Seasonal tune-up and full diagnostic on your Carrier, Trane, or Goodman system - readings shown to you before any repair is proposed
Diagnosis first, numbers second - you approve the repair price before a single part goes in.
Before
After
Before
After
Before
AfterFast, Reliable Furnace Repair Across Storrs
Furnace repair in Storrs, CT typically costs between $150 and $700, and most calls we take from Storrs homeowners can be scheduled the same day or next morning. If your heat is out and the temperature inside is dropping, call (361) 306-9515 right now. A live person answers, not a voicemail queue. We know the heating systems in Storrs’s older UConn-area rentals, the Colonials along Route 195, and the split-levels near Mirror Lake, and we stock the replacement parts most of those systems need before our truck rolls into your driveway.
Why Dalton Heating & Air Is Storrs’s Preferred Furnace Repair Company
Marco Benitez leads our Storrs furnace repair team, and he holds every technician to The Garrison Standard: arrive inside the stated window, put the price in writing before any work starts, do the job by the book, leave the site clean, and stand behind the repair for a full year. That’s not a pitch. It’s the operating code every Dalton tech carries on their clipboard.
Storrs homeowners call us after other companies no-show or change the price at the door. We answer with specifics: a written quote before the first tool comes off the truck, a written 365-Day Done Right Promise on every repair, and a free return visit if the fix doesn’t hold. Our Furnace Repair team services nine major residential brands, so the tech who arrives at your door in Storrs already knows the ignition sequence, gas valve, and control board on your unit, whether it’s a Goodman, Rheem, or York. Scheduling is coordinated through our Hartford metro office, but the crews dispatched to Storrs are local to the area and know the roads, the housing stock, and the way winter hits inland Connecticut harder than the shoreline.
Boiler Repair in Storrs
Boiler Repair in Storrs means dealing with hydronic systems you’ll find throughout the older housing stock near Storrs Center and the pre-war homes off Dog Lane. These aren’t forced-air furnaces with a blower and ducts. They circulate hot water through baseboard radiators or cast-iron radiators, and when heat stops, the cause is usually a failing circulator pump, an air-bound loop, or a zone valve that won’t open. We carry circulator cartridges, air vents, and replacement zone valves for the boiler brands common in this part of Tolland County, and a typical boiler repair in Storrs runs $150 to $700 depending on the part and the diagnosis time.
Circulator and Zone Valve Work
A boiler that short-cycles or leaves one room cold often has a circulator pump drawing high amps or a zone valve stuck closed. We test the electrical draw, check the loop for trapped air, and replace the failed part without draining your entire system when possible.
Baseboard Air Bleed and Expansion Tank Checks
Air in the loop creates that gurgling sound and cold spots along the baseboard. We bleed the loop, check the expansion tank charge, and confirm the pressure relief valve is operating. These are straightforward fixes that restore even heat fast, usually well under $300.
Gas Furnace Repair in Storrs
Gas Furnace Repair in Storrs covers the forced-air systems most common in the colonials and split-levels built from the 1960s through the 1990s along Route 195 and in the neighborhoods near Mansfield City Road. A gas furnace that won’t light, keeps tripping the limit switch, or runs but blows cold air has a specific failure point: an ignitor that’s cracked, a flame sensor caked with carbon, a gas valve that’s not opening, or a blower motor that’s done. Repair costs in Storrs run $150 to $700, and we always explain which piece failed, why it failed, and what your options are before we touch anything.
Ignitor and Flame Sensor Replacement
A glowing ignitor that won’t reach temperature or a flame sensor reading microamps too low will keep your furnace locked out. We replace ignitors and clean or replace flame sensors on Goodman, Rheem, Daikin, and York units regularly, and the parts are on our truck when we arrive in Storrs.
Gas Valve and Limit Switch Diagnostics
When the furnace lights and then shuts down after a minute or two, the gas valve or high-limit switch is usually not doing its job. We verify manifold gas pressure, test the valve coil, and confirm the limit switch is opening and closing at the right temperature before recommending a repair.
Trusted Brands We Service in Storrs
Our technicians are factory-trained on Goodman, Rheem, York, and Daikin, and we carry the common repair parts for those brands in our trucks so a Storrs homeowner isn’t waiting two days for a capacitor or pressure switch to ship. That local parts stock matters in January. If your furnace is one of those brands, the odds are high we have the ignitor, the flame sensor, or the blower motor capacitor on hand when we pull up to your house near Bone Mill Road or along Gurleyville Road.
Common Furnace Repair Problems We See in Storrs Homes
- Oversized furnaces short-cycling in older UConn-area rentals. Many homes around the campus were equipped years ago by square-footage guesswork, not a load calculation. The furnace fires, hits temperature in eight minutes, shuts off, and repeats all day. The heat exchanger pays for that with thermal stress, and replacement heat exchangers in Storrs run at the upper end of the $150 – $700 repair range.
- Blower motor and capacitor failures during long cold snaps. Inland Connecticut winter design temperatures push furnaces to run longer, harder cycles than coastal systems. Motors and capacitors that were fine through November give out in February, usually after a stretch of single-digit nights.
- Boiler circulator failures in pre-war Storrs Center housing. A no-heat call in a house with hydronic baseboard looks like a furnace problem until you check the pump. A seized circulator or air-bound loop is common in the older homes around Storrs Center, and it needs a boiler tech, not a furnace swap.
- Duct pressure problems in partially renovated homes. When a Storrs homeowner adds insulation or replaces windows, the heating load drops, but the furnace and the duct static pressure were never re-balanced. Rooms get uneven heat, and the furnace cycles more often than it should.
Pricing for Furnace Repair in Storrs, CT
Most furnace repairs we complete in Storrs land between $150 and $700. A flame sensor cleaning on a Rheem usually sits near the bottom of that range. A blower motor replacement on a York runs higher. A heat exchanger replacement, which we don’t do lightly and only after showing you the crack or the combustion-analysis readings, can reach the top of that range or push beyond it in rare cases.
| Service | Typical Cost in Storrs |
|---|---|
| Furnace Repair | $150 – $700 |
| Boiler Repair | $150 – $700 |
| Furnace Tune-Up | $80 – $200 |
What changes the number is which part failed and whether the system needs combustion analysis to confirm it. We hand you the written price before we start, and it doesn’t change at the end. Call (361) 306-9515 for a free estimate on furnace repair in Storrs.
The Load Calculation Question in Storrs
Storrs sits in a pocket of inland eastern Connecticut where winter design temperatures run several degrees colder than Hartford or the shoreline, and the UConn campus-area housing stock includes a lot of older, partially updated homes with original ductwork or hydronic baseboard. That means furnace and boiler sizing here can’t be copied from a metro Hartford rule of thumb. A real load calculation, not an educated guess from square footage, often changes the equipment recommendation on a Storrs furnace call.
On a no-heat call off Hunting Lodge Road near the UConn campus, our tech found a Carrier gas furnace short-cycling: the blower motor was drawing high amps and the heat exchanger showed signs of stress after years of oversized operation. We ran a load calculation, confirmed the existing unit was oversized for the actual envelope, and walked the homeowner through repair-versus-replace with the SEER2-era efficiency math before they decided. A properly sized replacement and corrected static pressure brought the cycle times back into normal range. That’s the difference between a parts-swapper and a heating company that reads the whole system.
We Also Serve Cities Near Storrs
Our furnace and boiler technicians cover Storrs and the surrounding area, including Bridgeport, Stamford, New Haven, and Hartford. If you’re in one of those cities or anywhere else near Furnace Repair in Storrs, the same written-price standard and 365-Day Done Right Promise apply. Call (361) 306-9515 and we’ll route the nearest available tech to you.
Serving Storrs, CT - Our Local Coverage Area
We’re based in the Storrs area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs About Furnace Repair in Storrs
Short-cycling in a Storrs home is most often caused by an oversized furnace, and the right answer depends on what the load calculation shows. If the unit is oversized for the actual heating load, replacing it with a properly sized system solves the cycling problem permanently. If the short-cycling is caused by a bad flame sensor, a clogged filter, or a limit switch tripping too early, a repair between $150 and $700 fixes it. We run the numbers before recommending either path. Call (361) 306-9515 to have a tech check it in person.
Yes, and it changes it more often in Storrs than in most Connecticut towns because of the colder inland design temperatures and the mix of older UConn-area housing stock with partial updates. A furnace that was sized right for a drafty 1980s house becomes oversized after new windows and added attic insulation. The load calculation accounts for the actual envelope and the local climate, and yes, it frequently changes whether we recommend repair or replacement. We include it on no-heat calls where the unit is operating but struggling.
SEER2 is the current efficiency testing standard for HVAC equipment, and it’s calculated under conditions closer to real-world ductwork and static pressure than the old SEER rating. For a furnace, the heating-side number that matters more is AFUE, but SEER2 matters when you’re replacing a furnace and a central air system together. A higher-efficiency unit uses less fuel for the same heat output, and in a colder inland climate like Storrs, that difference shows up in every January bill. We’ll show you the annual operating cost difference between repair and replacement before you decide.
Yes. We handle boiler and hydronic baseboard systems throughout Storrs, including the older homes in Storrs Center and the neighborhoods off Dog Lane. A no-heat call on a hydronic system is usually a circulator pump, an air-bound loop, or a zone valve, not the boiler itself. We diagnose and repair those without trying to sell you a furnace you don’t need.
A furnace repair in Storrs runs $150 to $700 for most jobs. A full furnace replacement in the current Storrs market starts around $3,500 and goes up from there depending on efficiency, brand, and duct modifications. When repair cost approaches half the replacement cost and the unit is more than 15 years old, replacement is usually the better long-term move. We’ll give you the written numbers for both options and let you decide. Call (361) 306-9515 for a free estimate.
Call Dalton Heating & Air for Furnace Repair in Storrs
If your furnace is down in Storrs, pick up the phone. A live person answers at (361) 306-9515, day or night. We’ll get a background-checked, uniformed technician to your home inside the stated window, put the repair price in writing before we start, and back the fix with a full-year written guarantee. That’s The Garrison Standard, and Marco Benitez enforces it on every single call we run in Storrs.
Written by Marco Benitez, Owner at Dalton Heating & Air, serving Storrs, CT.