Furnace Repair in Fort Myers - On-Site Today, Diagnosis First

Fast, Reliable Furnace Repair Across Fort Myers

Most furnace repair in Fort Myers runs between $150 and $700 depending on the part that failed and how long the diagnosis takes. Our crew answers calls from a live person 24/7 and typically reaches homes across Fort Myers the same day a no-heat call comes in. If your system is blowing cold air on a February morning, call (361) 306-9515 and we’ll get a tech to you fast. We carry a full-year written guarantee on every repair, and the price goes in writing before any work starts.

Call (361) 306-9515

A quick note on what a “furnace” usually is in Fort Myers: in this climate, most homes run heat pumps year-round, not gas-fired furnaces. So when a Fort Myers homeowner calls about furnace repair, the actual problem is often a heat pump stuck in cooling mode, a bad heat strip, or a worn blower motor. Our Furnace Repair team is trained to diagnose all of that, and we don’t sell you a gas-furnace fix you don’t need.

Why Dalton Heating & Air Is Fort Myers’s Preferred Furnace Repair Company

We’ve been a Garrison Partners company since 2003, and every job in Fort Myers runs under The Garrison Standard: arrive inside the stated window, put the price in writing before starting, do the work by the book, leave the site clean, and stand behind the repair for a full year. That’s not a marketing promise. It’s a written guarantee on every service call, and if the repair fails within that year, we return at no charge.

Every tech who shows up at your door is background-checked, uniformed, and factory-trained to service nine major HVAC brands, including Carrier, Trane, Lennox, Goodman, Rheem, York, Daikin, Bryant, and American Standard. You’ll know who is coming before they arrive. Our dispatchers know Fort Myers neighborhoods: we schedule calls in the Villas, McGregor corridor, Gateway, and down toward San Carlos Park, and we route techs so you’re not waiting through a four-hour window.

Marco Benitez leads the team that services Fort Myers, and he holds every tech to The Garrison Code. What that means for you: a tech who shows up on time, diagnoses the actual problem, gives you a written price, and doesn’t push a replacement you don’t need. Dispatch and scheduling are coordinated from our Miami (South FL) office, but the crews working in Fort Myers live and work in this market.

Heating Repair in Fort Myers

Heating repair in Fort Myers usually means fixing a heat pump that won’t switch to heating mode, a backup heat strip that won’t fire, or a blower motor that’s given out after years of near-constant runtime. In this CZ2A hot-humid climate, the same motor that moves cool air through your house all summer also moves warm air in winter, so it wears out faster than it would in a northern city. A failed reversing valve is the number one winter no-heat call we see in Fort Myers: the heat pump runs, but it’s still pumping cold air. A failed sequencer on the electric backup strips is a close second, and it often goes unnoticed until a 40-degree morning.

Most heating repairs in Fort Myers run $150 to $700, with the lower end covering things like a capacitor or ignitor replacement and the upper end covering a blower motor or reversing valve. We always give you a written price before any work begins, and the repair is guaranteed in writing for a full year. If it fails in that time, we come back at no charge.

Heat Pump Reversing Valve Replacement

A reversing valve is the part that tells a heat pump whether to move heat into the house or out of it. When it fails in Fort Myers, the symptom is almost always the same: the thermostat says heat, the outdoor unit runs, and cold air comes out of the registers. Replacing one involves recovering the refrigerant, swapping the valve, re-brazing the lines, pulling a vacuum, and recharging the system by weight. It’s a job for a trained tech with the right gauges and a recovery machine, not a Saturday DIY.

Electric Backup Heat Strip Repair

Heat pumps carry the full heating load in Fort Myers most of the year, so the electric backup strips only fire during cold snaps. That’s exactly when a bad sequencer or a tripped breaker gets discovered: the heat pump runs but can’t keep up, the strips are supposed to kick in, and nothing happens. We test the sequencer, the breaker, and the wiring, then replace only what’s actually failed. A typical heat strip repair in Fort Myers runs $150 to $450.

Boiler Repair in Fort Myers

Boiler repair in Fort Myers is rare compared to northern cities, but a handful of older homes in the McGregor Boulevard corridor and along the Caloosahatchee still run hydronic systems, and a few newer custom builds have boilers for radiant floor heat. When a boiler acts up, it’s usually a circulator pump that’s seized, a pressure relief valve that’s weeping, or a limit switch that short-cycled. These are not systems to guess at: a boiler under pressure is a different animal than a forced-air furnace, and the safety controls have to be tested, not bypassed.

Boiler repair in Fort Myers runs $150 to $700 depending on the part. A stuck circulator pump on the lower end, a failed gas valve or control board on the higher end. We don’t see many boilers here, which is exactly why you want a tech who treats it carefully and follows the manual, not someone who’s going to wing it. Every boiler repair gets the same written price, the same written one-year guarantee, and the same free return visit if the repair fails.

Circulator Pump and Zone Valve Repair

A boiler that fires but doesn’t move heat usually has a failed circulator pump or a stuck zone valve. We check the pump with an amp clamp, verify the zone valve is opening, and bleed air from the loops. In Fort Myers, where boilers sit idle most of the year, seals can dry out and pumps can seize from disuse, so we also check the pump’s capacitor and impeller while we’re in there.

Boiler Safety Control Check

When we do any boiler repair in Fort Myers, we test the pressure relief valve, the high-limit switch, and the low-water cutoff as part of the job. A boiler that’s been sitting for months in a Florida garage sees corrosion and sediment buildup that a northern boiler doesn’t. We’ll tell you what we found and what it costs before we touch anything. No pressure on replacement: if it’s fixable, we fix it and guarantee it in writing for a year.

Trusted Brands We Service in Fort Myers

Our techs are factory-trained on nine major residential brands, and in Fort Myers we work on a lot of Rheem, York, Daikin, and Bryant systems, along with Carrier, Trane, Lennox, and Goodman. We keep common parts for these brands stocked on our local trucks: capacitors, sequencers, contactors, ignitors, flame sensors for the few true gas furnaces in the area, and blower motors. That means most repairs in Fort Myers are done in a single visit, not a diagnosis plus a return trip after a part gets ordered. If we need a part we don’t carry, we tell you that upfront, in writing, before you pay for anything.

Common Furnace Repair Problems We See in Fort Myers Homes

• Heat pump stuck in cooling mode. The reversing valve fails, and suddenly your “furnace” is blowing cold air. This is the #1 winter no-heat call in Fort Myers, and it’s not something a gas-furnace tech from up north sees often. We diagnose it with a pressure check and a thermostat signal test, then either replace the valve or, if it’s a coil issue, tell you straight what’s actually wrong.
• Backup heat strips that won’t fire. Fort Myers heat pumps run all year, but the electric backup strips only come on during cold snaps, which is when you find out they failed months ago. A bad sequencer or a tripped breaker usually means the strips never turn on, and the heat pump can’t keep up when the outdoor temp drops into the 40s.
• Blower motor and capacitor wear. Your system runs cooling for roughly 9-10 months a year in Fort Myers, so the blower motor that moves A/C air all summer also moves heat in winter. Capacitors fail, motors overheat, and the system shuts down. We check the capacitor first, then the motor’s amp draw, before recommending anything.
• Clogged condensate line causing lockout. Florida humidity means every air handler in Fort Myers makes condensate, and a clogged drain line can trip a float switch that shuts down the whole system, including heat. We clear the line, flush it, and check the switch so it doesn’t happen again on the next muggy week.

Pricing for Furnace Repair in Fort Myers, FL

We Also Serve Cities Near Fort Myers

If you’re in North Fort Myers, Cape Coral, Lehigh Acres, or Estero, we handle Furnace Repair in Fort Myers and the surrounding communities with the same quick response and written pricing. Same crews, same one-year written guarantee, same no-surprise estimate. Call (361) 306-9515 and a live person answers, day or night.

FAQs About Furnace Repair in Fort Myers