Seasonal tune-up and full diagnostic on your Carrier, Trane, or Goodman system - readings shown to you before any repair is proposed
Diagnosis first, numbers second - you approve the repair price before a single part goes in.
Before
After
Before
After
Before
AfterFast, Reliable Furnace Repair Across New Braunfels
Most furnace repairs in New Braunfels run between $150 and $700, and we complete the majority of heating repair jobs in a single visit. If your furnace is blowing cold air, short-cycling, or making noise it shouldn’t, call Dalton Heating & Air at (361) 306-9515. We answer with a live person around the clock, and we serve homes across New Braunfels, from Gruene to downtown to the neighborhoods off FM 306 and Loop 337.
New Braunfels winters are mild enough that a furnace can sit idle for weeks, then be pressed into service on a 28-degree morning. That’s exactly when failures surface. We know the equipment in these homes well because we work on it every week, not once a season.
Why Dalton Heating & Air Is New Braunfels’s Preferred Furnace Repair Company
Dalton Heating & Air is a Garrison Partners company. We’ve operated under The Garrison Standard since 2003, and that standard travels with every truck we send into New Braunfels: arrive inside the window, put the price in writing before any work starts, do the job by the book, leave the site clean, and stand behind the repair for a full year. That’s not a marketing line. It’s the operating code every one of our techs works under.
Marco Benitez leads our team, and he holds every technician to the same written guarantee on every repair. If the fix doesn’t hold, we come back at no charge. Not within 30 days. For 365 days. That’s the Furnace Repair standard we’ve built our name on, and it’s why homeowners in New Braunfels call us when a no-heat call turns into a decision about repair versus replacement.
Our technicians are background-checked and uniformed. You’ll know who’s coming before they pull up. And they’re factory-trained on Carrier, Trane, Lennox, Goodman, Rheem, York, Daikin, Bryant, and American Standard. Most New Braunfels homes we walk into have a heat pump, a dual-fuel system, or a gas furnace paired with an AC coil, and our techs see enough of each to diagnose accurately on the first visit.
Heating Repair in New Braunfels
Heating repair in New Braunfels typically runs $150 to $700, depending on the part and the system type. A failed ignitor on a gas furnace tends to land on the lower end. A blower motor replacement or a heat exchanger inspection that turns into a repair lands higher. Either way, you get a written price before we touch a screw, and the repair is guaranteed in writing for a full year.
What makes New Braunfels different is the equipment mix. Builders in this area spec dual-fuel systems and heat pumps more often than in San Antonio proper because the temperature swing is wider. A winter morning below freezing and a 75-degree afternoon mean the outdoor unit runs all year. That changes failure patterns.
Dual-Fuel Changeover Calibration
When a dual-fuel system’s balance point isn’t set correctly at the thermostat, the furnace either never kicks on when it should, or it runs when the heat pump would’ve handled the load more efficiently. We recalibrate changeover settings as part of heating repair when the symptom points that way. It’s a $150 to $300 fix that, left alone, drives utility bills up and shortens the life of both pieces of equipment.
Capacitor Failure on Heat Pumps
A weak capacitor is one of the most common no-heat calls we run in New Braunfels. The outdoor unit runs year-round here, not seasonally, so capacitors wear faster than in climates with an off-season. We keep common capacitor sizes on the truck and can usually get your system heating again the same visit.
Boiler Repair in New Braunfels
Boiler repair in New Braunfels is less common than furnace repair, but it’s a real need in older homes and some custom builds along the Guadalupe and out toward Canyon Lake. Most boiler repairs in this market run $150 to $700, and our techs carry the common pressure switches, circulator pump parts, and ignitors to handle the majority of calls in one trip.
New Braunfels has pockets of older housing stock, particularly in the downtown grid and along Seguin Avenue, where hydronic heat was installed decades ago. Those systems need a different diagnostic approach than a forced-air furnace, and they benefit from a tech who isn’t guessing.
Circulator Pump and Zone Valve Work
A boiler that heats unevenly or won’t push hot water to a zone is often the circulator pump or a stuck zone valve. We replace both regularly in New Braunfels homes with baseboard or radiator heat. Parts plus labor usually stay within the $150 to $700 range unless multiple zones are involved.
Pressure Switch and Ignitor Replacement
Modern condensing boilers use pressure switches and hot-surface ignitors that fail the same way furnace parts do. We diagnose, replace, and verify combustion before leaving. If a combustion reading doesn’t come back clean, we don’t sign off on the job.
Trusted Brands We Service in New Braunfels
We’re factory-trained on nine major residential HVAC brands, and in New Braunfels we see a lot of Rheem, York, and Daikin equipment in newer construction off FM 1044 and along Creekside. Bryant systems show up frequently in the older neighborhoods. We keep common parts for these brands stocked on our trucks, which means fewer second visits and a faster path from diagnosed to fixed. Whether your furnace is a gas unit, an air handler paired with a heat pump, or a dual-fuel setup, our techs know the controls and the failure points specific to that brand.
Common Furnace Repair Problems We See in New Braunfels Homes
- Ignored capacitor failures on heat pumps. A weak capacitor is the most frequent no-heat call we run in New Braunfels because the outdoor unit runs year-round. Symptoms look like a furnace problem – cold air at the vent – but the fix is at the condenser.
- Dual-fuel changeover set wrong at the thermostat. When the balance point isn’t calibrated for New Braunfels’s 20-degree winter mornings, the furnace either never engages or runs when the heat pump would’ve been more efficient. This shows up as short-cycling or a gas bill spike in December.
- Heat exchanger cracks from short-cycling. Undersized ductwork or a failing blower motor creates static pressure that stresses the furnace. We catch this during a routine heating repair before it becomes a carbon monoxide risk. If we find a cracked heat exchanger, we shut the gas valve and show you exactly what we found.
- Ignitors and flame sensors fouled from humid-season disuse. New Braunfels humidity can corrode a flame sensor that sat unused through a mild fall. The furnace tries to light, fails, and locks out. We clean or replace the sensor and confirm the ignition sequence cycles cleanly.
Pricing for Furnace Repair in New Braunfels, TX
Here’s what to expect, in writing, before any work begins:
| Service | Typical Cost in New Braunfels |
|---|---|
| Heating Repair | $150 – $700 |
| Boiler Repair | $150 – $700 |
What moves a job toward the top of that range is the part cost. A blower motor, a gas valve, or a fan control board costs more than a capacitor or a flame sensor. Labor in New Braunfels is consistent with the broader San Antonio metro, which means you won’t pay a premium for us to drive a truck into the city. Estimates are free, and the number we write down is the number you pay. If the repair fails within a year, we return at no charge. Call (361) 306-9515 for an exact quote.
We Also Serve Cities Near New Braunfels
If you’re outside the city limits, we cover Marion, Seguin, San Marcos, and Cibolo with the same same-visit availability and written pricing. Use this page for Furnace Repair in New Braunfels details, or call (361) 306-9515 to confirm response time to your address.
Local Conditions That Shape Furnace Repair Here
New Braunfels sits in a temperature transition zone. Winter mornings can drop into the 20s, cold enough for a furnace to run, but the same system often switches to cooling by afternoon. That’s why repair-versus-replace decisions here hinge on a dual-fuel or heat-pump setup, not just a furnace fix. Our techs see more heat-pump and dual-fuel configurations in New Braunfels than in San Antonio proper because builders spec them for the wider swing. A heat pump that’s losing efficiency on a January morning isn’t automatically a candidate for replacement. Sometimes it needs a capacitor, a refrigerant top-off, or a thermostat recalibration. We’ll tell you what you actually need, and we’ll put it in writing.
We got a no-heat call in the morningside area off Loop 337 where a homeowner’s Carrier heat pump was blowing cool air on a 28-degree morning. Our tech found a failed capacitor on the outdoor unit and a refrigerant charge low enough to trip the defrost board. We replaced the capacitor, corrected the charge, and recalibrated the thermostat. The system was heating within the hour, and the homeowner avoided a full replacement quote they’d already received from another company. That’s the difference between diagnosing the system and quoting the worst case.
Serving New Braunfels, TX - Our Local Coverage Area
We’re based in the New Braunfels area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs About Furnace Repair in New Braunfels
If your system is a heat pump, the outdoor unit is your heat source, and cold air on a 30-degree morning usually points to a capacitor failure, a refrigerant problem, or a defrost control issue, not a furnace malfunction. If it’s a dual-fuel system, the furnace should take over below the balance point. We diagnose both on every call. Call (361) 306-9515 and we’ll send a tech who works on heat pumps and furnaces daily.
A furnace under 15 years old with a failed part is usually a repair. A furnace over 15 years old with a cracked heat exchanger or a failed blower assembly is often a replacement conversation. In New Braunfels, the math also depends on whether you’re running a dual-fuel setup: replacing the furnace half while the heat pump is still efficient can be the right long-term call. We’ll show you the repair quote and the replacement quote side by side and let you decide.
Most furnace repairs in New Braunfels run $150 to $700. The low end covers items like a flame sensor, capacitor, or pressure switch. The high end covers blower motors, gas valves, and control boards. The price is in writing before we start, and it’s guaranteed for a full year.
Short-cycling in winter but not summer often means the dual-fuel changeover point is set wrong at the thermostat, so the furnace is staging on and off when the heat pump should be running, or vice versa. It can also be a limit switch tripping due to static pressure from undersized ductwork. We troubleshoot both causes on a single service visit.
Yes. Dual-fuel and heat pump systems are the majority of what we service in New Braunfels, and our techs are factory-trained on Carrier, Trane, Lennox, Goodman, Rheem, York, Daikin, Bryant, and American Standard equipment. We calibrate changeover settings, verify defrost cycles, and check heat exchanger condition on every furnace repair call.
Get Your Furnace Repair Scheduled Now
If your furnace isn’t heating, call Dalton Heating & Air at (361) 306-9515. A live person answers 24/7, and we’ll give you a straight answer about response time to your New Braunfels neighborhood. Every repair comes with a written price, a written one-year guarantee, and a free return visit if the work doesn’t hold. Marco Benitez and the whole team stand behind that promise.
Written by Marco Benitez, Owner at Dalton Heating & Air, providing furnace repair to New Braunfels homeowners.