Seasonal tune-up and full diagnostic on your Carrier, Trane, or Goodman system - readings shown to you before any repair is proposed
Diagnosis first, numbers second - you approve the repair price before a single part goes in.
Before
After
Before
After
Before
AfterHVAC Company in Coral Springs, FL
Dalton Heating & Air handles HVAC repair, replacement, and installation across Coral Springs, FL. Most homes here are single-family concrete block or frame builds from the 1970s through the early 2000s, which means two things on nearly every job: undersized return ducts and original condenser pads now sinking into sandy fill. You can call us at (361) 306-9515 any hour, and a live person answers. Our three core Coral Springs services are linked just below, each with its own dedicated page.
Key Takeaways:
- AC repair in Coral Springs typically lands between $150 and $650, with most calls under $400.
- Every repair carries a written one-year guarantee; if it fails in that window, we return at no charge.
- Coral Springs humidity and limestone-heavy fill change how systems age, and how we diagnose them.
- We service Carrier, Trane, Lennox, Goodman, Rheem, York, Daikin, Bryant, and American Standard units.
Why Coral Springs Homes Are Different
Coral Springs sits on the edge of the Everglades, and the soil underneath a lot of this city is a mix of sand, muck, and limestone. That matters for HVAC in a way that never shows up on a spec sheet: condenser pads settle. When a pad tilts more than a couple of degrees, the compressor inside works off-axis, oil doesn’t circulate the way it should, and the unit runs hot. Homes in the Wyndham Lakes, Ramblewood, and Cypress Run neighborhoods especially show this, because so many original pads were poured directly onto un-compacted fill.
The other constant here is humidity. Coral Springs air is wet nearly year-round, which pushes evaporator coils harder than dry-climate heat ever would. A coil that would last fifteen years in Phoenix might go twelve here before pinhole leaks start. We see that on service calls from the Pines to Maplewood: the failure isn’t the compressor, it’s a corroded aluminum coil sweating in crawlspace-grade humidity. Duct sizing is the third recurring issue. Homes built before the mid-1990s along Riverside Drive and Wiles Road frequently run a single undersized return, which chokes airflow and shortens blower motor life. None of this is unique to one street, but it is the pattern that separates Coral Springs from the beach-side cities east of us.
Our Main Coral Springs Services
These are the two calls we run most often in Coral Springs, plus the occasional cold-snap furnace repair. Each has its own Coral Springs page with full pricing and detail.
AC Repair in Coral Springs
The dominant call in Coral Springs is an AC system that’s running but not cooling, or running constantly and never reaching setpoint. That second symptom, in this humidity, is usually a charge issue or an airflow restriction, not a bad compressor. We diagnose the system, not the guess. Work starts with a written price, and the repair is covered by our one-year guarantee. If a repair doesn’t hold, the second trip is on us. AC Repair in Coral Springs has the full breakdown.
Heat Pump Installation in Coral Springs
Coral Springs weather makes a heat pump a sensible replacement for an aging straight-cool system: one unit that cools through July and heats on the handful of nights when it drops into the 40s. Installations run through a load calculation first; we never size a replacement by square footage alone, especially in Coral Springs where three-bedroom homes on the east side can carry different heat loads than identical floorplans further west. Pricing is written and fixed before any equipment is ordered. Details on the process are on Heat Pump Installation in Coral Springs.
Furnace Repair in Coral Springs
Heat pumps cover most Coral Springs heating loads, but plenty of older homes still run gas furnaces, and when a cold front drops the overnight low into the 30s, those furnaces get tested for the first time in months. A failed igniter or a dirty flame sensor is a common find. Repairs carry the same written one-year guarantee as everything else we touch, and the parts we replace are spec’d to the unit, not to what’s on the truck. Furnace Repair in Coral Springs covers what to expect.
What happens when you call
- 1
A real person answersNo phone trees - you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Brands We Service in Coral Springs
Our technicians are factory-trained on all nine major residential brands. On a Coral Springs call, the relevant parts for Goodman, Rheem, York, and Daikin units are usually on the truck or available the same day, which keeps most repairs to a single visit. We never adapt a part that wasn’t built for the system. See our brands for the full breakdown of what we service.
Pricing for HVAC Company in Coral Springs, FL
Numbers below are what Coral Springs homeowners should expect, based on the work we actually see here. Every one is a range; the exact figure gets put in writing before any work starts.
| Service | Typical range in Coral Springs |
|---|---|
| AC repair (capacitor, contactor, or sensor) | $150 – $350 |
| AC repair (refrigerant recharge with leak search) | $250 – $650 |
| Furnace repair (igniter, flame sensor, or pressure switch) | $150 – $450 |
| Furnace repair (blower motor or gas valve) | $300 – $700 |
| AC installation (full system, 2 to 3.5 tons) | $3500 – $5500 |
| AC installation (full system, 4 to 5 tons) | $4500 – $7500 |
| Heat pump installation (2 to 3 tons) | $4000 – $6500 |
| Heat pump installation (4 to 5 tons) | $5500 – $7500 |
| Tune-up (maintenance inspection with coil cleaning) | $80 – $200 |
What pushes a Coral Springs repair toward the top of a range is usually access: a condenser crowded into an overgrown side yard or a furnace in a tight closet deep inside the house. What does not push it: the time of day or the season. We don’t charge overtime, and the price you get before the work is the price you pay after.
Neighborhoods We Serve in Coral Springs
We run calls across the full width of Coral Springs. Most residential visits fall within a 30-minute arrival window from the start of the dispatch, though heavy weather on I-595 or the Sawgrass can stretch that. These are the neighborhoods we visit most often.
- Wyndham Lakes
- Ramblewood
- Cypress Run
- Maplewood
- The Pines
Service Area – Cities Near Coral Springs
Coral Springs sits near the top edge of Broward County, and we route calls into the neighboring cities daily. If you’re south of the county line, check our coverage in Margate, FL and Coconut Creek, FL. East of Coral Springs, we cover Pompano Beach, FL. West and south, Plantation, FL is within range. Dispatch for this area is coordinated from our Miami (South FL) office; technicians reach Coral Springs locally.
Serving Coral Springs, FL - Our Local Coverage Area
We’re based in the Coral Springs area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs About HVAC Company in Coral Springs
Most Coral Springs calls get a same-day or next-day visit, depending on the time you call and what’s already scheduled in the area. Emergency calls, meaning no cooling in a home with vulnerable occupants or a complete system failure, are prioritized. Call (361) 306-9515 and a live person will give you a straight answer.
Yes. We need someone at the property to walk through what was found and approve the written price before any work begins. That’s the Garrison Code: no price in writing, no work. If you can’t be there, we can schedule for a time when you can.
Yes. The City of Coral Springs requires permits for system replacements and most mechanical work beyond a basic repair. We pull the permit as part of the installation job; the paperwork is handled on our side, and the price you’re quoted includes the permitting cost. Repairs that don’t involve structural or code changes don’t require one.
We cover Coral Springs proper plus the surrounding cities: Margate, Coconut Creek, Pompano Beach, and Plantation. If you’re unsure whether your neighborhood is in range, call (361) 306-9515 and we’ll confirm while you’re on the phone. Estimates are always free.
If your Coral Springs system needs work, call (361) 306-9515 for a free estimate. The price gets put in writing before anything starts, and every repair carries our written one-year guarantee.
What happens when you call
- 1A real person answersNo phone trees - talk to a local hvac pro.
- 2You get an upfront price rangeHonest numbers before anyone is dispatched. No surprises.
- 3We come out and measureLicensed & insured, at a time that suits you - the visit and the quote are both free.
- 4You get the price in writingLine-itemed, yours to keep, and nothing starts until you say go.
What Coral Springs Customers Say
"Coil cleaning and a refrigerant check before summer. AC has never been this cold."
- Marty D."Good communication, tidy, and disciplined work. Taped off the floor and wiped the unit down."
- Karen J."Installed a heat pump to replace an old oil furnace. Three clear quotes and the install crew was tidy."
- Cheryl B.