Seasonal tune-up and full diagnostic on your Carrier, Trane, or Goodman system - readings shown to you before any repair is proposed
Diagnosis first, numbers second - you approve the repair price before a single part goes in.
Before
After
Before
After
Before
AfterFast, Reliable Furnace Repair Across Hudson
Furnace repair in Hudson, MA typically costs between $150 and $700, depending on the part that failed and how long the system has been limping along. Most no-heat calls in Hudson get a same-day response from our dispatch team, and every repair gets a written price before any work begins. Call (361) 306-9515 and a real person answers, 24 hours a day. No voicemail queue.
Hudson’s housing stock runs the full range, from 1950s Capes on Washington Street to newer subdivisions off Brigham Street. That mix means two furnaces on the same street can fail for completely different reasons. One might need a $180 ignitor swap. The one next door might need a full replacement because its ductwork was undersized from the start. We’ll tell you which one you’re dealing with, in plain terms, before you spend a dollar.
We run service calls across Hudson daily, from the downtown blocks near Main Street to the neighborhoods along Cox Street and over toward the Assabet River. When a furnace quits in January, you don’t need a callback window. You need a tech at your door inside the stated time, with a multimeter in hand and the price in writing. That’s how every Dalton Heating & Air call works.
Scheduling and dispatch for our Hudson calls are coordinated from our Boston office. The tech who shows up is a background-checked, uniformed professional who knows Hudson’s older Capes and ranches as well as its newer construction.
Key Takeaways
- Most furnace repairs in Hudson run $150 – $700, with a written quote before any work starts.
- Every repair carries a 365-day written guarantee. If it fails, we return at no charge.
- We service Carrier, Trane, Lennox, Goodman, Rheem, York, Daikin, Bryant, and American Standard.
- Same-day response for no-heat calls in Hudson when you reach us during normal business hours.
Why Dalton Heating & Air Is Hudson’s Preferred Furnace Repair Company
We don’t ask Hudson homeowners to take our word for anything. We’ve been held to The Garrison Standard since 2003, and that standard is the same on every job in Hudson: arrive inside the window, put the price in writing before work starts, fix it by the book, leave the site clean, and stand behind the repair for a full year. That’s not a marketing line. It’s the operating code every Dalton tech carries.
Marco Benitez leads our operation, and he’s built the Hudson book of business one repair at a time. Homeowners here don’t want a sales pitch. They want to know what broke, what it costs, and whether the fix will hold. Our techs are trained to explain exactly that, in trade terms and then in plain words, so you’re never nodding along to something you don’t understand.
Response time matters most when the temperature drops into the teens and the house won’t warm past 58 degrees. Hudson calls come in steadily from November through March, and we staff for it. Our live answer line means a person picks up at 3 a.m. when your furnace starts making a noise it shouldn’t. Not an answering service that promises a callback. A person.
Hudson homeowners tell us the same thing after a repair: the price didn’t change at the door, and the tech didn’t try to upsell a replacement that wasn’t needed. That’s because our technicians aren’t paid on what they sell. They’re paid to diagnose and fix. If a $200 part swap is the honest fix, that’s the quote you get.
Furnace Repair is our core trade, and in Hudson we handle everything from gas valve failures to full system diagnostics. If you’ve dealt with no-shows and shifting quotes before, you’ll notice the difference on the first call.
Heat Pump Repair in Hudson
Heat pump repair in Hudson matters more than most towns because of how many 1970s and 1980s ranches here depend on one outdoor unit for both heating and cooling. The first sentence you need to hear: most heat pump repairs in Hudson fall between $150 and $650, and a good diagnosis tells you whether the problem is in the outdoor condenser, the air handler, or the thermostat calibration that’s been drifting for years.
A Hudson heat pump that isn’t keeping up in winter is often fighting two things at once: a low refrigerant charge from a slow leak, and a thermostat that’s reading wrong. Our techs check static pressure and superheat on every heat pump call, because skipping those tests leads to recharging a system that’s still going to fail in six weeks.
Heat Pump Diagnostics That Don’t Skip Steps
We start with the basics: capacitor health, contactor wear, and whether the reversing valve is actually shifting when you switch from heat to cool. Then we measure the refrigerant pressures against manufacturer spec for your specific unit. Rheem and York heat pumps behave differently, and a tech who treats them all the same is guessing. We don’t guess.
When a Hudson Heat Pump Needs More Than a Recharge
If your outdoor unit is iced over in February or the system runs constantly without hitting set point, a recharge alone won’t cut it. You may have a failing defrost control board or a compressor that’s on its way out. In those cases we lay out the repair cost against the unit’s age and give you an honest number for both paths.
Heating Repair in Hudson
Heating repair in Hudson covers everything from gas furnaces to hydronic baseboards to heat pump air handlers. The range on most heating repairs here is $150 to $700, and the deciding factor is usually what component failed and whether it took anything else down with it. A failed ignitor is a simple swap. A cracked heat exchanger is a different conversation entirely.
In Hudson’s older Capes, the heating system has often been patched together across 40 years and three different contractors. Original ductwork may be undersized. The return might be pulling from one central hallway instead of each room. Fixing the symptom without checking the system pressure is how you get repeat no-heat calls every February.
Gas Furnace Repair in Hudson’s Older Homes
Gas furnaces in 1950s and 1960s Capes here run hard. Limit switches trip, blower motors pull high amps, and heat exchangers take the brunt when airflow is bad. We test static pressure on every call, not just the part you think is broken. That’s the difference between fixing a furnace once and fixing it every winter.
When the Furnace Is Fine but the House Won’t Warm
Sometimes the furnace runs and runs, but the living room stays cold. In Hudson homes with original windows and minimal insulation, that’s often an airflow or duct leakage problem. It can also be a thermostat calibration drift, which is a cheaper fix than a blower motor. We check the calibration and the duct runs before recommending anything expensive.
Trusted Brands We Service in Hudson
Our Hudson techs are factory-trained on the major residential brands, including Rheem, Bryant, and Daikin. We stock common parts like ignitors, flame sensors, capacitors, and pressure switches on our trucks, so if you’ve got a Rheem furnace with a dead ignitor or a Bryant heat pump with a failed start capacitor, there’s a good chance we fix it on the first visit. Less waiting on parts means your house gets warm again faster, which is the whole point. If your system uses a less common part, we have local supply houses in the MetroWest area we pull from daily, so the delay is measured in hours, not days.
Common Furnace Repair Problems We See in Hudson Homes
- High static pressure from undersized ductwork. In Hudson’s older Capes and ranches, the original ducts were often sized for smaller systems than what’s installed now. The furnace pushes against the restriction, the blower motor burns out early, and the heat exchanger cracks from overheating. We measure the pressure to confirm it before selling you anything.
- Weak capacitors that fail during heating season. A capacitor that’s losing its rating can prevent the induced draft blower from starting, which makes the furnace act like the control board failed. We test capacitor health on every no-heat call, and if it’s weak, we show you the reading.
- Short-cycling in newer subdivisions. Oversized furnaces in Hudson’s newer developments heat the house fast, shut off, then fire again minutes later. That’s short-cycling, and it beats up heat exchangers. Some homeowners think the furnace is broken when the real problem is sizing. We explain the difference and tell you what an honest fix looks like.
- Thermostat calibration drift masking real issues. In homes with poor insulation, a thermostat that’s drifting out of calibration makes the furnace run longer than it should. That longer runtime can hide a failing limit switch or even a heat pump refrigerant issue. We calibrate the thermostat early in the call so we’re not chasing ghosts.
Pricing for Furnace Repair in Hudson, MA
Here’s what Hudson homeowners should expect to pay, and it’s the same price sheet whether you live off Apsley Street or over near the Marlborough line.
| Service | Typical Price Range |
|---|---|
| Furnace Repair | $150 – $700 |
| AC Repair | $150 – $650 |
| AC Installation | $3,500 – $7,500 |
| Tune-Up | $80 – $200 |
The spread within each range comes down to parts. An ignitor or flame sensor is a low-cost part with quick labor. A gas valve or blower motor lands higher. A heat exchanger replacement is near the top, and honestly, at that price we’ll show you the numbers for replacement too, because sometimes replacing is the better financial move. The quote you get is in writing before work starts, and it does not change at the door. Call (361) 306-9515 for an exact quote on your furnace. Estimates are free.
Because Hudson’s housing stock mixes older Capes with newer construction, a furnace that’s right-sized for one house can be grossly oversized for another on the same street. That means two identical repair calls can end one in a $200 part swap and the other in a full replacement recommendation, depending on actual static pressure and ductwork. This makes honest load calculation and static pressure testing the dividing line between a quick fix and an unnecessary replacement pitch here. We measure. We don’t guess.
We got a no-heat call from a homeowner off Washington Street whose Carrier furnace was short-cycling and tripping the high-limit switch. Our tech found a failing blower motor pulling high amps and a heat exchanger with visible cracks after a static pressure test showed the ductwork was undersized for the unit’s tonnage. We replaced the blower motor and walked the homeowner through why the cracked heat exchanger meant replacement was the safer call, not just a repair. That’s the kind of honest conversation Hudson homeowners get from us every time.
We Also Serve Cities Near Hudson
Dalton Heating & Air runs furnace repair calls across MetroWest, so if you’re searching Furnace Repair in Hudson, you’re in our service area. We also cover Marlborough, Maynard, Clinton, and Northborough. If you’re in one of those towns and your furnace is down, the same written pricing and 365-day guarantee applies.
Serving Hudson, MA - Our Local Coverage Area
We’re based in the Hudson area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs About Furnace Repair in Hudson
The honest answer depends on the heat exchanger, the system’s age, and the repair cost as a percentage of replacement. If your Hudson furnace is under 12 years old and the failed part is a capacitor, ignitor, or pressure switch, repair is almost always the right call at $150 to $450. If the heat exchanger is cracked, the furnace is over 18 years old, or you’ve had three or more repair calls in the last two winters, replacement usually makes more sense. We’ll show you real numbers for both paths and let you decide. Call (361) 306-9515 for a straight answer on your specific furnace.
A Manual J load calculation tells you how many BTUs your Hudson home actually needs, and that number often surprises people. In older Capes with original insulation, the load is higher than the square footage suggests. In newer subdivisions, homeowners frequently discover the original furnace was oversized by 20 to 30 percent. That oversizing causes short-cycling, which is hard on heat exchangers. A proper load calculation tells us whether your repair is fixing the real problem or just the symptom of a system that was sized wrong from day one. We run the calc before recommending any major repair or replacement.
The high-limit switch trips when the furnace gets too hot, and in Hudson homes the usual cause is restricted airflow. That could be a clogged filter you forgot to change, closed supply registers in unused rooms, or, in the older Capes off Main Street and Washington Street, undersized ductwork that’s been there since the house was built. A failing blower motor that isn’t moving enough air will do it too. If the switch trips once, change the filter and open the vents. If it keeps tripping, there’s a real airflow or motor problem that needs a tech. Call (361) 306-9515 and we’ll check the static pressure, not just the switch.
In Hudson, a typical repair runs $150 to $700. A full furnace replacement with new ductwork in an older Cape can run $5,000 to $9,000 depending on the system and what the load calculation shows. If your furnace is under 10 years old, a single repair under $500 is usually the smart money. If the heat exchanger is cracked and the unit is 15-plus years old, you’re looking at $1,500 to $2,500 for that part alone, which stops making sense. We give you both numbers in writing so you’re deciding with real math, not a sales pitch. Call (361) 306-9515 for an honest quote.
We service both. Heat pump repair and mini split repair are a big part of our Hudson work, especially on the older ranches that got heat pumps installed in the 1980s and on newer multi-zone mini splits in finished basements and additions. The price range is the same as furnace work: $150 to $650 for most heat pump repairs. The diagnostic approach changes, but the written pricing and the 365-day guarantee don’t. Call (361) 306-9515 if your heat pump or mini split is acting up.
Call Dalton Heating & Air for Furnace Repair in Hudson
When your furnace stops heating a Hudson home in January, you need a straight answer and a fast fix. You get both from Dalton Heating & Air. A live person answers the phone 24/7. A background-checked tech arrives inside the stated window. The price goes in writing before any work starts. The repair carries a 365-day written guarantee, and if it fails within that year, we return at no charge. That’s The Garrison Standard, and it’s been how we work since 2003. Call (361) 306-9515 for a free estimate.
Written by Marco Benitez, Owner at Dalton Heating & Air, serving Hudson, MA.