Seasonal tune-up and full diagnostic on your Carrier, Trane, or Goodman system - readings shown to you before any repair is proposed
Diagnosis first, numbers second - you approve the repair price before a single part goes in.
Before
After
Before
After
Before
AfterFast, Reliable Heat Pump Installation Across Miramar
A new heat pump installation in Miramar typically runs $3,500 to $7,500, and most homes are back to full climate control within one to two days once equipment arrives. That price covers the outdoor condenser, indoor air handler, refrigerant lines, thermostat integration, and full commissioning. We serve every corner of Miramar, from Silver Lakes to the neighborhoods off Miramar Parkway and Douglas Road, and we also offer our AC Repair in Miramar for existing systems. Call (361) 306-9515 and we’ll give you a written price before any work starts.
Miramar’s cooling season runs long and hard. That changes how a heat pump should be specced, and it’s why we don’t treat a heat pump install here the same way we would in a colder market. You need a unit sized for the cooling load first, with a heating mode that handles the handful of truly cold nights Broward County gets each winter. Get that wrong and you’ll feel it on your FPL bill every month.
Why Dalton Heating & Air Is Miramar’s Preferred Heat Pump Installation Company
Dalton Heating & Air has been part of the Garrison Partners network since 2003, every job held to The Garrison Standard: arrive inside the stated window, put the price in writing before starting, do the work by the book, leave the site clean, and stand behind it for a full year. Miramar homeowners call us because the price we quote is the price you pay, on paper, before the first panel comes off the wall.
Our Heat Pump Installation team works with factory-trained technicians who service nine major brands including Rheem, York, Daikin, and Bryant. Every crew member is background-checked and uniformed, so you know who is stepping onto your property. When you call, a live person answers, 24/7, not a voicemail tree.
Marco Benitez, who leads our Miramar crews, has seen the same pattern play out across hundreds of South FL installs: a homeowner gets a straight-swap quote, nobody runs a load calculation, and a year later the system is short-cycling in July humidity. That does not happen on a Dalton job. We measure before we quote.
Mini Split Installation in Miramar
Mini split installation in Miramar is the right answer for a lot of homes here, especially 1990s and 2000s builds where only part of the house gets conditioned or where ductwork was never run to a converted garage or Florida room. A ductless mini split gives you zoned temperature control without tearing into drywall to add ducts where none exist. In Miramar, mini split systems also make sense for homes with aging ductwork that leaks conditioned air into a hot attic.
What a Mini Split Install Involves
We mount an indoor air handler on the wall or ceiling in the target room, run a small refrigerant line set through a three-inch opening in the exterior wall, and set the outdoor condensing unit on a pad or bracket outside. The indoor and outdoor units connect through that line set. No ductwork, no major construction. Most single-zone installs finish in a day. Multi-zone systems covering three or four rooms take longer, and cost climbs accordingly within the $3,500 to $7,500 range for typical Miramar homes.
When to Consider a Mini Split
If one side of your house never cools evenly, if your upstairs bedrooms run five degrees warmer than the living room, or if a converted garage or enclosed patio is outside your existing duct layout, a mini split is the direct fix. It is also the right call for homes where the ductwork has leaky seams or poor insulation in the attic, which is common in Miramar’s older subdivisions.
Heat Pump Maintenance in Miramar
Heat pump maintenance in Miramar should happen twice a year, ideally before the humid season and again before the short winter heating stretch. A standard tune-up runs $80 to $200 and covers coil cleaning, refrigerant level verification, electrical connection inspection, condensate drain clearing, thermostat calibration, and a check of the reversing valve. For a heat pump, the reversing valve is the component that swaps the system between cooling and heating mode; when it sticks, you’ll get hot air in July or cold air in January.
What the Tech Actually Checks
During a heat pump tune-up, our technician measures refrigerant pressures against manufacturer specs, checks amp draw on the compressor and both fan motors, and inspects the outdoor coil for salt and debris buildup. Miramar’s air carries salt from the coast and fine dust from the Everglades, so coils here need cleaning more often than inland areas. A dirty coil raises head pressure and burns more electricity while moving less heat.
Why Two Visits a Year Matters Here
South Florida’s cooling season runs nearly year-round, and a heat pump that runs ten months out of twelve wears components faster than one up north that sits idle half the year. Capacitors dry out in the heat, contactors pit, and coil fins corrode in humidity. A $150 tune-up catches a $900 compressor failure before it happens. We also check the system’s static pressure, because that number tells us whether the ductwork itself is choking the system.
Trusted Brands We Service in Miramar
Dalton Heating & Air technicians are factory-trained on Rheem, York, Daikin, Bryant, and five other major residential brands. That factory training matters because modern heat pump controls are not interchangeable. A Daikin inverter board does not communicate with a York thermostat the same way. We stock common parts and refrigerant linesets for Miramar installs, which keeps turnaround tight when a part is needed mid-job. You will not get a call halfway through an install telling you the job is paused until a distributor opens Monday.
Common Heat Pump Installation Problems We See in Miramar Homes
- Oversized units from a straight swap. A previous contractor replaces a 3-ton unit with a 4-ton because “bigger is better.” In Miramar’s humidity, an oversized system short-cycles: it cools the air fast but never runs long enough to pull moisture out, leaving the house cool and clammy at the same time.
- Undersized ductwork choking the new system. Builders in 1990s Miramar subdivisions often ran a single undersized return for the whole house. A new heat pump connected to that same return pushes against high static pressure, so airflow drops, the coil ices up, and the system never reaches the efficiency it was rated for.
- Skipped refrigerant charge verification at commissioning. A heat pump that leaves the factory with a pre-charge for a specific lineset length often needs adjustment once connected to longer runs. If the tech does not check subcooling and superheat when the system starts, your new unit runs hot in cooling mode and eats more power every month.
- Corroded coils from coastal air and attic heat. Miramar sits close enough to the coast that salt drift rides the east breeze, and attic temperatures in July push past 120°F. Combined, those conditions accelerate condenser corrosion and stress capacitors and blower motors far earlier than a national average failure curve would suggest.
Pricing for Heat Pump Installation in Miramar, FL
Here is what heat pump work actually costs in Miramar. A full heat pump installation runs $3,500 to $7,500 depending on capacity, efficiency rating, and whether ductwork needs modification. Repairs run $150 to $650 for most parts failures. A seasonal tune-up is $80 to $200. Those are the ranges we write on estimates, and they match what you should expect from any reputable contractor in Broward County.
| Service | Typical Miramar Price Range |
|---|---|
| Heat pump installation | $3,500 – $7,500 |
| Heat pump repair | $150 – $650 |
| Heat pump tune-up | $80 – $200 |
The largest variable on an install is whether existing ductwork can stay or needs work. In a Sunset Lakes home we once found a builder-installed 3-ton heat pump that was never matched to the return duct. The homeowner got quoted a straight swap by another company. We ran a load calculation, checked static pressure, and found the return was undersized for the tonnage. Trimming the return and balancing airflow came first. Only then did the new heat pump hold setpoint without cycling constantly. That distinction, checking the system rather than assuming it, is what separates a real installation from a box swap. Call (361) 306-9515 for a free estimate on your Miramar home.
We Also Serve Cities Near Miramar
Dalton Heating & Air serves Miramar and the surrounding South Florida communities. Our Heat Pump Installation crews cover Jacksonville, Miami, Tampa, and Orlando as well, so if you have family in another part of Florida dealing with a failed heat pump, the same written pricing and 365-Day Done Right Promise applies. One phone number reaches a live person wherever the job is.
Serving Miramar, FL - Our Local Coverage Area
We’re based in the Miramar area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs About Heat Pump Installation in Miramar
If your heat pump is under 10 years old and the repair quote is under $650, repair usually makes sense. If the compressor has failed, the unit is over 12 years old, or you are looking at repeated repairs within two years, replacement is the better call. Miramar’s long cooling season ages these systems faster than northern climates. A heat pump that has run ten summers here has run the equivalent of fifteen heating seasons up north. Call us and we’ll give you honest numbers for both options.
A load calculation uses your home’s square footage, window orientation, insulation levels, and ceiling height to determine the exact heating and cooling capacity required. In Miramar, that calc is weighted toward cooling because humidity and heat dominate most of the year. Skip the calculation and you lean on guesswork. An oversized unit short-cycles and never dehumidifies properly. An undersized one runs constantly and cannot hold temperature in August. We run the calculation on every install, no exceptions, and we show you the numbers.
SEER2 is the new efficiency standard for heat pumps in cooling mode, and it is the rating that matters most in Miramar. Going from a SEER2 14 to a SEER2 17 unit cuts cooling electricity use by roughly 18 percent on paper, though your real-world savings depend on how many hours the system runs and what you currently pay per kilowatt-hour to FPL. In a cooling-dominated market like Miramar, that efficiency difference shows up on every summer bill, not just a few months a year. We can calculate the estimated payback for your home before you commit.
Yes, and for many Miramar homes it is the cleanest option. A ductless mini split needs no ductwork, just a three-inch hole through the wall for the refrigerant lines. That makes it ideal for converted garages, enclosed patios, or rooms where the existing ducts never reached. We install single-zone and multi-zone mini split heat pumps throughout Miramar, including the communities off Miramar Parkway and University Drive. A free estimate will tell you exactly what your home needs.
Heat pump maintenance includes coil cleaning, refrigerant level verification, electrical connection inspection, condensate drain clearing, thermostat calibration, air filter replacement, and a reversing valve check. In Miramar, schedule it twice a year: once in late spring before the heavy cooling season, and once in early winter before the short heating stretch. Twice-yearly service keeps your unit running at rated efficiency and gives us a chance to catch small problems before they become $650 repairs. Call (361) 306-9515 and we’ll get you on the schedule.
Written by Marco Benitez, Owner at Dalton Heating & Air, serving Miramar since the company’s founding in 2003.