cause.
- Aging blower motors in older hillside homes. Homes off Mar West Street and around Belvedere often have furnaces from the 1990s with blower motors drawing rising amps. The symptom is noisy short-cycling or a limit trip that shuts the furnace down mid-cycle.
- Cracked heat exchangers from condensation cycles. A furnace that runs only a few weeks a year goes through repeated warm-up and cool-down cycles that create condensation inside the exchanger. Cracks develop slowly and only a visual inspection catches them before they become a safety issue.
- Thermostat miscalibration after years of low use. We often find thermostats that haven’t been touched since the previous winter and have drifted off calibration. The furnace is fine; the thermostat is telling it the wrong temperature.
Pricing for Furnace Repair in Tiburon, CA
Most furnace repairs in Tiburon run $150 – $700 depending on the part that failed. A flame sensor or thermocouple replacement sits at the lower end, a blower motor or gas valve at the higher end. Every job we do in Tiburon gets a written price before any work starts, and that price does not change when the tech arrives. Here’s the honest table:
| Service | Typical Cost in Tiburon |
|---|---|
| Furnace Repair | $150 – $700 |
| Tune-Up | $80 – $200 |
If the repair requires a part we don’t have on the truck, you’ll know the exact cost before we order it. Estimates are free, and calling (361) 306-9515 does not commit you to anything.
We Also Serve Cities Near Tiburon
Dalton Heating & Air serves Tiburon and the surrounding Bay Area. If you’re searching for Furnace Repair in Los Angeles, San Diego, San Jose, or San Francisco, our crews cover those markets too. Same written pricing, same full-year guarantee, same live person on the phone.
Serving Tiburon, CA - Our Local Coverage Area
We’re based in the Tiburon area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs About Furnace Repair in Tiburon
Repair is usually the right call in Tiburon, because your furnace simply doesn’t accumulate enough runtime to wear out like one in a cold-climate city. Before recommending replacement, we run a load calculation to confirm the existing tonnage is correct. A sooted flame sensor or failing blower motor does not mean the furnace is done. We got a no-heat call on a hillside home off Mar West Street where the furnace was short-cycling with a sooted flame sensor and a failing blower motor. After replacing the blower motor and recalibrating the thermostat, we ran a load calculation that confirmed the existing tonnage was right and repair was the honest call over replacement. Call (361) 306-9515 and we’ll give you the same straight answer for your system.
Repeated lockouts in Tiburon almost always trace to a corroded flame sensor or igniter, because the fog and marine moisture settle on ignition components while the furnace sits idle most of the year. The flame sensor can’t confirm the burner lit, so the control board shuts the system down as a safety measure. Cleaning the sensor is a quick fix, but if the igniter itself is failing, it needs replacement. Either way, the fix falls well within the $150 – $700 range. Call (361) 306-9515 for an exact quote – estimates are free.
A load calculation measures your home’s actual heating need, not the guesswork that went into sizing the original furnace. In Tiburon, the load is mild and the season is short, so a proper calculation usually shows the home needs less tonnage than owners assume. That changes the repair-or-replace decision. If a contractor tells you to replace a furnace without running a load calculation, you’re not getting an engineering answer, you’re getting a sales pitch. We run the numbers on every replacement quote and show them to you in writing.
SEER2 is the current efficiency rating for cooling, and higher numbers mean lower electricity use per hour of runtime. But in Tiburon, your heating bill is driven by gas and your cooling load is modest, so small differences in SEER2 between models often translate to only a few dollars a month. A high-efficiency system pays back much faster in a hot inland climate than it does on the Tiburon peninsula. When we quote a replacement, we’ll show you the honest math, not just the rating sticker. Call (361) 306-9515 and ask for Marco Benitez to walk you through it.
A furnace that makes unusual noises, smells like gas, or trips the limit switch needs urgent repair. A furnace that runs but hasn’t been serviced in over a year needs maintenance. Gas odor is the one exception: if you smell gas, leave the home and call the utility, then call us from outside. For everything else, a tune-up at $80 – $200 is the cheapest way to catch a corroded igniter or cracked heat exchanger before it becomes a no-heat night. Our techs are not paid on what they sell, so you’ll get a written report of what was actually found.
Written by Marco Benitez, Owner at Dalton Heating & Air, serving Tiburon since 2003.