Seasonal tune-up and full diagnostic on your Carrier, Trane, or Goodman system - readings shown to you before any repair is proposed
Diagnosis first, numbers second - you approve the repair price before a single part goes in.
Before
After
Before
After
Before
AfterFast, Reliable Furnace Repair Across Manor
Furnace repair in Manor, TX typically runs $150 – $700 depending on the part that failed, and most repairs are completed in a single visit. Dalton Heating & Air has crews that roll into Manor daily, familiar with the ranch homes, new builds, and mixed-age furnaces across the area. If your heat is out and the house is cold, call (361) 306-9515 now. We answer with a live person, 24/7, and we’ll get a background-checked tech headed your way.
Manor is not a place where you can afford to wait out a furnace problem. January nights drop into the 30s, and a gas furnace that won’t fire turns a house into an icebox by morning. Our Furnace Repair team dispatches from our Austin office, and we run calls across Manor every day, which means we’re rarely far from your street.
Why Dalton Heating & Air Is Manor’s Preferred Furnace Repair Company
Dalton Heating & Air has been a Garrison Partners company since 2003, and every call we run is held to The Garrison Standard. That is not a slogan. It means a written price before any work begins, on every job, without exception. It means the repair itself is guaranteed in writing for a full year through our 365-Day Done Right Promise, and if the repair fails inside that window, we return at no charge. Manor homeowners don’t have to ask for these terms. They’re automatic.
Every technician who shows up at a Manor door is background-checked, uniformed, and factory-trained to service nine major brands: Carrier, Trane, Lennox, Goodman, Rheem, York, Daikin, Bryant, and American Standard. You know who is coming before they arrive. And our phone staff at (361) 306-9515 is a real person at a desk, not a voicemail queue, at 3 p.m. or 3 a.m. We serve Manor with the same discipline we bring to every Garrison Partners location, led locally by Marco Benitez.
Boiler Repair in Manor
Boiler Repair in Manor is a less common call than furnace work, but it shows up in older ranch houses and a handful of converted homes near downtown. A boiler in this part of Central Texas usually heats water for radiators or baseboard loops, and when the circulator pump fails or the zone valve sticks, one end of the house goes cold while the thermostat keeps calling for heat. Most Manor boiler repairs fall inside the $150 – $700 range, though a failed circulator on an older unit lands closer to the top of that spread. We diagnose the actual failed part before quoting anything.
Circulator and Zone Issues
A dead circulator pump is the classic no-heat boiler call. We bench-test the relay, confirm voltage at the pump, and replace only what failed. A stuck zone valve that will not open gets the same treatment: tested, cleaned or replaced, never swapped on a guess.
Boiler Pressure and Leak Checks
Low system pressure on a Manor boiler usually means a small leak at a valve, an air vent, or an old expansion tank. We find it, fix it, and re-pressurize to the manufacturer’s spec. We also check the relief valve so the system is safe before we leave.
Gas Furnace Repair in Manor
Gas Furnace Repair in Manor is the bread-and-butter call from late October through February. Almost every home here heats with natural gas, and the failures we see most often are ignitors, flame sensors, gas valves, and blower motors. A typical gas furnace repair in Manor runs $150 – $700. A failed hot-surface ignitor is on the low end, around $280 – $400 installed. A failed blower motor lands higher. We give you the exact written price before any part is ordered or any cover comes off.
Ignitor and Flame Sensor Failures
The most common no-heat call starts with the furnace clicking or trying to light and then shutting down. That is almost always a cracked ignitor or a dirty flame sensor. We replace the ignitor, clean the sensor, and test the full startup sequence through three complete cycles before we call it done.
Gas Valve and Burner Repairs
If the ignitor glows and the gas valve never opens, the problem is upstream in the valve or its signal path. We verify incoming gas pressure at the manifold, check the valve’s coil resistance, and confirm the control board is sending the call for heat. We replace gas valves by the book, with a combustion test afterward. Gas work is not a DIY job: a miswired or leaking valve is a genuine hazard, so this one belongs in the hands of a trained tech, period.
Trusted Brands We Service in Manor
Our techs are factory-trained on the furnaces Manor homes actually have, including Rheem, York, Daikin, and Bryant. That means when a Rheem gas furnace off a 2012 build needs a new control board or a York 80% unit on a ranch near Wilbarger Creek starts short-cycling, we already know the part numbers and the failure patterns. We keep common ignition and safety components on the trucks, so a no-heat call often gets fixed the same visit instead of waiting on a parts house run. If a part is not on the truck, we source it locally and get back out fast.
Common Furnace Repair Problems We See in Manor Homes
- Oversized furnaces short-cycling: A lot of Manor homes, especially the ones built fast in the 2000s and 2010s, got furnaces that are too big for the actual heating load. The unit hits setpoint in minutes, shuts off, and fires again a half hour later. That cycling murders heat exchangers and makes parts fail early. We check the load and the static pressure before we replace parts, because the right fix is sometimes a smaller piece of the puzzle than a whole new furnace.
- Failed ignitors misdiagnosed as dead boards: We have lost count of the Manor calls where another company quoted a full replacement or a control board, and the real problem was a cracked hot-surface ignitor or a flame sensor caked with carbon. One specific no-heat call off a Manor street stands out: the homeowner had already been quoted a full system replacement, and our tech found a failed hot-surface ignitor and a weak capacitor on an older Goodman gas furnace, about a $280 repair instead of a $6,000 install. We tested the heat exchanger, checked static pressure against the ductwork, and confirmed the unit still heated the house on the design-day load before recommending any replacement.
- Duct and static-pressure problems disguised as furnace faults: Restricted airflow on a Manor ranch home will trip the high-limit switch, which looks exactly like a bad blower motor or a control failure. If we don’t measure static pressure when we’re in the cabinet, we’d be guessing. So we measure it. A clogged filter, a crushed return, or undersized ductwork is a cheaper and more honest fix than a blower motor that was never the problem.
- Heat exchanger stress from short cycling: We already said it: the oversized furnace cycles too often, and the heat exchanger pays the price. The metal expands and contracts, cracks form, and then you have a real safety concern. In Manor’s climate, with winter temps swinging from 70°F days to 28°F nights, the cycling gets worse because the load changes so quickly. If we find a cracked exchanger, we say so plainly and show you why. That is a safety issue, not a sales pitch.
Pricing for Furnace Repair in Manor, TX
Manor furnace repair pricing breaks down like this in our experience:
| Service | Typical Price Range |
|---|---|
| Furnace Repair (diagnostic + repair) | $150 – $700 |
| AC Repair | $150 – $650 |
| Tune-Up | $80 – $200 |
| AC Installation | $3,500 – $7,500 |
The spread exists because a flame sensor cleaning costs far less than a gas valve replacement. What doesn’t change is the process: we diagnose first, we hand you a written price before any work starts, and that price does not move. Estimates are free. Call (361) 306-9515 and we’ll give you an exact number for your furnace, not a ballpark.
We Also Serve Cities Near Manor
Our furnace repair crews cover Manor and the surrounding communities, including Pflugerville, Elgin, Hutto, and parts of Austin. If you’re in one of those areas and your furnace quits, the same written-price guarantee and one-year repair warranty apply. For the full scope of our work, see our Furnace Repair page or call the number on this page.
Serving Manor, TX - Our Local Coverage Area
We’re based in the Manor area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs About Furnace Repair in Manor
Repair if the fix is under $700 and the heat exchanger is intact. Replace if the exchanger is cracked, the unit is over 15 years old and parts are getting scarce, or a proper load calculation shows the furnace never matched the house in the first place. Manor sits in mixed Central Texas ranch and new-build country where most homes were built without a proper Manual J load calculation, so a right-sized furnace here is often one tonnage smaller than the box a contractor would otherwise sell. That changes the math: before you let anyone quote you a replacement, ask for the load numbers and a static pressure test. Call (361) 306-9515 and we’ll run the test before we recommend anything.
Most Manor furnace repairs land between $150 and $700. A failed ignitor is usually $280 – $400. A gas valve or blower motor pushes the high end. You’ll get a written quote before any work starts, so the number is fixed, not a guess.
Usually because it’s oversized for the house, a common Manor problem when the original install skipped a load calculation. The furnace heats the space too fast, shuts down, and starts again minutes later. That cycling stresses the heat exchanger and shortens the life of every part. A proper tonnage check and static pressure test shows whether the furnace is too big or whether something else, like a clogged filter or a dirty flame sensor, is causing the short cycle.
SEER2 is a cooling efficiency metric, so it applies to the AC side of a system. For a furnace, the number that matters is AFUE, annual fuel utilization efficiency. An 80% furnace wastes 20 cents of every gas dollar; a 96% furnace wastes 4 cents. In Manor, where winters are short but sharp, the efficiency difference shows up on your gas bill in December and January. If we’re discussing replacement, we’ll show you the AFUE and the payback in real dollars, not in vague percentages.
We run calls in Manor daily, so same-day service is common for no-heat emergencies, especially if you call before noon. We answer the phone with a live person 24/7 at (361) 306-9515, not a call center menu. When your house is cold and the temperature outside is dropping, we treat that call as the priority it is, with no overtime charge for emergency service.
Written by Marco Benitez, Owner at Dalton Heating & Air, serving Manor, TX and the surrounding area since 2003.