Seasonal tune-up and full diagnostic on your Carrier, Trane, or Goodman system - readings shown to you before any repair is proposed
Diagnosis first, numbers second - you approve the repair price before a single part goes in.
Before
After
Before
After
Before
AfterFast, Reliable Furnace Repair Across Crowley
Furnace repair in Crowley typically runs $150 – $700 depending on the failed part, and most calls we take in this area are actually heat-pump issues rather than gas furnace failures. That distinction matters, because the fix is different, the diagnosis is different, and the price is different. We’re Dalton Heating & Air, and our Furnace Repair team gets to Crowley homes the same day you call. When your heat is down and the temperature outside is dropping toward the 20s, you want a tech who knows what they’re looking at. Call (361) 306-9515 and you’ll talk to a live person, not a voicemail tree.
Why Dalton Heating & Air Is Crowley’s Preferred Furnace Repair Company
We’ve spent years working on homes across Crowley, from the established streets around Crepe Myrtle Park to the newer subdivisions off FM 1187. That local time pays off in a simple way: we know what fails here and why. A no-heat call in Crowley in January is often a heat pump reversing valve or defrost board, not a cracked heat exchanger. A tech who doesn’t work this area might spend an hour chasing the wrong part. Our techs don’t.
Every job gets a written price before we touch a single component, and every repair carries a one-year written guarantee. If it fails inside that window, we return at no charge. That’s not a promo. It’s part of The Garrison Standard our company has operated under since 2003, and Marco Benitez holds every Crowley call to that code: arrive inside the stated window, price it in writing, fix it right, leave the site clean, stand behind it for a full year.
Our techs are background-checked, uniformed, and factory-trained on nine major residential brands. When you book, you know who’s coming. When the job’s done, you know exactly what you paid for and how long it’s covered.
Furnace Tune Up in Crowley
A Furnace Tune Up in Crowley is a systematic once-a-season check that costs $80 – $200 and takes about an hour on most systems. In this part of the DFW heat-pump belt, a tune-up isn’t just cleaning and checking your gas manifold. It’s testing the heat pump’s reversing valve operation, verifying defrost cycle timing, measuring strip heat amp draw, and confirming the blower motor moves the right CFM. If you wait until the first hard freeze to find out your aux heat is weak, you’ll be cold for a night while we come fix it. Better to find it in October.
Heat Pump and Strip Heat Verification
This is the part of a Crowley tune-up most companies skip. We run the unit through heat mode, switch it to cooling, verify it switches back, and check the amp draw on your electric strip heat. Undersized strips or a lazy sequencer show up here clearly.
Airflow and Static Pressure Check
Your blower motor and ductwork either move the air the system was designed for, or they don’t. We measure external static pressure on both modes and check the blower capacitor. A weak capacitor often fails on the first cold morning, not on a mild afternoon.
Emergency Furnace Repair in Crowley
Emergency Furnace Repair in Crowley is what happens when your heat is out at 6 AM and the forecast says 22 degrees before lunch. We answer the phone with a live person around the clock, and we dispatch same-day. Most emergency calls we run here fall into three buckets: a heat pump stuck in cooling, a defrost control board that won’t engage, or an electric strip heat package that can’t keep up. Expect emergency pricing to fall within the same $150 – $700 range as standard repair, with the written quote in your hand before any work starts.
Reversing Valve and Defrost Board Diagnosis
A stuck reversing valve means your heat pump is trying to cool your house in January. The repair is usually a valve replacement, which runs on the upper end of the repair range. A bad defrost board is less expensive and often fixes intermittent no-heat calls in seconds.
Strip Heat and Blower Motor Failures
On the coldest nights, a failed strip heat element or a dead blower motor is the difference between a warm house and a long night. We stock common strip heat kits and blower motors for older Goodman and Rheem systems, and we can usually get a replacement same-day in Crowley.
Trusted Brands We Service in Crowley
We service all nine major residential HVAC brands, but in Crowley we see a heavy mix of Trane, Lennox, Goodman, and Rheem equipment. That’s the house stock of the DFW heat-pump belt, and we keep common compatibles for those brands on our trucks: reversing valves, defrost boards, capacitors, limit switches, and strip heat sequencers. If you have a Rheem heat pump that trips a defrost cycle too often, or a Goodman unit with a weak blower capacitor, we can usually fix it the first visit. You won’t wait three days for a part to ship while your house goes cold.
Common Furnace Repair Problems We See in Crowley Homes
Here’s what we actually find when we pull up to a Crowley home and the heat is out:
- Stuck reversing valve. Your heat pump runs in cooling mode when it should heat. In Crowley’s January weather, this shows up as lukewarm air or a frozen outdoor coil. The fix is valve replacement, and it’s the single most common no-heat repair we make in this area.
- Failed defrost board. When winter nights drop into the 20s and your outdoor coil ices up, the defrost board has to cycle heat to melt it. A dead board means ice builds until the system locks out. This is a quick same-day fix if the part is on the truck.
- Undersized or failed electric strip heat. Older Crowley homes, especially those built in the 1980s and 1990s along the 76036 corridor, often had strip heat sized without a proper load calculation. When the mercury drops below 20 degrees, those strips run nonstop and either trip a breaker or simply can’t hold temperature. We test amp draw and check the sequencer before calling the strips bad.
- Weak blower motor capacitor. The same five-minute capacitor test that catches summer AC failures finds them on winter heat-pump calls. A weak cap makes the blower motor run slow or not start at all on a cold morning. We check it on every visit.
Pricing for Furnace Repair in Crowley, TX
Most furnace repair calls in Crowley fall between $150 and $700. On the low end, you’re looking at a diagnostic call and a small repair: a capacitor, a flame sensor cleaning, a limit switch. On the upper end, you’re replacing a reversing valve or a blower motor. The written price you get covers parts and labor, and it’s the price you pay, full stop. Here’s the breakdown:
| Service | Price Range |
|---|---|
| Furnace Repair (diagnostic + common repair) | $150 – $700 |
| Furnace / Heat Pump Tune-Up | $80 – $200 |
Estimates are free. Call (361) 306-9515 and we’ll give you a firm written price before any work begins.
We were called to a home near Crowley Cemetery for a no-heat complaint at 6 AM. The homeowner had a 3-ton Rheem heat pump, and our tech found a stuck reversing valve plus a weak capacitor on the outdoor unit that was tripping the defrost cycle. We replaced the valve and capacitor, verified refrigerant charge and static pressure, and had the system heating again before the morning freeze lifted. We also ran a load calculation because the 20-year-old strip heat was undersized for the 15°F night, and the numbers showed the aux heat was never going to keep up. We gave the homeowner both repair and replace options with SEER2 efficiency comparisons on the replacement side.
That call is the Crowley story in miniature. The home sits in the DFW heat-pump belt, where winter design temperatures hover near 25°F but summer peaks exceed 100°F. That’s why so many homes here have a heat pump with electric strip backup rather than a gas furnace. A no-heat call is often a failed reversing valve, defrost board, or undersized aux heat, not a cracked gas heat exchanger. If you call a company that only knows gas furnaces, you’ll get a wrong answer and a wasted visit. If you call us, you get a tech who’s seen this exact failure a hundred times.
We Also Serve Cities Near Crowley
Our crews serve Crowley and the surrounding communities, including Burleson, Joshua, Kennedale, and Arlington. If you’re in one of those areas and your heat is down, the same pricing, the same written guarantee, and the same same-day response applies.
Serving Crowley, TX - Our Local Coverage Area
We’re based in the Crowley area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs About Furnace Repair in Crowley
Yes and no. A heat pump heats your home in winter, but the failure points are different from a gas furnace, and in Crowley, most no-heat calls are heat-pump issues: reversing valves, defrost boards, low refrigerant, or failed strip heat. Our techs have to diagnose which heat source is failing before quoting any repair, which is why we don’t give blind quotes over the phone. Call (361) 306-9515 and we’ll start with a diagnosis.
Start with the repair quote, then run the numbers on a replacement. If your system is over 15 years old, uses R-22 refrigerant, or failed a load calculation for the home, replacement often pays for itself. In Crowley’s climate, where a system runs heat in winter and AC in summer, a newer heat pump with a higher SEER2 rating typically cuts a meaningful slice off the monthly bill. We’ll show you both options with the hard numbers and let you decide.
A proper tune-up here checks both modes of a heat pump, not just heating: reversing valve operation, defrost cycle timing, strip heat amp draw, blower motor capacitor, refrigerant charge in cooling mode, and static pressure in both modes. The goal is to catch a weak component before the first hard freeze. Most tune-ups in Crowley run $80 – $200 and take about an hour.
SEER2 is the updated efficiency rating that reflects real-world external static pressure. A higher SEER2 means less electricity used for the same cooling. In a DFW summer with 90-plus days above 90°F, the difference between a 14 SEER2 and a 17 SEER2 system can be $200 to $400 a year on your cooling bill alone. We’ll show you the numbers for your actual home load, not a generic chart.
We do. Our techs are factory-trained on all nine major residential brands, but in Crowley we most often work on Trane, Lennox, Goodman, and Rheem systems. We carry common parts for those brands on our trucks and can usually complete the repair the same day we diagnose it.
Get Your Furnace Fixed Today in Crowley
If your heat is out or your system is limping, call Dalton Heating & Air at (361) 306-9515. You’ll get a live person, a same-day appointment, a written price before any work begins, and a one-year written guarantee on the repair. Marco Benitez and the whole team stand behind that. If it fails inside the year, we come back at no charge. That’s The Garrison Standard, and it’s been that way since 2003.
Written by Marco Benitez, Owner at Dalton Heating & Air, serving Crowley and the surrounding DFW communities.